Question is ⇒ AM-SC stands for, Options are ⇒ (A) Amplitude Modulated-Suppressed Carrier, (B) Amplitude Modulated-Single Carrier, (C) Amplitude Modulated-Synchronous Carrier, (D) Amplitude Modulated-Self Carrier, (E) , Leave your comments or Download question paper.

Question is ⇒ AM-SC stands for, Options are ⇒ (A) Amplitude Modulated-Suppressed Carrier, (B) Amplitude Modulated-Single Carrier, (C) Amplitude Modulated-Synchronous Carrier, (D) Amplitude Modulated-Self Carrier, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	AM-SC stands for
A.	Amplitude Modulated-Suppressed Carrier [Correct Answer]
B.	Amplitude Modulated-Single Carrier [Wrong Answer]
C.	Amplitude Modulated-Synchronous Carrier [Wrong Answer]
D.	Amplitude Modulated-Self Carrier [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected.Ignoring shadows, the port addresses
80 H
85 H
82 H, 83 H
80 H to 85 H

⇒ In a conventional AM superhetrodyne receivers, the detectors employed to extract intelligence include
Peak detectors
Ratio detectors
PLL
Slope detectors

⇒ The minimum decimal equivalent of the number 11C0 is
183
194
268
269

⇒

Assertion (A): In 8085 WR and RD signals are active high.

Reason (R): LOW WR means write operation and low RD means read operation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
400 V
about 100 V
about 20 V
zero

⇒ Access time of a storage is the time required
to write one word into the memory
to read one word from the memory
to write one word into and to read one word from the memory
either to write one word or to read one word

⇒ For an RC admittance function Y, the slope dY/dσ
is positive
is negative
may be positive or negative
0

⇒ In Modulation, "carrier" is
resultant wave
speech voltage to be transmitted
voltage with constant frequency, phase or amplitude
voltage for which frequency, phase or amplitude is varied

⇒ For the signal flow graph of the given figure consider the following statements

It has three forward paths
It has three individual loops
It has two non touching loops

Out of above the correct statements
1, 2, 3
1, 2
2, 3
1, 3

⇒ In the circuit, the value of the voltage source
-22 V
-12 V
+12 V
-10 V

⇒ The value of program counter of 6800 at power on are after reset is
0
FFFE
User Programmable
FFFF

⇒ Which two rows represent identical binary numbers?
A second and fourth
Fifth and eight
Third and seventh
Second and third

⇒ Which of the following statement is correct?
Pre-emphasis circuits are used in AM transmitters
FM reception is noise free as compared to AM
A limiter state is also used in AM receivers
Discriminator is used for the detection of AM signals

⇒ A semiconductor diode is biased in forward direction and carrying current I. The current due to holes in p material is
I
0
less than I
0.5

⇒ In a single phase full wave regulator feeding R-L load, short gate pulse are not suitable.
TRUE
FALSE

⇒ High IF in a superheat receiver
improves selectivity
increases tracking problems
decreases tracking problems
reduces adjacent channel rejection

⇒ The normalised form of 0.0152 x 10¹⁸ is
0.152 x 10¹⁷
1.52 x 10¹⁶
15.2 x 10¹⁵
152 x 10¹⁴

⇒ Resistivity of metals consists of two parts, one part constant and the other temperature dependent.
TRUE
FALSE

⇒ Recommended fanout for ECL is
5
10
15
25

⇒ At a given probability of error, binary coherent FSK is interior to binary coherent PSK by
6 dB
3 dB
2 dB
0 dB

⇒ Find value
1A
0A
0.45 A
None of these

⇒ Point out the wrong statement, Sequential logic circuit is
one that requires a clock to change states
one in which past affects the present states
one whose outputs changes immediately when the inputs change
also called clock logic or synchronous logic

⇒ The switch board instruments
should be mounted in vertical position
should be mounted in horizontal position
should be mounted at about 45°
should be mounted at about 80°

⇒ A material for permanent magnet should have
High retentivity
High permeability
Low hysteresis loss
High hysteresis loss

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What percentage negative feedback should be introduced to the amplifier so that linear oscillations result?
0.0125
0.025
-0.0125
-0.025

⇒ It is desired to couple a coaxial line to a two parallel wire line. It is best to use
quarter wave transformer
balun
slotted line
directional coupler

⇒ The thermal resistance of a BJT is about
100° C/W
200° C/W
20° C/W
2° C/W

⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases

⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere.
7.07
10
12.07
2.07

⇒ For the time domain response shown in figure the
lies in left half plane
lies in right half plane
lies at origin
may be complex or imaginary