Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | An ac network has a power factor of 0.8 leading if the applied wave is of fundamental frequency. If the applied wave contains third and fifth harmonics, the overall power factor will be |

A. | 0.8 leading [Wrong Answer] |

B. | less than 0.8 leading [Wrong Answer] |

C. | more than 0.8 leading [Correct Answer] |

D. | 0.8 leading or more [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The pre-emphasis in FM aids in providing extra noise immunity by

emphasizing only the higher frequency components

emphasizing the entire frequency band

emphasizing only the lower frequency band

cutting down the low frequency noise

⇒ The depth of modulation is doubled in FM system then, the power transmitted

increase by factor of 2

increase by factor of 3

increase by factor of 2

none of the above

⇒ Which of the following factor does NOT contribute to the drift of a geostationary satellite from its stationary position in space?

Pressure of solar radiations

Gravitational changes due to Sun and Moon

Oblateness of the Earth

Weight of the satellite

⇒ In cable TV local programmes can be telecast at any frequency.

TRUE

FALSE

⇒ In figure, the power dissipated in 4 resistance is P

_{1}and power associated with 3 A source is P

_{2}.

P

_{1}= P

_{2}

P

_{1}< P

_{2}

P

_{1}> P

_{2}

P

_{1}may be equal or less than P

_{2}

⇒ Secondary emission occurs in

diode

triode

tetrode

pentode

⇒ Whenever a JFET operates above pinch-off voltage

depletion regions become smaller

drain current increase steeply

drain current starts decreasing

drain current remains nearly constant

⇒ Consider the following in C

4 and 300 respectively

4.2 and 300.00 respectively

4 and 300.00 respectively

⇒ As compared to full wave rectifier, a half wave rectifier

has higher ripple factor

has lower ripple factor

may have higher or lower ripple factor

has same ripple factor

⇒ The dead zone in a pyrometer is 0.125% of span. The calibration is 400°C to 1000°C. What temperature change might occur before it is detected.

0.125°C

0.75°C

0.4°C

1°C

⇒ Video signals are transmitted through

amplitude modulation

frequency modulation

either amplitude or frequency modulation

neither amplitude nor frequency modulation

⇒ Figure shows a portion of linear

*v*-

*i*characteristics of diode. If applied voltage is + 6 V, the current wil

42 mA

48 mA

51 mA

54 mA

⇒ Vestigial sideband is most commonly used in

radio transmission

television transmission

telephony

all of the above

⇒ What is the approximate steady state current in the above circ

50 A

25 A

0.208333333333333

0.0416666666666667

⇒ Electric breakdown strength of a material depends on its

composition

moisture content

thickness

all of the above

⇒ A PC has typically

5 to 10 KB of main memory

10 to 100 KB of main memory

100 to 256 KB of main memory

256 KB to 1 MB of main memory

⇒ The purpose of connecting a coupling capacitor in the output circuit of an amplifier is

to increase voltage gain

to increase collector current

to block dc collector voltage

all of the above

⇒ Power is drawn from a source at power factor 0.7. P

_{av}= 300 watt. The reactive power is

0

105

100 VA

107 VA

⇒

Match the following:

List I (Operation in Basic) | List II (Priority) | ||
---|---|---|---|

A. | Exponentiation | 1. | 1 |

B. | Multiplication and division | 2. | 2 |

C. | Addition and subtraction | 3. | 3 |

D. | Expression within parenthesis | 4. | 4 |

A-1, B-2, C-3, D-4

A-2, B-3, C-1, D-4

A-4, B-3, C-2, D-1

A-2, B-3, C-4, D-1

⇒ Consider a baseband binary PAM receiver shown below. The additive channel noise

*n*(

*t*) is whit with power spectral density S

_{N}(

*f*) = N

_{0}/2 = 10

^{-20}W/Hz. The low-pass filter is ideal with unity gain and cutoff frequency 1 MHz. Let Y

_{k}represent the random variable

*y*(

*t*

0.5 x

0.5 x

0.5 x

_{k}0.5 x*e*^{-3.5}0.5 x

*e*^{-5}0.5 x

*e*^{-7}0.5 x

*e*^{-10}

⇒ A MASER is a

low noise device

high noise device

medium noise device

may be either high or medium noise device

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I

⇒ If

0.5 and 1

- 2 and 1

30 and 1

30 and 1.5

⇒ The Depth of penetration of EM wave in medium having conductivity σ at a frequency of 1 MHz is 25 cm. The depth of penetration at a frequency of 4 MHz will be

6.25 cm

12.50 cm

50 cm

100 cm

⇒ In orthogonal BFSK. the energy of information bearing term is :

the same as total transmitted energy

one half of total transmitted energy

one fourth of total transmitted energy

None

⇒ The Ebers-moll equation for I

I

I

I

I

⇒ In

is nearly equal to density of acceptor atoms

is much greater than density of acceptor atoms

is much less than density of acceptor atoms

may be equal to or more or less than density of acceptor atoms

⇒ In the given figure forward voltage wave has a magni

90 V

60 V

30 V

10 V

⇒ In a second order undamped system, the poles are on

positive real axis

imaginary axis

negative real axis

either (a) or (c)

⇒ The gate lead, in a thyristor is welded to :

outside

⇒ A MASER is a

low noise device

high noise device

medium noise device

may be either high or medium noise device

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I

_{CBO}= 0, if V_{BB}= 6V, R_{E}= 2 kΩ and β = 90, I_{BQ}= 20 μA then R_{B200 kΩ265 kΩ150 kΩ100 kΩ}⇒ If

*i*_{b}is plate current,*e*_{b}is plate voltage and*e*_{c}is grid voltage the*v*-*i*curve of a vacuum triode0.5 and 1

- 2 and 1

30 and 1

30 and 1.5

⇒ The Depth of penetration of EM wave in medium having conductivity σ at a frequency of 1 MHz is 25 cm. The depth of penetration at a frequency of 4 MHz will be

6.25 cm

12.50 cm

50 cm

100 cm

⇒ In orthogonal BFSK. the energy of information bearing term is :

the same as total transmitted energy

one half of total transmitted energy

one fourth of total transmitted energy

None

⇒ The Ebers-moll equation for I

_{E}in CB configuration is given byI

_{E}= a_{n}I_{C}I_{EC0}I

_{E}= a_{I}I_{C}+ I_{C0}I

_{E}= a_{n}I_{C}+ I_{C0}(*e*^{qVEB/KT-1})I

_{E}= a_{I}I_{C}+ I_{E0}(*e*^{qVEB/KT}- 1)⇒ In

*p*type semiconductor, the hole concentrationis nearly equal to density of acceptor atoms

is much greater than density of acceptor atoms

is much less than density of acceptor atoms

may be equal to or more or less than density of acceptor atoms

⇒ In the given figure forward voltage wave has a magni

90 V

60 V

30 V

10 V

⇒ In a second order undamped system, the poles are on

positive real axis

imaginary axis

negative real axis

either (a) or (c)

⇒ The gate lead, in a thyristor is welded to :

*p*layer to which anode is connected*n*layer nearest to the anode terminal*p*layer nearest to the cathode terminaloutside

*n*layer