Question is ⇒ An FM transmitter has maximum frequency deviation of 75 kHz and reproduces audio signals up to 15 kHz. Minimum channel width required is __________ kHz., Options are ⇒ (A) 180, (B) 120, (C) 90, (D) 60, (E) , Leave your comments or Download question paper.

Question is ⇒ An FM transmitter has maximum frequency deviation of 75 kHz and reproduces audio signals up to 15 kHz. Minimum channel width required is __________ kHz., Options are ⇒ (A) 180, (B) 120, (C) 90, (D) 60, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An FM transmitter has maximum frequency deviation of 75 kHz and reproduces audio signals up to 15 kHz. Minimum channel width required is __________ kHz.
A.	180 [Wrong Answer]
B.	120 [Correct Answer]
C.	90 [Wrong Answer]
D.	60 [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Avalanche beakdown is primarily dependent on the phenomenon of
doping
collision
recombination
ionization

⇒ In a series RLC circuit the dB level of currents at half power frequencies as compared to current at resonance is
3
-3
0.5
-0.5

⇒ Modelling error may occur due to
neglecting the nonlinear characteristics of plant
inaccuracy of parameters
change of plant characteristics with time
any of the above

⇒ The use of microprocessor control in automobiles results in
improved fuel economy
improved car control
advanced information system for driver
all of the above

⇒ For a plate-modulated class C amplifier the plate supply voltage is E. The maximum plate cathode voltage could be almost high as
2E
3E
4E
6E

⇒ In an amplitude modulated waveform, the amplitude of the sideband is
independent of the carrier amplitude
independent of the modulation index
carrier amplitude x modulation index
1/2 carrier amplitude x modulation index

⇒ If X(z) = (1 - az^-1)^-1 and |a| < |z|, the initial value x₀ = 0
TRUE
FALSE

⇒ A radiation thermometer is suitable for temperatures
below 500°C
below 100°C
above 500°C
above 1400°C

⇒ In a receiver, which of the following device has IF input but RF output?
Demodulator
Loudspeaker
Audio amplifier
Frequency changer

⇒ If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is
23 dB
25 dB
46 dB
50 dB

⇒ In fi
the collector currents of T₁ and T₂ are equal
the collector current of T₁ is more than that of T₂
the collector current of T₁ is double that of T₂
the collector currents of T₂ is more than that of T₁

⇒ The applications of shift registers are

Time delay
Ring counter
Serial to parallel data conversion
Serial to serial data conversion

Which of the above are correct?
1, 2, 3
2, 3, 4
1, 2, 3, 4
1, 2, 4

⇒ A rectangular pulse train s(t) is shown in figure is convolved with the signal cos²(4p x 10³t). The convolved signal will
DC
12 kHZ sinusoidal
8 kHZ sinusoidal
14 kHZ sinusoidal

⇒ In following figure, what will be R₁ and R₂ for maximum symmetrical swing if V_CSat ≈ 0. Given that R_E = 200 Ω, R_C = 400 Ω, V_CC = 20 V, β
6 k
3 k, 6 k
9.9 k, 2.4 k
2.4 k, 9.9 k

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒ Consider the following state
1 only
1 and 2
2 only
3 only

⇒ A step down cycloconverter has an input frequency f. If it uses natural commutation, the output frequency
must be a sub-multiple of input frequency
can be any frequency
must be an even sub-multiple of input frequency
must be an odd sub-multiple of input frequency

⇒

Assertion (A): Linear ICs include audio amplifier, wideband amplifier, RF amplifier and IF amplifier

Reason (R): The error voltage in a feedback circuit is very small

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The transmission coefficient will be
1.70 - j 2.97
0.08 + j 0.32
1.32 + j 1.38
1.08 + j 0.32

⇒ n-channel MOS is
slower than p-channel MOS
faster than p-channel MOS
same as p-channel MOS
none of these

⇒ What is the frequency of pulse at the points a, b, c in the circ
3 MHz
7.8 KHz
10 KHz
1 MHz

⇒ The network shown in the figure represen
band pass filter
low pass filter
high pass filter
band stop filter

⇒

Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.

Reason (R): A semi converter is cheaper than a full converter.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): In Darlington pair, the overall β is product of individual β_s

Reason (R): The voltage gain of a base driven amplifier is equal to ac collector voltage divided by ac base voltage

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a normally biased N-P-N transistor the main current crossing the collector junction is
a drift current
a hole current
a diffusion current
same as the base current

⇒ In a specimen of n type semiconductor, the initial concentration of holes and electrons is p_no and n_no. When the specimen is subjected to radiation, the hole and electron concentration increase to p_n and n_n. Then
p_n - p_no = n_n - n_no
p_n + p_no = n_n + n_no
p_n - p_no = n_no + n_no
p_n + p_no = n_n - p_no

⇒ The static electric field in a conductor is
zero
unity
infinity
none of the above

⇒ What is the function of silicon dioxide layer in MOSFETS?
To provide high input resistance
To increase current carriers
To provide high output resistance
Both (a) and (c)

⇒ Monostable multivibrator is called one-shot or single-shot circuit because it
can be used once
can be used single and not with other circuits.
always returns by itself to its single stable state
changes to quasistable for a fixed period of time upon receipt of triggering signal.