Question is ⇒ A voltage of 9 V is applied in forward direction to a semiconductor diode in series with a load resistance of 1000 Ω. The voltage across the load resistance is zero. It indicates that, Options are ⇒ (A) diode is short circuited, (B) diode is open circuited, (C) resistor is open circuited, (D) diode is either o.c or s.c, (E) , Leave your comments or Download question paper.

Question is ⇒ A voltage of 9 V is applied in forward direction to a semiconductor diode in series with a load resistance of 1000 Ω. The voltage across the load resistance is zero. It indicates that, Options are ⇒ (A) diode is short circuited, (B) diode is open circuited, (C) resistor is open circuited, (D) diode is either o.c or s.c, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A voltage of 9 V is applied in forward direction to a semiconductor diode in series with a load resistance of 1000 Ω. The voltage across the load resistance is zero. It indicates that
A.	diode is short circuited [Wrong Answer]
B.	diode is open circuited [Correct Answer]
C.	resistor is open circuited [Wrong Answer]
D.	diode is either o.c or s.c [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The logic circuit given below converts a binary code y₁ y₂, y₃
Excess - 3 code
Gray code
BCD code
Hamming

⇒ For attenuation of low frequencies we should use
shunt capacitance
series capacitance
shunt inductance
series inductance

⇒

Assertion (A): A class C amplifier can also be used as frequency multiplier

Reason (R): When narrow current pulses drive a resonant circuit the output can be a near perfect sine wave

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the half power beamwidth
4°
2°
10°
15°

⇒ A bit synchronizer regenerates at the receiver a clock waveform which is
synchronous with original clock waveform
out of phase by 180° with original clock waveform
out of phase by 90° with the original clock waveform
none of the above

⇒ The ratio of active power to apparent power is known as __________ factor.
power
load
form
demand

⇒ In a circuit using a full wave converter (M - 2 connection) the PIV of each thyristor is 400 V. For the same output voltage and fully controlled bridge converter, PIV will be
400 V
800 V
200 V
2002 V

⇒

Assertion (A): The 'do while' statement is used less frequently than the 'while' statement.

Reason (R): For most applications it is more natural to test for continuation of loop at the beginning than at the end of loop.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): For most metals, Fermi energy E_F is less than 10 eV.

Reason (R): Fermi level of a metal is given by E_F = 3.64 x 10^-19 (n)^2/3 where n is number of free electrons/m³ of metal.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ 268₁₀ = __________ .
10A₁₆
10B₁₆
10C₁₆
10D₁₆

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ The response of a thermistor overs the whole of its temperatures range is
linear
non-linear
almost linear
either (a) or (c)

⇒ A transistor amplifier has pole
s₁
s₁ + s₂ + s₃ + s₄
s₁ + s₄
s₄

⇒ A circular polarizer converts a linearly polarized wave into a circularly polarised wave.
TRUE
FALSE

⇒ Which connection is rarely used?
CE
CB
CC
Both (a) and (b)

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒ For a system to work, as oscillator the total phase shift of the loop gain must be equal to
90°
45°
270°
360°

⇒ When satellite radio beam is aimed towards earth, it illuminates on the earth for an oval shaped area called
foot print
beam area
satellite service area
radiated area

⇒ In a low level amplitude modulated system, the amplifier modulated stage must be
class C
linear
non linear
harmonic

⇒ The addition of a zero to the open loop transfer function
pulls the root locus to the left and makes the system more stable
pulls the root locus to the right and makes the system less stable
either (a) or (b)
neither (a) nor (b)

⇒ In a reactance function
all poles are simple
all poles and zeros are simple
all poles and zeros are simple and lie on jω axis only
all poles and zeros lie on negative real axis

⇒ The impulse response h[n] of a linear time invariant system is give
42 e^jpn/4
42 e^{- jpn/4}
4e^pn/4
-4e^pn/4

⇒ If D is diameter of circular waveguide the cutoff wave-length for TE₁₁ mode is equal to
1.706 D
2.11 D
0.82 D
0.41 D

⇒ If it is desired to have low output impedance in an amplifier circuit then we should use
common collector circuit
common base circuit
common emitter circuit
either (b) or (c)

⇒ A radio wave is incident on a layer of ionosphere at an angle of 30° with the vertical. If the critical frequency is, 1.2 MHz, the maximum usable frequency is
1.2 MHz
2.4 MHz
0.6 MHz
1.386 MHz

⇒ Which of the following is correct?
Voltages across a capacitance can change instantaneously
Voltages across a capacitance cannot change instantaneously
Charge across a capacitance is always constant
Charge across a capacitance can change instantaneously

⇒ In a crystal
the frequencies of series and parallel resonance are equal
the frequency of series resonance is more than frequency of parallel resonance
the frequency of parallel resonance is more than frequency of series resonance
None of the above

⇒ Equation x_l0 = 11001001₂ when solved for x gives the value of x as
8
111
152
201

⇒ To ensure that a zener diode does not get destroyed
the applied voltage should not exceed breakdown voltage
the current should not exceed rated current
the current should be less than magnitude of barrier potential
both (a) and (b)

⇒ The quality of a space-link is measured in terms of the __________ ratio.
C/N
S/N
G/T
EIRP