Question is ⇒ An m derived low pass filter has fc = 1000 Hz and m = 0.6. This filter will have infinite attenuation at, Options are ⇒ (A) f = 1250 Hz, (B) all frequencies above 1000 Hz, (C) f = 1562.5 Hz, (D) f = 1666.67 Hz, (E) , Leave your comments or Download question paper.

Question is ⇒ An m derived low pass filter has fc = 1000 Hz and m = 0.6. This filter will have infinite attenuation at, Options are ⇒ (A) f = 1250 Hz, (B) all frequencies above 1000 Hz, (C) f = 1562.5 Hz, (D) f = 1666.67 Hz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An m derived low pass filter has f_c = 1000 Hz and m = 0.6. This filter will have infinite attenuation at
A.	f = 1250 Hz [Correct Answer]
B.	all frequencies above 1000 Hz [Wrong Answer]
C.	f = 1562.5 Hz [Wrong Answer]
D.	f = 1666.67 Hz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If E_b, the energy per bit of a binary digital signal is 10^-6 watt sec. and the one sided power spectral density of the white noise N₀ = 10^-5 W/Hz, then the output SNR of the matched filter is
26 dB
10 dB
20 dB
13 dB

⇒ If a zero is added to a second order underdamped system
the peak overshoot is increased
the peak overshoot is decreased
the peak overshoot remains unchanged
either (a) or (b)

⇒ A geostationary satellite
is located at a height of 358, 00 km
appears stationary over earth's magnetic pole
is motionless in space but keeps spinning
orbits the earth within a 24 hour period

⇒ Which of the following are included in the architecture of a computer?

Addressing modes, CPU
Instruction set, data formats
Secondary memory, operating system

Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
3 only

⇒ A microprocessor is generally
single chip SSI
single chip MSI
single chip LSI
any of the above

⇒ Current through a charging capacitor exhibits
an exponential growth function
an exponential decay function
a step decay function
a linear decay function

⇒ Which of the following addressing modes is used in the instruction PUSH B?
Direct
Register
Register Indirect
Immediate

⇒ The basic shift register operations are
serial in - serial out
serial in - parallel out
parallel in - serial out
all of the above

⇒ An induction wattmeter can be used for
dc only
50 Hz ac only
both ac and dc
high frequency ac only

⇒ An ac circuit has two branches in parallel. The impedances of the two branches are equal. The p.f. of one branch is 0.8 lagging and 0.8 leading. The overall p.f. is
zero
0.5 lagging
1
0.7 lagging

⇒ Low frequency boost can be easily compensated by
attenuating the frequencies from 0 to 1.25 MHz
using an appropriate de-emphasis circuit in the receiver
using an appropriate pre-emphasis circuit in the transmitter
none

⇒ The relational operators allowed in Pascal are
=, >, <, > =, < = and < >
=, >, < and < >
=, >, <, > = and < =
>, <, > = and < =

⇒ In a TV studio the illuminance is about
200 lux
1000 lux
10000 lux
10 lux

⇒ Reflection from the object to be measured is significant only when the wavelength is
much bigger than the size of object
much smaller than the size of object
almost of the size of object
either (a) or (c)

⇒ A transistor has two p-n junctions. The batteries should be connected such that
both junctions are forward biased
both junctions are reverse biased
one junction is forward biased and the other is reverse biased
either (a) or (b)

⇒ In a series RLC circuit p.f is lagging when f < resonance frequency.
TRUE
FALSE

⇒ A (A + B) =
A
B
A
B

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ Which of the following is a better propagation mode to propagate television frequency modulation and radar signals?
Satellite communication
Ground propagation
Polarized communication
None of the above

⇒ If eddy current damping is to be used, the disc of instrument should be
non-conducting and non-magnetic
conducting and magnetic
conducting and non-magnetic
non-conducting and magnetic

⇒ Bandwidth for practical PCM system is (where n is no. of channels, N length of PCM codes)
2n N f_m Hz
4n f_m Hz
2n f_m
(N + 1)f_m

⇒ A series circuit has fixed resistance and variable reactance. The impedance locus will be a straight line parallel to Y-axis.
TRUE
FALSE

⇒ A Hartley oscillator uses
a tapped capacitor
a tapped inductor
a tapped inductor for inductive feedback
none of the above

⇒ A voltage doubler circuit uses
two diodes
two capacitors
two diodes and two capacitors
none of the above

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒ The problem of current lagging is associated with
DCTL gates
DTL gates
ECL gates
CMOS gates

⇒ Consider the following tasks in a micro computer

Receiving data and instruction
Performing arithmetic computation
Performing logical computations
Storing data and instructions

Which of the above are performed by ALU?
2 only
2 and 3 only
1, 2 and 3 only
All

⇒ If γ = (S₀/N₀)/(S_i/N_m) where S₀ and S₁ are signal power output and signal power input and N₀ and N_m are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are
1 and 1
1 and 2
2 and 1
0.5 and 0.5

⇒ One commercial unit of energy is equal to
1 watt-sec
1 kilowatt-sec
1 kilowatt-hour
One watt-hour

⇒ A transistor will operate in inverted region when
emitter junction is forward biased and collector junction is reverse biased
emitter junction is reverse biased and collector junction is forward biased
emitter junction as well as collector junction are forward biased
emitter junction as well as collector junction are reverse biased