Question is ⇒ An ideal rectifier should have, Options are ⇒ (A) 100% efficiency, zero ripple factor, zero harmonic factor and unity displacement factor, (B) 100% efficiency, zero tipple factor, zero harmonic factor and zero displacement factor, (C) 100% efficiency, zero ripple factor, unity harmonic factor and unity displacement factor, (D) 100% efficiency, unity ripple factor, zero harmonic factor and unity displacement factor, (E) , Leave your comments or Download question paper.

Question is ⇒ An ideal rectifier should have, Options are ⇒ (A) 100% efficiency, zero ripple factor, zero harmonic factor and unity displacement factor, (B) 100% efficiency, zero tipple factor, zero harmonic factor and zero displacement factor, (C) 100% efficiency, zero ripple factor, unity harmonic factor and unity displacement factor, (D) 100% efficiency, unity ripple factor, zero harmonic factor and unity displacement factor, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An ideal rectifier should have
A.	100% efficiency, zero ripple factor, zero harmonic factor and unity displacement factor [Correct Answer]
B.	100% efficiency, zero tipple factor, zero harmonic factor and zero displacement factor [Wrong Answer]
C.	100% efficiency, zero ripple factor, unity harmonic factor and unity displacement factor [Wrong Answer]
D.	100% efficiency, unity ripple factor, zero harmonic factor and unity displacement factor [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : Anoodee 94 Said on 2021-03-06 03:43:50 Both ripple factor and harmonic factor should be unity for ideal controlled rectifier. true false !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In analog signal given below is sampled at such a rate that the samples of signal can be given to a collection of buffers having capacity of either 24 samples/sec. or 25 samples/sec. The sampling rate is minimum such that it fully utilizes the collection of both types of buffers m(t) = 2 sin 480pt + 3 sin 720 pt<
600 Hz
300 Hz
1200 Hz
2400 Hz

⇒ Both ROM and RAM can be accessed randomly.
TRUE
FALSE

⇒ Which DOS command improves memory usage?
MEM MAKER
MOVE
MEM IM
None on the above

⇒ In a JK Master slave flip flop
both master and slave are positively clocked
both master and slave are negatively clocked
master is positively clocked and slave is negatively clocked
master is negatively clocked and slave is positively clocked

⇒ An air gap provided in the iron core of an inductor prevents
flux leakage
hysteresis loss
core saturation
heat generation

⇒ Examine the following statements
Pneumatic systems are fire proof.
Pneumatic systems are explosion proof.
Hydraulic systems are explosion proof.
Hydraulic systems are fire proof.
Which of the above statements are correct?
1 only
1 and 2 only
1 2, 3, 4
2, 3, 4 only

⇒ If all bubbles are removed, what are the new RAM locati
(8000)_H - (83FF)_H
(80AA)_H - (80FF)_H
(FF00)_H - (FFFF)_H
none of the above

⇒ A rectangular pulse is passed through an L.P.F. The response is a
triangular
trapezoidal function
sampling
Both (a) and (b)

⇒ In INHIBIT operation
output is 1 when both inputs are 0
output is 0 when blocking input is 1
output is 0 when blocking input is 0
output is 1 when blocking input is either 0 or 1

⇒ In figure, the battery has remained switched on for a long time. At t = 0 the switch is closed. The current i(t) is likely t
6
6 - 3e^-1
6 + 3e^-1
3 - 6e^-1

⇒ (11)₂ + (11)₃ = (11)_?
4
5
6
none

⇒ The damping ratio of a pair of complex poles when expressed in terms of angle θ measured from jω axis equal to
sin θ
cos θ
tan θ
cot θ

⇒ Consider a baseband binary PAM receiver shown below. The additive channel noise n(t) is whit with power spectral density S_N(f) = N₀/2 = 10^-20 W/Hz. The low-pass filter is ideal with unity gain and cutoff frequency 1 MHz. Let Y_k represent the random variable y(t_k10¹⁰
10⁷
1.414 x 10^-10
2 x 10^-20

⇒ The accuracy of measurement by ohmmeter is very good.
TRUE
FALSE

⇒
Assertion (A): A p-n junction is used as rectifier.
Reason (R): A p-n junction has low resistance in forward direction and high resistance in reverse direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following statem
1 alone
2 alone
3 alone
1 and 3

⇒ Henry is equivalent to
Volts/Ampere
Weber/Volt
Weber/Ampere
Weber/Ampere²

⇒ A single phase dual converter consists of
two fully controlled converters connected in parallel
two fully controlled converters connected in antiparallel
two fully controlled semiconverters connected in antiparallel
two fully controlled semiconverters connected in parallel

⇒ Which one of the following circuits is used for converting a sine wave into a square wave?
Astable multivibration
Monostable multivibration
Bistable multivibration
Schmitt trigger

⇒ If R(t) is autocorrelation of a waveform v(t) and R(0) is autocorrelation for t = 0, then
R(0) > R(t)
R(0) ≥ R(t)
R(0) < R(t)
R(0) ≤ R(t)

⇒ An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a
sine wave
square wave
triangular wave
(a) or (c)

⇒
Assertion (A): ECL gate has very high speed of operation.
Reason (R): Transistors in ECL do not go into saturation region.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The unit of magnetic flux density is
farad/metre
ohm/metre
tesla
ampere/metre

⇒ In most of instruments, the controlling torque is provided by
fluid fraction
spring
eddy current
either (a) or (c)

⇒ A Clapp's oscillator is
a modified Hartley oscillator
a modified Colpitt's oscillator
a modified RC oscillator
none of the above

⇒ A power transistor dissipates 5 W. If ambient temperature is 30° and case to air thermal resistance is 10° C/W, the case temperature is
80°C
20°C
32°C
305°C

⇒ If the drift velocity of holes under a field gradient of 100 V/m in 5 m/s, their mobility (in SI units) is
0.05
0.5
50
500

⇒ In a CE amplifier the Q point is very close to cutoff point on the load line. This results in
saturation clipping
cut off clipping
both saturation and cut off clipping
either saturation clipping or cut off clipping

⇒ The figures shows the symbo
p channel depletion MOSFET
p channel enhancement MOSFET
complementary MOSFET
p channel JFET

⇒ Which one is digital modulation technique?
AM
PAM
PCM
None

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math