Question is ⇒ Acoustic strain gauges, Options are ⇒ (A) have good linearity of measurement, (B) do not have long term stability, (C) have a large range of measurement, (D) have an accuracy range of 0.1-1% depending on environment, (E) , Leave your comments or Download question paper.

Question is ⇒ Acoustic strain gauges, Options are ⇒ (A) have good linearity of measurement, (B) do not have long term stability, (C) have a large range of measurement, (D) have an accuracy range of 0.1-1% depending on environment, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Acoustic strain gauges
A.	have good linearity of measurement [Wrong Answer]
B.	do not have long term stability [Wrong Answer]
C.	have a large range of measurement [Wrong Answer]
D.	have an accuracy range of 0.1-1% depending on environment [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Hexadecimal number E is equal to binary number
1110
1101
1001
1111

⇒ In the following non planar graph number of independent loop equations
8
12
7
5

⇒ A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,
8
6
5
7

⇒ Baudot code is a six bit code.
TRUE
FALSE

⇒

Assertion (A): When excited by a unit step voltage, an inductor behaves as open circuit at t = 0.

Reason (R): Inductance has the property of inertia.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I		List II
A.	p type semiconductor	1.	silicon
B.	n type semiconductor	2.	holes are majority carriers
C.	Intrinsic semiconductor	3.	electrons are majority carriers
D.	Tungsten	4.	is a metal

A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-1, C-2, D-4

⇒ The maximum range of a radar is proportional to
square root of peak transmitted pulse power
fourth root of peak transmitted pulse power
peak transmitted pulse power
none of the above

⇒ Energy content of atmospheric noise
does not depend on frequency
decreases as frequency is increased
increases as frequency is increased
either (a) or (c) depending on the temperature

⇒ The current passing through a resistance of 100 ± 0.2% Ω is 2 ± 0.5% A. The limiting error in computation of power will be
± 0.7%
± 0.9%
± 1.2%
± 0.3%

⇒ For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is
sin^-1 ξ
cos^-1 ξ
tan^-1 ξ
cot^-1 ξ

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ For formation of state equations, resistance of the circuit
should be in tree
should be in cotree
may be in tree or cotree
none of the above

⇒ A network N is dual of network N if
both of them have same mesh equation
both of them have same node equation
mesh equation of one are the node equations of the other
KCL and KVL equations are the same

⇒ In a class C power amplifier
resonant frequency of tuned circuit is equal to fundamental frequency of pulsed waveform
resonant frequency of tuned circuit is half the fundamental frequency of pulsed waveform
resonant frequency of tuned circuit has no relation to the fundamental frequency of pulsed waveform
either (b) or (c)

⇒ A CMOS amplifier when compared to an N-channel. MOSFET, has the advantage of
higher cut off frequency
higher voltage gain
higher current gain
lower current drain from the power supply, there by less dissipation

⇒ Which amplifier will be preferred for highest gain?
Darlington's pair
Single stage amplifier
Cascade amplifier
Depends on the circuitry

⇒ To plot frequency spectrum we draw two graphs viz |F_n| versus frequency and φ_n versus frequency.
TRUE
FALSE

⇒ A TV receiver has 20 kV EHT supply and total beam current (for 3 electron guns) of 1500 μA. The power handled by IHVT is
3 W
30 W
300 W
0.3 W

⇒ 8 bit data can have 256 numbers ranging from 00000000 to 111 111 11.
TRUE
FALSE

⇒ Heat in calories = I²Rt/4.186.
TRUE
FALSE

⇒ The collector voltage V_C of the circuit shown in the given figure aside is approxima
2 V
4.6 V
8 V
8.6 V

⇒ A quantization error is an essential aspect of ADC
TRUE
FALSE

⇒ Which of the following theorems can be conveniently used to find power consumed in 10 Ω resistor in fig
Thevenin theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ In a multicavity klystron amplifier the signal to be amplified develops an ac voltage of signal frequency across the gap in buncher cavity
TRUE
FALSE

⇒ A modem is
a form of commutator
a device for digitizing speech
a circuit used for suppressing microwave mterference
an electronic circuit which carries out modulation and demodulation of a carrier frequency

⇒ A seven bit (even parity) code 0010001 may have error. The correct code is
10001
1110001
11001
1111110

⇒ Some multiplexing arrangements for telephone system are

Space multiplexing
Time division multiplexing
Frequency division multiplexing

Which of the above allow transmission of many independent signals over a single channel?
1 only
2 and 3 only
1, 2, 3
1 and 3 only

⇒ The phenomenon of creep occurs in
energy meters
voltmeters
ammeters
wattmeters

⇒ Which of the following circuit would be preferred for a 355 KHz IF amplifier?
Resistance loaded
Double tuned transformer
Video amplifier
Class C