Question is ⇒ An instruction used to set cany flag in a computer is classified as, Options are ⇒ (A) data transfer, (B) arithmetic, (C) logical, (D) program control, (E) , Leave your comments or Download question paper.

Question is ⇒ An instruction used to set cany flag in a computer is classified as, Options are ⇒ (A) data transfer, (B) arithmetic, (C) logical, (D) program control, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An instruction used to set cany flag in a computer is classified as
A.	data transfer [Wrong Answer]
B.	arithmetic [Correct Answer]
C.	logical [Wrong Answer]
D.	program control [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Short circuited stubs are preferred to O.C stubs because
O.C stubs are incapable of giving full range of reactances
O.C stubs are liable to radiate
O.C stubs are difficult to make and connect
none of the above

⇒ When a diode is not conducting, its bias is
forward
zero
reverse
zero or reverse

⇒ An intrinsic silicon sample has 1 million free electrons at room temperature. As the temperature is increased
the number of free electrons increases
the number of free electrons increases but the number of holes decreases
the number of free electrons and holes increase by the same amount
the number of free electrons and holes increase but not by the same amount

⇒ Which of the transistor models is most preferred for the analysis of a transistor circuit both at mid-band and at high frequencies?
h-parameter model
y-parameter model
s-parameter model
hybrid-p model

⇒ The tree selected for the formation of state equations contains
all voltage sources
all capacitors
all inductors and current sources
all voltage sources and maximum number of capacitors

⇒ Consider the network: Impedance of this network as a function of the complex frequency is consists of a certain number of zeros and poles. What is the location of po
-2
-2, ∞
2
2, ∞

⇒ If a capacitor is charged by a square wave current source the voltage across the capacitor is
triangular wave
step function
zero
square wave

⇒ A resistance strain gauge has a resistance of about
100 Ω
25 Ω
10 Ω
1 Ω

⇒ Radiation resistance of an antenna is 54 Ω and loss resistance is 6 Ω. If antenna has power gain of 10, then directivity is:
9
11.11
data not sufficient
10

⇒ A collector collects
electrons from the base in case of N-P-N transistor
electrons from the emitter in case P-N-P transistor
holes from the base in case of N-P-N transistor
holes from the base in case of P-N-P transistor

⇒ In a half wave voltage doubler circuit the input frequency is 50 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
150 Hz

⇒ Which of following is linear and bilateral parameter?
Resistors
Semi conductor diodes
Electron tubes
Transistor

⇒ A conditionally stable system is stable for the value of gain between two critical values. It is unstable if
the gain is increased beyond upper critical value
the gain is decreased below lower critical value
both (a) and (b)
none of the above

⇒ In a thermocouple two metal junctions between metals M₁ and M₂ are kept at temperature T₁ and T₂. The thermocouple emf is produced because
M₁, M₂ are similar and T₁, T₂ are equal
M₁, M₂ are similar but T₁, T₂ are unequal
M₁, M₂ are dissimilar but T₁, T₂ are equal
M₁, M₂ are dissimilar but T₁, T₂ are unequal

⇒ Which binary addition is incorrect?
1101.1 + 1011.1 = 11001.0
101101 + 1101101 + 1100011
0.0011 + 0.1110 + 1.0001
1100.001 + 1011.011 = 10111.100

⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the radiated power
730 W
73 W
100 W
None

⇒ Integrated fin line can be utilized as a medium for constructing millimeter wave circuits.
TRUE
FALSE

⇒ A black box has one of the elements our of R, L, C. when a 220 V a supply is connected the current supplied by source is I. when a 0.1 F capacitor is connected in parallel with the box, the current is 2I. The element is
resistance
inductance
0.1 F capacitance
not identifiable on the basis of given data

⇒ Which of the following DO statements is invalid in FORTRAN 77?
DO 161 = 1, 15
DO 16 1 = 1, 10, 1
DO 16 I = - 5, 5, 2
none of the above

⇒ Transfer function of a linear system is 200 e^-j10ω The system is a
distortionless Attenuator
amplifier with Phase distortion
distortionless Amplifier
attenuator with Phase distortion

⇒ A network N is dual of network N if
both of them have same mesh equation
both of them have same node equation
mesh equation of one are the node equations of the other
KCL and KVL equations are the same

⇒ The dissipation at the collector is in the quiescent state and increases with excitation in the case of a
class A series fed Amplifier
class A transistor coupled Amplifier
class AB amplifier
class B amplifier

⇒ At corner frequency the phase angle of factor 1/(1 + jωT) is
+90°
-90°
+45°
-45°

⇒

Match the following:

	List I (Functional components)		List II (Device)
A.	Error detector	1.	Three phase FHP Induction motor
B.	Servo motor	2.	Synchro transmitter and control transformer
C.	Amplifier	3.	Tacho generator
D.	Feed back	4.	Armature controlled FHP dc motor
		5.	Amplidyne

A-2, B-4, C-1, D-5
A-4, B-2, C-5, D-3
A-2, B-4, C-5, D-3
A-1, B-2, C-3, D-5

⇒ Which of the following statements is incorrect?
A mesh with two resistors has two mesh currents
The algebraic sum of all voltages around any mesh or any loop must be zero
The principle node is a function where branch current can divide or combine
A Norton is a series circuit

⇒ In a specimen of n type semiconductor, the initial concentration of holes and electrons is p_no and n_no. When the specimen is subjected to radiation, the hole and electron concentration increase to p_n and n_n. Then
p_n - p_no = n_n - n_no
p_n + p_no = n_n + n_no
p_n - p_no = n_no + n_no
p_n + p_no = n_n - p_no

⇒ The number of bits in a nibble is
8
4
2
16

⇒ Consider the following applications

TV tuning
Active filter
Microwave frequency multiplication

In which of above can a varactor diode be used?
1 2 and 3
l and 2 only
1 and 3 only
2 and 3 only

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller

⇒ Noise with uniform power spectral density of N₀ω/H_z is passed through a filter H(ω) = 2 exp (-J ω t_y) followed by an ideal low pass filter of bandwidth B Hz. The output noise power in watts is
2 N₀B
4 N₀B
8 N₀B
16 N₀B