Question is ⇒ According to maximum power transfer theorem, if the load is inductive, the source should be, Options are ⇒ (A) inductive, (B) capacitive, (C) resistive, (D) any of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ According to maximum power transfer theorem, if the load is inductive, the source should be, Options are ⇒ (A) inductive, (B) capacitive, (C) resistive, (D) any of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	According to maximum power transfer theorem, if the load is inductive, the source should be
A.	inductive [Wrong Answer]
B.	capacitive [Correct Answer]
C.	resistive [Wrong Answer]
D.	any of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When slider of the potentiometer AB is in the position shown in figure, what resistance reading would be indicated by an ohmmeter connected between A an
zero
infinite
can't say
none of the above

⇒ MOSFET can be used as a
current controlled capacitor
voltage controlled capacitor
current controlled inductor
voltage controlled inductor

⇒

Assertion (A): The speed of a shaft can be measured by using a dc tacho generator.

Reason (R): A two phase servometer can also be used as a speed transducer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ For a superconductor, the relative permeability is
zero
high
low
either low or high

⇒ The O/P Power of a power amplifier is several times its input power. It is possible because
power amplifier introduces a -ve resistance
there is +ve feed back in the circuit
step up transformer is use in the circuit
power amplifier converts a part of I/P d.c. power into a.c. power

⇒ Sulphur hexafluoride is used in
transformers
generators
relays
circuit breakers

⇒ 1274₁₆ - 3A7₁₆ = __________ .
ACA₁₆
ACB₁₆
ECD₁₆
AAA₁₆

⇒ Consider the resonant circuit as shown b
R = 10⁴ L = 5 μH C = 20 pF
1000 L = 50 μH C = 200 pF
10 K L = 50 μH C =20 pF
None of these

⇒ Which of the following statement is false?
Television signals are propagated as ground waves
Surface waves can propagate on piezoelectric substrates
The skip distance is the maximum distance upto which ionospheric reflection is possible
Tropospheric scatter propagation is always subjects to fading

⇒

Match the following:

	List I		List II
A.	SSB Modulation	1.	Transmission line
B.	Δ . B = 0	2.	Hilbert transform
C.	Model dispersion	3.	Faraday's law
		4.	Absence of magnetic monopoles
		5.	Waveguides
		6.	Phase locked loop

A-1, B-3, C-5
A-5, B-4, C-2
A-6, B-4, C-5
A-2, B-4, C-5

⇒ A black box has one of the elements our of R, L, C. when a 220 V a supply is connected the current supplied by source is I. when a 0.1 F capacitor is connected in parallel with the box, the current is 2I. The element is
resistance
inductance
0.1 F capacitance
not identifiable on the basis of given data

⇒ The dual of a loop is
twig
node pan
mesh
tree

⇒ Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.
TRUE
FALSE

⇒ Inductors used at V.H.F. are made using
air core
cast iron cored
sheet steel cored
thin film technique

⇒ The transmitting antennas for lower frequencies (below 500 kHz) are generally
vertical grounded wire type
horizontal suspended wire type
parabolic reflector type
any of the above

⇒ In a P type silicon sample, the hole concentration is 2.25 x 10¹⁵ / cm³. If the intrinsic carrier concentration is 1.5 x 10¹⁰/ cm³ the electron concentration is
zero
10¹⁰/cm³
10⁵/cm³
1.5 x 10²⁵/cm³

⇒ A system has high gain and phase margin. The system is
very stable
sluggish
very stable and sluggish
oscillatory

⇒ If air pressure in a rectangular waveguide is increased the maximum power handling capacity
is decreased
is increased
remains the same
may increase or decrease depending on pressure

⇒ AGC voltage is applied to the stages which are
before the detector stage
after the detector stage
either before or after the detector stage
none of the above

⇒ In figure, the current I_{410 ∠0
5 ∠90°
5 ∠270°
10 ∠90°}

⇒ In a CE amplifier the ac signal is increased. Which of the following will not change?
Ac base voltage
Ac collector voltage
Ac emitter voltage
Ac collector voltage and ac emitter voltage

⇒ Depending on the technique used, digitized television requires a bit rate between __________ millions.
40 and 92.5
25 and 60
30 and 82.5
2

⇒ The main advantage of TDM over FDM is
TDM requires more bandwidth than FDM
less complicated in hardware than FDM
better SNR
required filter

⇒ Which of these has lowest dielectric strength?
Dry air
Wet air
Cotton
Paper

⇒

Assertion (A): In p type semiconductor conduction is mainly due to holes.

Reason (R): In p type material the holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω²T²)
-20 log (1 + ω²T²)

⇒ A LASCR has
4 semiconductor layers and 3 junctions
3 semiconductor layers and 2 junctions
2 semiconductor layers and 2 junctions
any of these depending on the rating

⇒ Which of the following directives in 8085 causes one byte to be reserved in the memory?
D S
D B
D W
E Q U

⇒ The modulation index is, if f_m = 500 Hz, Δf = 2.25 kHz
2.25
4.5
9
18

⇒ Three point tracking is achieved with
double conversion
padder capacitor
double spotting
variable selectivity