Question is ⇒ A Wien bridge oscillator uses, Options are ⇒ (A) negative feedback, (B) positive feedback, (C) both negative and positive feedback, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A Wien bridge oscillator uses, Options are ⇒ (A) negative feedback, (B) positive feedback, (C) both negative and positive feedback, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A Wien bridge oscillator uses
A.	negative feedback [Wrong Answer]
B.	positive feedback [Wrong Answer]
C.	both negative and positive feedback [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In RAM, all the information can be obtained at the output with
minimum time delay
unequal time delay
nearly identical time delay
maximum time delay

⇒ For representing two sinusoidal voltages on a phasor diagram
Both voltages must be of the same frequency
Both voltages must be sinusoidal but may be of different frequencies
One of the voltages must be of 50 Hz
The frequency of one must be integral of that of other

⇒ Effective address is calculated by adding or subtracting displacement value to
immediate address
Relative address
absolute address
base address

⇒ In a shift left register, shifting a bit by one bit means
division by 2
multiplication by 2
subtraction of 2
None of the above

⇒ If ωε is the displacement current factor and s is conduction current density factor then which of the following statements is incorrect?
For a lossless dielectric σ = 0
For an imperfect dielectric σ = 0
For a dielectric ωε >> σ
For a semiconductor ωε = σ

⇒ The polarization phenomena in Faraday rotation
is non-reciprocal
exists along perpendicular direction
exists along the axis of array
does not exist

⇒ The amount of photoelectric emission current depends on the frequency of incident light.
TRUE
FALSE

⇒ 8255 A is a
programmable peripheral interface
I/O device
memory chip
none of the above

⇒ Which one of the following circuits is most suitable as an oscillator at a frequency of 100Hz?
Hartley oscillator
Colpitts oscillator
Crystal oscillator
Twin-T oscillator

⇒ Which of the following statement is incorrect?
Curl of vector potential is magnetic field density
Electric charges in motion produce magnetic field
Electric charges at rest produce electrostatic field
None of the above

⇒ In an FM signal, the power
increases as the modulation index increases
reduces as the modulation index increase
increases as the modulation index decreases
remains constant when the modulation index increases

⇒ "Micro-program" is
the name of the source program in microcomputer
the set of instructions indicating the primitive operations in 1 system
the general name of 'MACRO's' in assembly language programming
the name of programs of very small size

⇒ Out of Metal-film type and Carbon-film type, the one with better tolerance specification is
carbon-film
metal-film type
both have same tolerance
none of these

⇒ Which of the following is true?
During addition if the carry into and carry out of the sign bit do not match then an overflow has occurred
During addition if the carry into and carry out of the sign bit don't match then an overflow or underflow has occurred
During addition if the carry into and carry out of the sign bit match then an overflow or underflow has occurred
During addition if the carry into and carry out of the sign bit match then an overflow has occurred

⇒ Pre-emphasis circuit is used
after modulation
before modulation
before detection
after detection

⇒ Which of the following are the non-linear application of op-amp?

Current-to-voltage converter
Comparator
Peak detector
Limiter

Select the correct answer from the codes given below:
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4

⇒ A person with a receiver is 5 km away from the transmitter. What is the distance that this person must move further to detect at 3 dB decrease in signal strength?
942 m
2070 m
4978 m
5320 m

⇒ If there is phase error in the carrier signal for the detection of SSB signals, then
the output gets reduced, but a phase distortion results
the output is not reduced, but a phase distortion results
the output is not reduced, and also no distortion
the output is reduced, no phase distortion

⇒ Three Mod-16 counters are connected in cascade. The maximum counting range is
16
256
4096
none of the above

⇒ It is required to increase the maximum range of a radar by a factor of two. The peak power transmitted in the radar system has to be increased by a factor of
2
4
8
16

⇒ Shannon's Law relates
antenna gain to frequency
noise power to bandwidth
information-carrying capacity to S/N ratio
transmission losses to noise

⇒ In an n type semiconductor the fermi level is 0.35 eV below the conduction band, the concentration of donor atoms is increased to three times. The new position of Fermi level will be
0.35 eV below conduction band
about 0.32 eV below conduction band
about 0.32 eV above conduction band
about 0.1 eV below conduction band

⇒

Match the following:

	List I		List II
A.	Very low response at very high frequencies	1.	Low-pass system
B.	Over shoot	2.	Velocity damping
C.	Synchro-control transformer output	3.	Natural frequency
		4.	Phase-sensitive modulation
		5.	Damping ratio

A-1, B-5, C-4
A-3, B-2, C-4
A-2, B-5, C-4
A-4, B-1, C-3

⇒ Four inputs A, B, C, D are fed to a NOR gate. The output of NOR gate is fed to an inverter. The output of inverter is
A + B + C + D
A + B + C + D
ABCD
ABCD

⇒

Assertion (A): A two byte instruction of 8085 has an operation code in first byte and operand / address in the second byte.

Reason (R): If an instruction is too long it is possible to reduce its length by a number of methods.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Consider the following circuits. Assume all gates to have finite propagation d
(1) only
(1) and (2) only
(2) (3) and (4) only
All (1) (2) (3) and (4)

⇒ A Schottky diode clamp is used along with switching BJT for
reducing the power dissipation
reducing the switching time
increasing the value of β
reducing the base current

⇒

Assertion (A): Magnetism can be explained by the theory of magnetic domains.

Reason (R): The existence of magnetic domains is evident from the Bitter powder patterns.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The forbidden energy gap between the valence band and conduction band will be wide in case of
semiconductors
all metals
good conductors of electricity
insulators

⇒ A Weinbridge oscillator is a
VHF oscillator
RF oscillator
microwave oscillator
audio frequency oscillator