Question is ⇒ An induction motor has relatively high power factor at, Options are ⇒ (A) rated r.p.m., (B) no load, (C) 20 percent load, (D) near full load, (E) none of the above, Leave your comments or Download question paper.

Question is ⇒ An induction motor has relatively high power factor at, Options are ⇒ (A) rated r.p.m., (B) no load, (C) 20 percent load, (D) near full load, (E) none of the above, Leave your comments or Download question paper. Previous question Next question


Q1.	An induction motor has relatively high power factor at
A.	rated r.p.m. [Wrong Answer]
B.	no load [Wrong Answer]
C.	20 percent load [Wrong Answer]
D.	near full load [Correct Answer]
E.	none of the above [Wrong Answer]
View Answer 6 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The knowledge of diversity factor helps in determining
plant capacity
average load
peak load
kWh generated

⇒ During load shedding
system power factor is changed
some loads are switched off
system voltage is reduced
system frequency is reduced

⇒ The increased load during summer months is due to
increased business activity
increased water supply
increased use of fans and air conditioners
none of the above

⇒ For which of the following power plants highly skilled engineers are required for running the plants ?
Nuclear power plants
Gas turbine power plants
Solar power plants
Hydro-electric power plants

⇒ The primary reason for low power factor is supply system is due to installation of
induction motors
synchronous motors
single phase motors
d.c. motors

⇒ Annual instalment towards depreciation reduces as rate of interest increases with
sinking fund depreciation
straight line depreciation
reducing balances depreciation
none of the above

⇒ Which of the following should be used for extinguishing electrical fires ?
Water
Carbon tetrachloride fire extinguisher
Foam type fire extinguisher
CO₂ fire extinguisher

⇒ A low utilization factor for a plant indicates that
plant is used for stand by purpose only
plant is under maintenance
plant is used for base load only
plant is used for peak load as well as base load

⇒ Different generating stations use following prime movers
diesel engine
hydraulic turbine
gas turbine
steam turbine

⇒ Efficiency is the secondary consideration in which of the following plants ?
Base load plants
Peak load plants
Both (a) and (b)
none of the above

⇒ A 130 MW generator is usually ____ cooled
air
oxygen
nitrogen
hydrogen

⇒ Following power plant has instant starting
nuclear power plant
hydro power plant
diesel power plant
both (b) and (c)

⇒ In a power plant if the maximum deniand on the plant is equal to the plant capacity, then
plant reserve capacity will be zero
diversity factor will be unity
load factor will be unity
load factor will be nearly 60%

⇒ Annual depreciation as per straight line method, is calculated by
the capital cost divided by number of year of life
the capital cost minus the salvage value, is divided by the number of years of life
increasing a uniform sum ofmoney per annum at stipulated rate of interest
none of the above

⇒ Direct conversion of heat into electric power is possible through
fuel cell
batteries
thermionic converter
all of the above

⇒ A consumer has to pay lesser fixed charges in
flat rate tariff
two part tariff
maximum demand tariff
any of the above

⇒ ____ power plant is expected to have the longest life.
Steam
Diesel
Hydroelectric
Any of the above

⇒ ____ is invariably used as base load plant.
Diesel engine plant
Nuclear power plant
Gas turbine plant
Pumped storage plant

⇒ Maximum demand tariff is generally not applied to domestic consumers because
they consume less power
their load factor is low
their maximum demand is low
none of the above

⇒ The least share of power is provided in India, by which of the following power plants ?
Diesel power plants
Thermal power plants
Hydro-electric power plants
Nuclear power plants

⇒ Approximate estimation of power demand can be made by
load survey method
statistical methods
mathematical method
economic parameters

⇒ A nuclear power plant is invariably used as a
peak load plant
base load plant
stand-by plant
spinning reserve plant

⇒ Which of the following is not a source of power ?
Thermocouple
Photovoltaic cell
Solar cell
Photoelectric cell

⇒ An induction motor has relatively high power factor at
rated r.p.m.
no load
20 percent load
near full load

⇒ Anything having some heat value can be used as fuel in case of
open cycle gas turbines
closed cycle gas turbines
petrol engines
diesel engines

⇒ In an interconnected system, the diversity factor of the whole system
remains unchanged
decreases
increases
none of the above

⇒ A synchronous condenser is virtually which of the following ?
Induction motor
Under excited synchronous motor
Over excited synchronous motor
D.C. generator

⇒ Annual operating expenditure of a power plant consists of
fixed charges
semi-fixed charges
running charges
all of the above

⇒ In case of ____ fuel transportation is the major problem.
diesel pwer plants
nuclear power plants
hydro-electric power plants
thermal power plants

⇒ Generating capacity connected to the bus bars and ready to take load when switched on is known as ____
firm power
cold reserve
hot reserve
spinning reserve