Question is ⇒ An electrolytic capacitor can be used for, Options are ⇒ (A) ac only, (B) dc only, (C) both ac and dc, (D) high frequency ac, (E) , Leave your comments or Download question paper.

Question is ⇒ An electrolytic capacitor can be used for, Options are ⇒ (A) ac only, (B) dc only, (C) both ac and dc, (D) high frequency ac, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An electrolytic capacitor can be used for
A.	ac only [Wrong Answer]
B.	dc only [Correct Answer]
C.	both ac and dc [Wrong Answer]
D.	high frequency ac [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A counter displays a sequence of numbers. If a reading corresponds to the hexadecimal number F52E, the next two readings are respectively
F52F, F520
F530, F531
F52F, F530
F52F, F52G

⇒ In grid bias modulation system the power required for modulating amplifier
is negligibly low since grid is negative
is large as compared to that for plate modulation
is almost the same as compared with plate modulation
is small as compared to that for plate modulation

⇒ In a proportional plus integral control action
proportional gain K_p is adjustable but integral time T_i is constant
proportional gain K_p is adjustable but integral time T_i is adjustable
both proportional gain K_p and integral time T_i are adjustable
both proportional gain K_p and integral time T_i are constant

⇒ The highest modulating frequency typically used in AM systems is
1 kHz
5 kHz
20 kHz
50 kHz

⇒ In a radio receiver, the local oscillator is tuned to a frequency
lower than the incoming frequency
higher than the incoming frequency
equal to incoming frequency
any of the above

⇒ Consider the following:

Si
Ge
GaAs
InP

Which of the above semiconductors should be used for making highly efficient photodiodes?
1 and 4 only
3 and 4 only
1, 3 and 4
2, 3 and 4

⇒

Assertion (A): TWT uses a focussing mechanism to prevent the electron beam from spreading.

Reason (R): In a TWT the electron beam has to travel a much longer distance than in klystron.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When two 4 bit parallel adders are cascaded we get
4 bit parallel adder
8 bit parallel adder
16 bit parallel adder
none of the above

⇒ Which of the following antennas uses a number of varying length parallel elements?
Helical antenna
Pyramidal Horn
Comer reflection antenna
Yagi-Uda antenna

⇒ In a JFET the width of channel is controlled by
gate voltage
drain current
source current
all of the above

⇒ As compared to bipolar junction transistor, a FET
is less noisy
has better thermal stability
has higher input resistance
all of the above

⇒ In a transistor the minimum and maximum values of β_dc are 100 and 121. The proper value of β_dc to be used to locate Q point is
100
121
110.5
110

⇒ For the time domain response shown in figure the
lies on negative real axis
lies on positive real axis
lies on imaginary axis
is complex or imaginary

⇒ In an ac single phase energy meter, the potential coil is put on
both side limbs, of upper magnet
central limb of upper magnet
one side limb of upper magnet
either (a) or (b)

⇒ In which condition does BJT behave like a closed switch?
Cut off
Saturation
Forward active
Reverse active

⇒ Isotropic radiator is one that radiates energy
uniformly in all direction
inside a hollow sphere
in a well defined isotropic direction
none of the above

⇒ The number of distinct Boolean expression of 4 variables is
16
256
1024
65536

⇒ The v-i characteristics of a diode may be linear or non linear.
TRUE
FALSE

⇒ Consider the following statements about loop antenna

It is suitable for direction finding application
It is a single turn or multiturn coil carrying RF current
The loop is surrounded by a magnetic field everywhere perpendicular to the loop

Which of the above statements are correct?
1 and 2 only
1 only
1, 2, 3
2 and 3 only

⇒ An n type semiconductor is illuminated by a steady flux of photons with energy greater than the band gap energy. The change in conductivity Δσ obeys which relati
Δσ = 0
Δσ = e(σ_n + σ_p) Δ_n
Δσ = e(μ_nΔ_n - μ_pΔ_p)
Δσ = e μ_nΔ_n

⇒ In CB amplifier the distortion of the input voltage waveform may occur due to
very low input resistance of an amplifier
very high input resistance of the amplifier
improper biasing
ripples in power supply

⇒ Consider the following:

Oscillator
Emitter follower
Cascaded amplifier
Power amplifier

Where of these use feedback amplifiers?
1 and 2
1 and 3
2 and 4
3 and 4

⇒ When .4546 E 5 and .5433 E 7 are to be added in normalized floating point mode
none of the numbers is changed to any other form
.4546 E 5 is changed .004546 E 7 and .5433 E 7 is not changed
.5433 E 7 is changed to 54.33 E 5 and .4546 E 5 is not changed
both the numbers are changed and their exponents are made equal to 6

⇒ As the viscosity of a liquid increases, the relaxation time
remains constant
increases
decreases
first decreases then increases

⇒

Assertion (A): The Fourier series of the wave shown in the figure does not contain even harmao
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is
23 dB
25 dB
46 dB
50 dB

⇒

Assertion (A): Oxide coated cathodes are very commonly used.

Reason (R): Work function of oxide coated cathode is 1 eV whereas it is 4.5 eV for pure tungsten.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a waveguide the dielectric region is generally
air
magnetic material
brass
mica

⇒ In a 3 phase semiconverter, the output voltage becomes discontinuous for
firing angle > 30°
firing angle > 60°
firing angle > 90°
firing angle > 120°

⇒ A 4 bit shift register is initialized to value 1000 for (Q₃, Q₂, Q₁, Q₀). The D input is derived from Q₀, Q₂ and Q₃ through two XOR gates as shown in figure. The pattern 1000 will appea
3rd pulse
7th pulse
6th pulse
4th pulse