Question is ⇒ Accurate amplitude measurements can be made more easily than accurate phase shift measurements., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Accurate amplitude measurements can be made more easily than accurate phase shift measurements., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Accurate amplitude measurements can be made more easily than accurate phase shift measurements.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The gap width in audio heads is about 0.01 mm.
TRUE
FALSE

⇒ Consider the following statements

The sign of a floating point number depends on the sign of mantissa only.
If the absolute value of a number is less than 1, the sign of exponent is zero or positive.
With sign bit of mantissa as 0, increasing the exponent from a positive to a more positive value gives a larger floating point number.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are
0101 and 5
0101 and 10
1010 and 5
1010 and 10

⇒ In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
class A
class B
class C
class AB

⇒ A 10 GHz signal propagates in a waveguide with a phase velocity of 4 x 10⁸ m/s. If the signal produces standing wave in the guide, then the distance between successive minimal will be
10 mm
20 mm
30 mm
40 mm

⇒ The no. of comparators required in a 3 bit comparator type ADC is
2
3
7
8

⇒ The time needed by a TTL circuit to switch from 0 to 1 or 1 to 0 is about
10 μs
10 ns
100 μs
50 ns

⇒ For a symmetrical network
h₁₁ = h₂₂
h₁₂ = h₂₁
h₁₁ h₂₂ - h₁₂ h₂₁ = 0
h₁₁ h₂₂ - h₁₂ h₂₁ = 1

⇒ In which of the following semiconductor are holes minority carriers
extrinsic
p type
n type
intrinsic

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the deviation is
4.77 kHz
47.7 kHz
477 kHz
4770 kHz

⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 1 GHz is about
100°
50°
5°
2°

⇒ Transistor T₁ operates at 30 kHz and T₂ operates at 300 Hz. The flicker noise is
not depend on frequency
T₁ > T₂
T₁ = T₂
T₁ < T₂

⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors

⇒ The transistor specification number 2N refers to
triac
diac
junction transistor
FET with one gate

⇒ An audio signal is to be transmitted digitally. Which is the system best suited for good fidelity?
8 bit PCM
13 bit PCM
32 bit PCM
PCM system with non-uniform quantizer

⇒ An oscilloscope has an input impedance consisting of 1 MΩ and 20 pF is parallel. A high impedance probe connected to input of this oscilloscope has a 10 MΩ series resistance. This 10 MΩ series resistance
may not be shunted
should be shunted by 2 pF capacitor
should be shunted by 20 pF capacitor
should be shunted by 200 pF capacitor

⇒ SHF range is
30 - 300 MHz
300 - 3000 MHz
3000 - 30000 MHz
30000 - 300000 MHz

⇒ Which variety of copper has the best conductivity?
Pure annealed copper
Hard drawn copper
Induction hardened copper
Copper containing traces of silicon

⇒ Number of cards read per minute by a card reader may be of the order of
20
1
10000
300

⇒ The static characteristic of an adequately forward biased p-n junction is a straight line if the plot is of
log I vs log V
log I vs V
I vs log V
I vs V

⇒ In the circuit of figure the voltage across C at t = 0^{+0 V
20 V
very large
7.5 V}

⇒ In a ripple counter,
whenever a flip flop sets to 1, the next higher FF toggles
whenever a flip flop sets to 0, the next higher FF remains unchanged
whenever a flip flop sets to 1, the next higher FF faces race condition
whenever a flip flop sets to 0, the next higher FF faces race condition

⇒ A trigonometric function is synonyms to
orthogonal function
triangular function
singular function
none of the above

⇒ 10's complement of 16₁₀ is
83₁₀
84₁₀
38₁₀
48₁₀

⇒ An FM transmitter has maximum frequency deviation of 75 kHz and reproduces audio signals up to 15 kHz. Minimum channel width required is __________ kHz.
180
120
90
60

⇒ Strength of space wave is not dependent on distance.
TRUE
FALSE

⇒ Radar reciever has high sensitivity and low noise figure
TRUE
FALSE

⇒ Which of the following is decimal equivalent of the binary 1111111?
27
87
127
167

⇒ The range of memory location in given memory interfacing scheme
0000H - 07FFH
F800H - FFFFH
0000H - 03FFH
0000H - 3FFFH

⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be
out of phase by 90°
in phase
out of phase by 45°
out of phase 180°