Question is ⇒ AM transmitter employing low level modulation, Options are ⇒ (A) uses class C amplifier for amplification, (B) requires higher audio power, (C) has a poor efficiency, (D) has a higher efficiency, (E) , Leave your comments or Download question paper.

Question is ⇒ AM transmitter employing low level modulation, Options are ⇒ (A) uses class C amplifier for amplification, (B) requires higher audio power, (C) has a poor efficiency, (D) has a higher efficiency, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	AM transmitter employing low level modulation
A.	uses class C amplifier for amplification [Wrong Answer]
B.	requires higher audio power [Wrong Answer]
C.	has a poor efficiency [Correct Answer]
D.	has a higher efficiency [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Both X and Y plates of a CRO are excited by ac signals. The display is an ellipse which makes one rotation in 5 seconds. This means that
the frequency of one input is 5 times that of other
the difference between the frequencies of the two signals is one fifth of hertz
the difference between the frequencies of the two signals is 5 Hz
either (a) or (c)

⇒ Δ²V = - r/E is known as __________ equation
Poisson
Fourier
Laplace
Maxwell

⇒ Which of the following parameters is negligible in transmission lines?
R
L
C
G

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
0.3 V
0.5 V
1 V
1.5 V

⇒ In p-n-p transistor the current I_E has two components viz. I_EP due to injection of holes from p-region to n-region and I_E due to injection of electrons from n-region to p-region. Then
I_Ep and I_En are almost equal
I_Ep >> I_En
I_En >> I_Ep
either (a) or (c)

⇒ A stepper motor is
a two phase induction motor
is a kind of rotating amplifier
is an electromagnetic transducer used to convert an angular position of shaft into electrical signal
is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis

⇒ An RF carrier of 12 kV at 1 MHz is amplitude modulated by 1 kHz signal having peak value of 6 kV. The modulation pattern is seen on CRO screen. The voltage indicated will be
18 kV
1.001 kV
6 kV
36 kV

⇒ If the Nyquist plot does not encircle the (-1 + j0) point the system is always stable.
TRUE
FALSE

⇒ CATV stands for
Common Antenna Television
Community Antenna Television
Cable Antenna Television
Channel Antenna Television

⇒ Some typical examples of macroscopic quantities are
conductivity
µ_r
dielectric constant
all of the above

⇒ In a D latch
D drives R and D drives S
D drives S and D drives R
D drives both R and S
D drives both R and S

⇒ Crossover distortion behaviour is characteristic of
class A O/P stage
class B O/P stage
class AB output stage
common pulse O/P state

⇒ In floating point representation decimal number 13.5 is
1101.1
1.1011 x 2³
0.11011 x 2⁴
11.011 x 2²

⇒ Capacitive transducer is superior to inductive type for measurement of capacitance because of
absence of non-linearity
high frequency response
small size
high accuracy

⇒ The voltage drop per ampere-metre of an aluminium conductor is higher as compared to a copper conductor of the same size due to its higher
insulation resistance
resistivity
conductivity
current density

⇒ Companding is used in PCM to
reduce bandwidth
increasing S/N ratio
get almost uniform S/N ratio
increase bandwidth

⇒ Negative feedback is used in audio amplifiers to
operate class C
reduce distortion
increase distortion
increase gain

⇒ L [f(t - a)] = F(jω) e^-jωa
TRUE
FALSE

⇒ A time varying magnetic field produces
electric field only
magnetic field only
both magnetic and electric fields
none of the above

⇒ The filter in figure, uses ideal op-amp. I
low pass filter
high pass filter
band pass filter
band stop filter

⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
increases
decreases
remains constant
may increases or decreases

⇒ Electric dipole moment is usually expressed in debye units. Here, 1 debye unit equals
3.33 x 10^-30 C-m
3.33 x 10^-30 C-m²
3.30 x 10^-10 C-m
3.33 x 10^-10 C-m²

⇒ Which of following antenna does not depend upon the frequency?
Log-periodic
Parabolic
Conical
All of the above

⇒ The number of programmable 8 bit registers of 6800 are
2
3
4
5

⇒ SSB stands for
Single Side Band
Suppressed Side Band
Single Sound Band
Single Sky Band

⇒ The inductance of connecting leads can be a source of
low frequency parasitics
high frequency parasitics
carrier frequency parasitics
none of the above

⇒ A sequence detector is required to give a logical output of 1 whenever the sequence 1011 is detected in the incoming pulse stream. Minimum number of flip-flops needed to built the sequence detector is
4
3
1
2

⇒ To realize the full power of 8086 the pin of 8086 connected to ground is
DEN
ALE
INTR
MN / MX

⇒ A Hartley oscillator is used for generation
very low frequency oscillation
radio frequency oscillation
microwave oscillation
audio-frequency oscillation

⇒ The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.
TRUE
FALSE