Question is ⇒ An alternating current or voltage is that which, Options are ⇒ (A) changes in magnitude only, (B) changes in direction only, (C) both (a) and (b), (D) has a random movement of electrons, (E) , Leave your comments or Download question paper.

Question is ⇒ An alternating current or voltage is that which, Options are ⇒ (A) changes in magnitude only, (B) changes in direction only, (C) both (a) and (b), (D) has a random movement of electrons, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An alternating current or voltage is that which
A.	changes in magnitude only [Wrong Answer]
B.	changes in direction only [Wrong Answer]
C.	both (a) and (b) [Correct Answer]
D.	has a random movement of electrons [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Ionic solids, in general, have no electrical conductivity.

Reason (R): In ionic solids, electrons are tightly bound to the nucleus.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of days when Earth's shadow falls on a geosynchronous satellite is
88
277
5
10

⇒ The number of lobes on each side of a 31 resonant antenna will be
2
3
4
6

⇒ Which of the following compensation method in amplifier can be used to reduce the bandwidth?
Pole-zero compensation
Dominant pole compensation
Lead compensation
Any of the above

⇒ As compared to an ordinary semiconductor diode, a Schottky diode
has lower cut in voltage
has higher cut in voltage
lower reverse saturation current
both (b) and (c)

⇒ Consider the common emitter amplifier shown below with the following circuit parameters: β = 100, g_m = 0.3861 A/V, r₀ = ∞ r_p = 259 Ω, R_s = 1 kΩ, R_B = 93 kΩ, R_C = 250 Ω, R_L = 1 kW, C₁ = ∞ and C₂ = 4.
258 Ω
1258 Ω
93 kΩ
∞

⇒ The hexadecimal number 64 AC is equivalent to decimal number
25727
25722
25772
25777

⇒ A single phase half wave converter is feeding a resistive load. Output dc power is P_dc and total power delivered to load is P_ac then
P_dc = P_ac for all values of firing angles
P_dc = P_ac if firing angle is less than 180°
P_dc < P_ac for all values of firing angles
P_dc < P_ac if firing angle is less than 180°

⇒ A network is causal if impulse response is zero for t < 0.
TRUE
FALSE

⇒ For transmission line load matching over a range of frequencies, it is best to use a
double stub
balun
single stub of adjustable position
broadband directional coupler

⇒ In a single phase full wave converter (M - 2 connection) feeding a highly inductive load, the firing angle for each thyristor is a in the respective half cycle. The period of conduction of each thyristor is
p - a
p
p + a
p - 2a

⇒ Which of the following are the properties of a medium?
Permeability, flux, magnesium
Permittivity, permeability, insulation
Permeability, resistivity, conductivity
Permittivity, permeability, conductivity

⇒ An ac network has two sources of the same frequency. The currents in one branch when the sources act independently are 10 ∠30° A and 10 ∠60° A. When both sources act, the current in the branch should be
19.32 ∠45°
15 ∠45°
20 ∠45°
zero

⇒

Assertion (A): An unbiased p-n junction develops a built-in potential at the junction with the n-side positive and the p-side negative.

Reason (R): The p-n junction behaves as a battery and supplies current to a resistance connected across its terminals.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Recommended fanout for ECL is
5
10
15
25

⇒ Which of these devices is used in relaxation oscillator?
UJT
SCR
DIAC
TRIAC

⇒ Quantizing error occurs in
TDM
FDM
PCM
PWD

⇒ The stator of phase shifting transformer for use in conjunction with an ac potentiometer has a
single phase winding
two phase winding
3 phase winding
either (a) or (c)

⇒ The output voltage of a charger is
less than battery voltage
same as battery voltage
more than battery voltage
same or more than battery voltage

⇒ Which of the following does not apply to Yagi-Uda antenna
High gain
Reasonably good bandwidth
Folded dipole
Parasitic elements

⇒ In an impedance smith chart, a clockwise movement along a constant resistance circle gives rise to
decrease in the value of reactance
an increase in the value of reactance
no change in the reactance value
no change in the impedance value

⇒ For an m x n matrix A, the eigen values are the roots of the characteristic equation
|I - A|
|λI - A| = 0
|λA - I| = 0
|A - I| = 0

⇒ The bandwidth required for amplitude modulation is
half the frequency of modulating signal
equal to the frequency of modulating signal
twice the frequency of modulating signal
four times the frequency of modulating signal

⇒ Special circuits using neon tubes, contact relays and capacitors are used in many domestic appliances. The role of capacitor in figure i
reduce power loss
function as resistor when relay is on
delay the operation of the contact relay after switching on
open circuit the relay terminals

⇒ The advantages of flash memory over EEPROM are
higher density
lower cost
both higher density and lower cost
none of the above

⇒ Volt is equivalent to
joule/coulomb
joule/watt
joule/ampere
joule/volt

⇒ How is an N-channel junction Field Effect Transistor operated as an amplifier?
With a forward bias gate source junction
With a reverse bias gate-source junction
With a open gate source junction
With a shorted gate source junction

⇒ For an npn transistor connected as shown in the figure V_BE = 0.7 volts. Given that reverse saturation current of the junction at room temperature 300K is 10^-13A, the emitter curr
30 mA
39 mA
49 mA
20 mA

⇒ The contents of the commands register are 23 H. Then port C
is an input port
is an output port
is both input as well as output port
none of the above

⇒ To avoid creep in an energy meter
two shading bands are put on shunt magnet
two shading bands are put on series magnet
two holes are cut in the disc on opposite sides of spindle
the potential coil is made of very thin wire