Question is ⇒ An arbitrary signal<i> m (t)</i> has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is, Options are ⇒ (A) AM-DSB signal with suppressed carrier, (B) AM-DSB signal with carrier, (C) AM-SSB signal with carrier, (D) a sequence of exponentially decaying sine waves, (E) , Leave your comments or Download question paper.

Question is ⇒ An arbitrary signal<i> m (t)</i> has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is, Options are ⇒ (A) AM-DSB signal with suppressed carrier, (B) AM-DSB signal with carrier, (C) AM-SSB signal with carrier, (D) a sequence of exponentially decaying sine waves, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
A.	AM-DSB signal with suppressed carrier [Wrong Answer]
B.	AM-DSB signal with carrier [Correct Answer]
C.	AM-SSB signal with carrier [Wrong Answer]
D.	a sequence of exponentially decaying sine waves [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 8085 microprocessor, if interrupt service requests have been received from all of the following interrupts, then which one will be serviced first?
RST 5.5
RST 6.5
RST 7.5
None

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88W
7.3 W
73 W

⇒ The following circuit resonate
0.5 Hz
5 Hz
1 rad/sec
0.5 rad/sec

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒ Microwaves are used for
telephony
radio broadcast
TV systems
all of the above

⇒ Nichrome is used in
heater coils
underground cables
overheated wires
lamp filament

⇒ The equation sin (z) = 10 has
no real or complex solution
exactly two distinct complex solutions
a unique solution
an infinite number of complex solutions

⇒ In a microprocessor, the service routine for a certain interrupt starts from a fixed location of memory which cannot be externally set, but the interrupt can be delayed or rejected. Such an interrupt is
non-maskable and non-vectored
maskable and non-vectored
non-maskable and non-vectored
maskable and vectored

⇒ If Z(s) has a pole at origin, the realization leads to
a resistance in series
an inductance in series
a capacitance in series
a resistance or capacitance in series

⇒ The braking torque in single phase energy meter is proportional to speed of disc.
TRUE
FALSE

⇒ In a synchronous counter all flip flops are clocked together.
TRUE
FALSE

⇒ In figure the rms valu
5
2.5
2.5
50

⇒

Assertion (A): Gate triggering is the most commonly used method for triggering of an SCR.

Reason (R): Even a small gate current is sufficient to turn on an SCR.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): Superposition theorem can be used to find the output of a full wave rectifier excited by sinusoidal signal sources of different frequencies connected in series.

Reason (R): Superposition theorem is valid for all linear systems.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For a good voltage amplifier, its input impedance should be
low as compared to the resistance of the source
high as compared to the resistance of the source
always inductive
always capacitive

⇒ Karnaugh map can not be drawn when the number of variables is more than 4
TRUE
FALSE

⇒ A class C amplifier uses
high Q tuned circuit
low Q tuned circuit
untuned circuit
either (b) or (c)

⇒ Which of the following is not a valid real constant in C?
1.2 e 2.0
-2.3 e - 2
-2.3 E 2
-2.3 e 2

⇒ The resistance of the aluminium conductor (r = 2.83 x 10^-8 Ωm) in figur
0.001 Ω
less than 0.001 Ω
more than 0.001 Ω
more than 0.002 Ω

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A differentiating amplifier has capacitor in the input path.
TRUE
FALSE

⇒ The frequency range of 300 kHz to 3000 kHz is known as
low frequency
medium frequency
high frequency
very high frequency

⇒ If A = 4∠7°, A² is
16∠14°
16∠49°
16∠7°
16∠3.5

⇒ The range of memory location in given memory interfacing scheme
0000H - 07FFH
F800H - FFFFH
0000H - 03FFH
0000H - 3FFFH

⇒ For the logic circuit given, what is the simplified Boolean funct
X = AB + C
X = BC + A
X = AB + AC
X = AC + B

⇒ It f(t) is an odd function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of I_c(sat).
storage time
fall time
turn-on time
turn-off time

⇒ The current rating of dc tachogenerator is usually
small
high
medium
either (b) or (c)

⇒ In paramagnetic materials
permanent magnetic dipoles exist but the interaction between neighbouring dipoles is negligible
permanent magnetic dipole do not exist
permanent magnetic dipoles exist and the interaction between neighbouring dipoles is very strong
permanent magnetic dipole moment may or may not exist

⇒ The expression H_Z = C cos(Bx) cos(Ay)yz is for
TE wave
TM waves
both TE and TM waves
some TE and some TM waves