Question is ⇒ An 8156 has A15 connected to its CE input. A14 to A8 are unconnected, and AD7 to AC0 are connected ignoring shadows, what are the RAM locations?, Options are ⇒ (A) (4000)H - (40FF)H, (B) (8000)H - (80FF)H, (C) (8000)H - (40FF)H, (D) Any of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ An 8156 has A15 connected to its CE input. A14 to A8 are unconnected, and AD7 to AC0 are connected ignoring shadows, what are the RAM locations?, Options are ⇒ (A) (4000)H - (40FF)H, (B) (8000)H - (80FF)H, (C) (8000)H - (40FF)H, (D) Any of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected ignoring shadows, what are the RAM locations?
A.	(4000)_H - (40FF)_H [Wrong Answer]
B.	(8000)_H - (80FF)_H [Correct Answer]
C.	(8000)_H - (40FF)_H [Wrong Answer]
D.	Any of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In an n-type silicon crystal at room temperature, which of the following can have a concentration of 4 x 10¹⁹ cm^-3?
Silicon atoms
Holes
Dopant atoms
Valence electrons

⇒ A MOD - 2 counter, the FF has a t_pd = 60 nsec. The NOR gate has a t_pd of 30 nsec. The clock frequency is
37 MHz
40 MHz
111 MHz
none

⇒ Consider the following statements about Infix and Post fix notations in Pascal

In Infix notation operators appear between the operands on which they operate.
In Post fix notation operators appear after the operand.
The Infix expression A + B - C + D will appear as AB + C - D + in post fix notation.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Which of the following is a digital modulation technique?
PCM
PSK
DM
All

⇒ Each cell of a static Random Access memory contains
6 MOS transistor
4 MOS transistor, 2 capacitor
2 MOS transistor, 4 capacitor
1 MOS transistor and 1 capacitor

⇒ If a wave is propagated in free space, it will be in nature of
TE
TM
TEM
Any one of above

⇒ The input voltage for starting oscillations in an oscillator is caused by
negative feedback
positive feedback
noise voltage in resistors
a special generator

⇒ Directive gain is
a power ratio
a voltage ratio
a current ratio
a distance ratio

⇒ A single phase full converter can operate in
4 quadrants
3 quadrants
2 quadrants
1 quadrant

⇒ Some advantages of optical fibre cables are

small diameter
Immunity to cross talk and EM interference
Laser and LED modulation methods lend themselves ideally to digital operation

Which of the above are correct?
1 only
1 and 2
1, 2, 3
2, 3

⇒ Consider the following statements about Rhombic antenna

It is non resonant
It is a broad band antenna
It is ideally suited for HF transmission

Which of the above are correct?
1, 2, 3
1, 3 only
2, 3 only
1 only

⇒ The general purpose register code for accumulator in 8085 is
111
0
1
1111

⇒ In a semi converter feeding a resistive load
the waveshapes of output voltage and output current are exactly similar
the waveshapes of output voltage and output current can not be similar
the waveshapes of output voltage and output current are similar only for low values of firing angle
the waveshapes of output voltage and output current may be similar or dissimilar

⇒ A 4 bit ripple counter uses flip flops with propagation delay of 50 ns each. The maximum clock frequency which can be used is
5 MHz
10 MHz
20 MHz
25 MHz

⇒ The multiplier resistance and meter coil in a voltmeter are in
series
parallel
series-parallel
either (a) or (b)

⇒ The correct relation between joules and calories is
calories = joules/4.156
joules = calories/4.156
calories = joules x 10⁷/4.156
joules = calories x 10⁷/4.156

⇒ Varactor diodes use
silicon
GaAs
either (a) or (b)
neither (a) nor (b)

⇒ The voltage e_o indicated in the figure has been measured by an ideal voltmeter. Which of the following can be calcula
Bias current of inverting input only
Bias current of inverting and non-inverting inputs only
Input offset current only
Both the bias currents and the I/P offset current

⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output, frequency for the carrier will be
26 MHz
26.1 MHz
10 kHz
160 kHz

⇒ The equivalent circuit shown in figure is
CE
CB
CC
None of the above

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ Consider a parallel plate capacitor being charged. Identify the incorrect statements
Energy stored in the capacitor does not enter it through the connecting wires but through the space around the wires and plates uf capacitor
Rate at which energy flows into this volume is equal to the integration of the Poynting vector over the boundary of the volume between the plates.
The Poynting vector points everywhere radially outward of the volume between the plates
The Poynting vector points everywhere radially into the volume between the plates.

⇒ Following is a reason of distortion in communication system
external interference
random variations
insufficient Channel Bandwidth
all

⇒ The F.T. of a conjugate symmetric function is always
imaginary
real
conjugate Unsymmetric
conjugate symmetric

⇒

Assertion (A): Impedance measurement at microwave frequencies is done by finding SWR.

Reason (R): SWR and reflection coefficient depend on the characteristic impedance and load impedance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The timing difference between a slow memory and fast processor can be resolved if
processor is capable of waiting
external buffer is used
either (a) or (b)
neither (a) nor (b)

⇒ In VHS format the width of tape is
2"
1"
1/2"
1/4"

⇒

Assertion (A): A BJT can be used as a switch.

Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Find R_TH across the terminals A a
52.28 Ω
58.28 Ω
52.82 Ω
58.82 Ω

⇒ In a radio receiver, if the intermediate frequency is too high
Selectivity will be poor
Tracking difficulties will be least
Adjacent channel rejection will improve
All of the above will occur