Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Am equivalent 2's complement representation of the 2's complement number 1101 is |

A. | 110100 [Wrong Answer] |

B. | 1101 [Wrong Answer] |

C. | 110111 [Wrong Answer] |

D. | 111101 [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The disadvantage of FET over BJT is

poor high frequency performance

low power-handling ability

low values of voltage gain

all of the above

⇒ From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier

gain bandwidth product

slew rate

upper 3 dB frequency

lower 3 dB frequency

⇒ In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle a is

0 ≤ a ≤ p

θ ≤ a ≤ p

0 ≤ a ≤ (p - θ)

θ ≤ a ≤ (p + θ)

⇒ In decimal system the base of radix is

0

1

10

e

⇒ The operating voltage of a megger is about

100 V

12 V

6 V

1 V

⇒ Fourier analysis indicate that a square wave can be represented as

a fundamental sine wave and odd harmonics

a fundamental sine wave and even harmonics

a fundamental sine wave and harmonics

fundamental and subharmonic sine waves

⇒ Which one of the following blocks is not common in both AM and FM receivers?

RF amplifier

Mixer

IF amplifier

Slope detector

⇒ Consider the program segment written for 8085 based sys

41

69

44

Indeterminate

⇒ The amount of dielectric heating is inversely proportional to frequency.

TRUE

FALSE

⇒ The number of branches of root locus plot is equal to

the number of roots of characteristic equation

double the number of roots of characteristic equation

the number of roots of characteristic equation minus one

the number of roots of characteristic equation plus one

⇒ Feedback factor may be less or more than 1.

TRUE

FALSE

⇒ Consider the following rules in Fortran

- A signed or unsigned real variable name or a real constant is a real expression.
- Two real expressions connected by an arithmetic operator is a real expression.
- A real variable or constant exponential by an integer constant or integer variable is not valid

All

1 and 2 only

1 and 3 only

2 and 3 only

⇒ If the ladder reference voltage is 2 V, then minimum comparator resolution required is

0.125 V

1.25 V

12.5 V

0

⇒ Consider the following statements

- The amplitude of an FM wave is constant
- FM is more immune to noise than AM
- FM broadcasts operate in upper VHF and UHF frequency ranges
- FM transmitting and receiving equipments are simpler as compared to AM transmitting and receiving equipments

1, 2, 3, 4

1, 2, 3

2, 3, 4

1, 3, 4

⇒ An earth mat for a communication tower consists of

one or two radials extending from base of tower at a depth of about 5 cm below ground

a large number of radials extending from base of tower at a depth of about 3 m

a large number of radials extending from base of tower at a depth of about 30 cm

none of the above

⇒ The forbidden energy gap between the valence band and conduction band will be wide in case of

semiconductors

all metals

good conductors of electricity

insulators

⇒ Consider the following statements in amplitude modulation

- The harmonic and intermodulation distortion may occur in audio and RF amplifiers
- The sum and difference frequencies are present in the output of mixer
- The diode detector has audio frequencies in its output
- A balanced modulator cannot produce an AM with suppressed carrier

1, 2, 3, 4

1, 2, 3

1, 2

3, 4

⇒ What is the direction of control

Unidirectional into μ

*p*

Unidirection out of μ

*p*

Bidirectional

Mixed direction, i.e., some lines into μ

*p*an some others out of μ

*p*

⇒ Consider an arbitrary distribution of conducting bodies in a charge free space according to the uniqueness theorem, which of following are required to be specified in order that the field is uniquely determined everywhere?

- Total charge on each conductor
- Potential at each conductor surface
- Potential at same of conductor and total charge on the remainder
- Total charge as well as potential gradient on each conductor surface

1 and 3

2 and 4

1, 2, and 3

1, 2, 3, 4

⇒ Consider the following library functions

- EXP (
*i.e., e*^{x}) - ARCTAN (
*i.e.* tan^{-1} *x*) - SQRT (
*i.e., x*) - AES (
*i.e. *|*x*|) <

All

1 and 3 only

1, 3, 4 only

1, 2 and 3 only

⇒ T.V. antennas are usually

Yagi-Uda

loops

helical

parabolic

⇒ In a synchronous counter all flip flops are clocked together.

TRUE

FALSE

⇒ Three identical coils each having self inductance L are connected in series so that the fluxes of all the three are in the same direction. If mutual inductance between each pair of coils is M, the total inductance of the arrangement is

3 L + 9 M

1.5 L + 3 M

3 L + 3 M

3 L + 6 M

⇒ The capacitance of a capacitor is not affected by

area of plates

thickness of plates

∈_{r}

distance between plates

⇒ The selectivity of a radio receiver is

its ability to reject adjacent unwanted signals

its ability to amplify weak signals

the frequency at which it gives maximum amplification to signal.

its ability to suppress noise.

⇒ The units for intrinsic strength of dielectric are

kV

kV/m

A

A/m

⇒ Complex poles give rise to oscillatory terms in the response.

TRUE

FALSE

⇒ The effect of a finite gain of operational amplifier used in an integrator is that

it would not integrator

slope of the O/P will varied with time

final value of the O/P

there will be instability in the cirucuit

⇒ The gain of an antenna with a circular aperture of diameter 3 metres at a frequency of 5 GHz, will be

2.4674

24.674

246.74

24674

⇒ When three 100 K, ± 10% fixed resistors of 1/4 W Power rating are connected in parallel, the resulting 33 K resistor will have a tolerance specification and power rating of

± 10% and 3/4 W respectively

± 10% and 1/12 W respectively

± 3.3.% and 3/4 W respectively

± 30% and 3/4 W respectively

```
```

```
```

```
```

```
```