Question is ⇒ AECF116 + 15ACD16 = __________ ., Options are ⇒ (A) C47BB16, (B) C47BE16, (C) A234F16, (D) A111116, (E) , Leave your comments or Download question paper.

Question is ⇒ AECF116 + 15ACD16 = __________ ., Options are ⇒ (A) C47BB16, (B) C47BE16, (C) A234F16, (D) A111116, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	AECF1₁₆ + 15ACD₁₆ = __________ .
A.	C47BB₁₆ [Wrong Answer]
B.	C47BE₁₆ [Correct Answer]
C.	A234F₁₆ [Wrong Answer]
D.	A1111₁₆ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 4 cm by 3 cm rectangular waveguide with air cavity, is operating at 12 GHz with TE₁₁ mode. The cut-off frequency is:
6.25 GHz
4.75 GHz
1.5 GHz
8.75 GHz

⇒

Match the following:

	List I		List II
A.	Darlington amplifier	1.	A circuit using pnp and npn transistors
B.	CB amplifier	2.	A CS amplifier driving a CG amplifier
C.	Cascade amplifier	3.	A circuit with over-all voltage gain close to 1 and very large input impedance
D.	Complementary symmetry amplifier	4.	A circuit with low input impedance

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1

⇒

Match the following:

	List I		List II
A.	Sky wave	1.	parasitic elements
B.	Antenna feed	2.	delta match
C.	Reflector	3.	long-wire antenna
D.	Rhombic antenna	4.	ionosphere

A-1, B-3, C-4, D-2
A-2, B-1, C-3, D-4
A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3

⇒ The effective length of antenna is different from actual length due to
top loading
end effects
both (a) and (b)
none of the above

⇒ In radar PRF depends on maximum range.
TRUE
FALSE

⇒ Two resistance R₁ and R₂ are connected in series R₁ = 528 ± 5 Ω and R₂ = 325 ± 3Ω. The total resistance will be
853 ± 2 Ω
853 ± 5 Ω
853 ± 3 Ω
853 ± 8 Ω

⇒ The minimum sampling frequency in sample/sec. required to reconstruct the following signal from its samples wuthout distor
2 x 10³
4 x 10³
6 x 10³
8 x 10³

⇒ In a coupled coil the primary has 100 turns and secondary has 200 turns. The primary produces, a flux Φ = e^-t. The coefficient of coupling is 1. The voltages induced in secondary is
200 e^-t V
200 e^t V
200 V
none of the above

⇒ The transfer function of a controller is given as K_p + K_d.s where K_p and K_d are constants. What type of controller is this?
Proportional
Proportional plus integral
Proportional plus derivative
Integral plus derivative

⇒ Which control action is also called rate control?
Proportional
Derivative
Integral
Proportional plus integral

⇒ An FM signal has modulating frequency f_m and maximum frequency deviation of δ. The bandwidth will be nearly equal to
δ
2 δ
2f_m δ
f_m δ

⇒ Which of the following is a valid logical expression in Pascal?
2.5 : = A
(A + B) < < (C + D)
A = = B

⇒ The time needed by a TTL circuit to switch from 0 to 1 or 1 to 0 is about
10 μs
10 ns
100 μs
50 ns

⇒ The operations which occur most frequently in a computer are
fetch
execute
both (a) and (b)
none of the above

⇒ A 0-150 voltmeter has a guaranteed accuracy of 1% of full scale reading. If actual reading is 83 V, the percentage error is
0.0083
0.01
0.0181
none of the above

⇒ In the circuit of figure the d
will conduct as the whole cycle
will conduct in the positive half cycle
will not conduct
will conduct from 30° to 150° in the positive half cycle

⇒ Read the following statements

The circuitry of ripple counter is more complex than that of synchronous counter.
The maximum frequency of operation of ripple counter depends on the modulus of the counter.
The maximum frequency of operation of synchronous counter does not depend on the modulus of the counter.

Which of the above statements are correct?
1 only
1, 2
1, 2, 3
2, 3

⇒ The early effect in a BJT is caused by
fast turn on
fast turn off
large collector base reverse bias
large emitter base forward bias

⇒ The amplifier used in miller voltage sweep should have a gain of
-∞
1
+∞
-1

⇒ 11101₂ x 10001₂ =
111101101
111101100
11110
1100110

⇒ In figure, I_D = 4 mA. Then V_{DS20 V
16 V
4 V
0.4 V}

⇒ In sign magnitude numbers,
the leading bit stands for the sign
the leading bit is part of the magnitude
the leading bit is always 0
the leading bit is always 1

⇒ High cut off frequency can be expected in case of
common-base
common-emitter
common-collector
all of the above

⇒ If V_a1 = V_a2 = 100 V and V_a0 = 0, then V_a, V_b, V_c are
200, -100 and -100 V
100, 100, 300 V
200, 100, 100 V
100, -100, 100 V

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ Consider the following statements for 8085

The most significant 8 bits of address are transmitted on the 8 lines on which data is transmitted.
Eight pins are dedicated to transmit the most significant 8 bits of memory address.
The least significant 8 bits of address are transmitted on the lines on which data is transmitted.
The data and leass significant 8 bits are transmitted at different points in time.

Which of the above statements are correct?
all
1, 2 and 3 only
2, 3 and 4 only
1, 3 and 4 only

⇒ When a power diode is conducting, the voltage drop across it is about
I V
5 V
20 V
50 V

⇒ Given a power supply filter circuit, what measurements must be made of determine percentage regulation
current through and voltage across the capacitor
d.c. load voltage and r.m.s. load voltage
current through load and voltage across load resistance
number of turns and gauge of secondary winding of transformer

⇒ If the diameter of a wire is doubled, its current carrying capacity becomes
one-fourth
half
twice
four times

⇒ In a picture tube, the video signal is applied to
cathode
grid
any anode
either cathode or grid