Question is ⇒ A voltage of about 200 V dc can be measured, Options are ⇒ (A) directly by dc potentiometer, (B) by dc potentiometer in conjunction with a volt ratio box, (C) a dc potentiometer in conjunction with a known resistance, (D) both (b) and (c), (E) , Leave your comments or Download question paper.

Question is ⇒ A voltage of about 200 V dc can be measured, Options are ⇒ (A) directly by dc potentiometer, (B) by dc potentiometer in conjunction with a volt ratio box, (C) a dc potentiometer in conjunction with a known resistance, (D) both (b) and (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A voltage of about 200 V dc can be measured
A.	directly by dc potentiometer [Wrong Answer]
B.	by dc potentiometer in conjunction with a volt ratio box [Correct Answer]
C.	a dc potentiometer in conjunction with a known resistance [Wrong Answer]
D.	both (b) and (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In order to enable TRAP interrupt, which of the following instructions are needed?
El only
SIM only
El and SIM both
None

⇒

Assertion (A): The amount of photoelectric emission depends on the intensity of incident light.

Reason (R): Photo electric emission can occur only if frequency of incident light is less than threshold frequency.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The oscillator shown in figure
Clapp oscillator
R-C Phase shift oscillator
Hartley oscillator
Colpitt's oscillator

⇒ Super high frequency means more than 3000 MHz.
TRUE
FALSE

⇒ In a bipolar transistor, the emitter base junction has
forward bias
reverse bias
zero bias
zero or reverse bias

⇒ Which of the following is the point of reference JFET?
Drain
Gate
Source
None of the above

⇒ A rectangular metal waveguide filled with a dielectric of relative permittivity ε_r = 4, has the inside dimensions 3 x 1.2 cm, the cut off frequency for the dominant mode is
2.5 GHz
5 GHz
10 GHz
12.5 GHz

⇒ 'Rotate instruction' in microprocessor belongs to
data transfer group
arithmetic group
logic group
branch group

⇒ Radar antennas are
dipoles
helical
parabolic
conical

⇒ A parallel ac circuit in resonance will
act like a resistor of low value
have a high impedance
have current in each section equal to the line current
have a high voltage developed across each inductive and capacitive section

⇒ Consider the following applications/ advantages of radar beacons

navigation
target identification
accurate tracking of enemy targets
large increase in maximum range

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2
2, 3, 4

⇒ In given figure a silicon diode is carrying a constant current of 1 mA. When the temperature of the diode is 20°C, V_D is found to be 700 mV. If the temperature rises to 40°C, V_D becomes approximately equa
747 mV
660 mV
680 mV
700 mV

⇒ Both X and Y plates of a CRO are excited by ac signals. The display is an ellipse which makes one rotation in 5 seconds. This means that
the frequency of one input is 5 times that of other
the difference between the frequencies of the two signals is one fifth of hertz
the difference between the frequencies of the two signals is 5 Hz
either (a) or (c)

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
the faster the AGC time constant, the more accurate the output
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC

⇒ If μ_n is mobility of free electron and μ_p is mobility of holes then for silicon at 300 K
μ_n = μ_p
μ_n > μ_p
μ_n < μ_p
μ_n may be more or less than μ_p

⇒ A 3 bit binary adder can add
2 bits
2 bits
3 bits
8 bits

⇒ Fidelity of a receiver represents
the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output
the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies
the variation of the output with the modulation frequency when the output impedance is a resistance
none of the above

⇒

Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The total number of pins in 8085 are
20
30
40
50

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒

Assertion (A): In p-n-p transistor collector current is termed negative.

Reason (R): In p-n-p transistor holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is used in integrated circuits?
Microstrip line
Coaxial line
Twin wire line
Shield cable

⇒ If A = B = 1, the outputs P and Q in the given figure
P = Q = 0
P = 0, Q = 1
P = 1, Q = 0
P = Q = 1

⇒ An RLC series circuit is excited by a step voltage E. The units of roots of characteristic equation are
seconds
1/seconds
tesla
henry

⇒ The gap width in audio heads is about 0.01 mm.
TRUE
FALSE

⇒ The clock shown in figure has a frequency of 6 MHz. The frequency of the Q output wil
12 MHz
24 MHz
3 MHz
1.5 MHz

⇒ The value of the inductance of coil in which a current increases linearly from zero to 0.1A in 0.2 second producing a voltage of 5 volts is __________ .
2.5
5
10
20

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ Cassergain feed is used with a parabolic reflector to
increase the gain of the system
increase the beamwidth of the system
reduce the size of the main reflector
allow the feed to be placed at a convenient point

⇒ The operations which occur most frequently in a computer are
fetch
execute
both (a) and (b)
none of the above