Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | An averaVoltage of 10 V is induced in a 250 turns solenoid as a result of a change in flux which occurs in 0.5 second. The total flux change is |

A. | 20 Wb [Wrong Answer] |

B. | 2 Wb [Wrong Answer] |

C. | 0.2 Wb [Wrong Answer] |

D. | 0.02 Wb [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :Virendra Said on 2016-11-23 13:55:19@=LI/N=10*0.5/250=0.02 Note=L=V/I per sec(0.5) !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Lenz's law is a consecluence of the law of conservation of

induced current

charge

enery

induced e.m.f.

⇒ Ifcurrentin a conductor increases then according to Lenz's law self-induced voltage will

aid the increasing current

tend to decrease the amount of current

produce current opposite to the increasing current

aid tite applied voltage

⇒ The self inductances of two coils are 8 mH and 18 mH If the co-efficients of coupling is 0.5, the mutual inductance of the coils is

4 mH

5 mH

6 mH

12 mH

⇒ The core of a coil has a length of 200 mm. The inductance of coil is 6 mH. If the core length is doubled, all other quantities, remaining the same, the inductance will be

3 mH

12 mH

24 mH

48 mH

⇒ A conductor 2 metres long moves at right angles to a magnetic field of flux densit 1 tesla with a velocity of 12.5 m/s. The induced e.m.f. in the conductor will be

10 V

15 V

25 V

50 V

⇒ A coil is wound on iron core which carries current I. The self induced voltage in the coil is not affected by

variation in coil current

variation in voltage to the coil

change of number of turns of coil

the resistance of magnetic path

⇒ A coil induces 350 mV when the current changes at the rate of 1 A/s. The value of inductance is

3500 mH

350 mH

250 mH

150 mH

⇒ Two 300 µH coils in series without mutual coupling have a total inductance of

300 µH

600 µH

150 µH

75 µH

⇒ Both the number of turns and the core length of an inductive coil are doubled. Its self-inductance will be

unaffected

doubled

halved

quadrupled

⇒ The co-efficient of self-inductance for a coil is given as

NI/Φ

NΦ/I

NI

^{2}/Φ

NΦ/I

^{2}

⇒ Which of the following statements is cotrect ?

The inductance of the coil carrying a constant D.C. current will change the current into pulses

The inductance of the coil carrying a constant D.C. current will increase the current

The inductance of the coil carrying a constant D.C. current will not affect the current

The inductance of the coil carrying a constant D.C. current will decrease the current

⇒ As per Faraday's laws of electromagnetic induction, an e.m.f. is induced in a conductor whenever it

lies perpendicular to the magnetic flux

lies in a magnetic field

cuts magnetic flux

moves parallel to the direction of the magnetic field

⇒ In case of an inductance, current is proportional to

voltage across the inductance

magnetic field

both (a) and (b)

neither (a) nor (b)

⇒ Which of the following inductor will have the least eddy current losses?

Air core

Laminated iron core

Iron core

Powdered iron core

⇒ In an iron cored coil the iron core is removed so that the coil becomes an air cored coil. The inductance of the coil will

increase

decrease

remain the same

initially increase and then decrease

⇒ Higher the self-inductance of a coil,

lesser its weher-turns

lower the e.m.f. induced

greater the flux produced by it

longer the dela' in establishing steady current through it

⇒ Two coils have self-inductances of 10 H and 2 H, the mutual inductance being zero. If the two coils are connected in series, the total inductance will be

6 H

8 H

12 H

24 H

⇒ A coil with negligible resistance has 50 V across it with 10 mA. The inductive reactance is

50 ohms

500 ohms

1000 ohms

5000 ohms

⇒ A crack in the magnetic path of an inductor will result in

unchanged inductance

increased inductance

zero inductance

reduced inductance

⇒ Which of the following is not a unit of inductance?

Henry

Coulomb/volt ampere

Volt second per ampere

All of the above

⇒ Which of the following is unit of inductance?

Ohm

Henry

Ampere turns

Webers/metre

⇒ Two coils have inductances of 8 mH and 18 mH and a co-efficient of coupling of 0.5. If the two coils are connected in series aiding, the total inductance will be

32 mH

38 mH

40 mH

48 mH

⇒ Mutually inductance between two magnetically-coupled coils depends on

permeability of the core

the number of their turns

cross-sectional area of their common core

all of the above

⇒ A 200 turn coil has an inductance of 12 mH. If the number of turns is increased to 400 turns, all other quantities (area, length etc.) remaining the same, the inductance will be

6 mH

14 mH

24 mH

48 mH

⇒ An averaVoltage of 10 V is induced in a 250 turns solenoid as a result of a change in flux which occurs in 0.5 second. The total flux change is

20 Wb

2 Wb

0.2 Wb

0.02 Wb

⇒ The co-efficient of coupling between two air core coils depends on

self-inductance of two coils only

mutual inductance between two coils only

mutual inductance and self inductance of two coils

none of the above

⇒ Which of the following circuit elements will oppose the change in circuit current?

Capacitance

Inductance

Resistance

All of the above

⇒ Which circuit element(s) will oppose the change in circuit current?

Resistance only

Inductance only

Capacitance only

Inductance and capacitance

⇒ An open coil has

zero resistance and inductance

infinite resistance and zero inductance

infinite resistance and normal inductance

zero resistance and high inductance

⇒ A laminated iron core has reduced eddy-current losses because

more wire can he used with less D.C. resistance in coil

the laminations are insulated from each other

the magnetic flux is concentrated in the air gap of the core

the laminations are stacked vertically