Question is ⇒ A voltage v = 100 sin ωt + 10 sin 5 ωt is applied to a pure capacitor having capacitance of 1 μF. If ω = 314 rad/sec, the current through the capacitor is, Options are ⇒ (A) 0.0314 cos 314 t + 0.0157 cos 1570 t, (B) 0.0314 sin 314 t + 0.0157 sin 1570 t, (C) 0.0314 cos 314 t + 0.0314 cos 1570 t, (D) 0.0157 cos 314 t + 0.0157 cos 1570 t, (E) , Leave your comments or Download question paper.

Question is ⇒ A voltage v = 100 sin ωt + 10 sin 5 ωt is applied to a pure capacitor having capacitance of 1 μF. If ω = 314 rad/sec, the current through the capacitor is, Options are ⇒ (A) 0.0314 cos 314 t + 0.0157 cos 1570 t, (B) 0.0314 sin 314 t + 0.0157 sin 1570 t, (C) 0.0314 cos 314 t + 0.0314 cos 1570 t, (D) 0.0157 cos 314 t + 0.0157 cos 1570 t, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A voltage v = 100 sin ωt + 10 sin 5 ωt is applied to a pure capacitor having capacitance of 1 μF. If ω = 314 rad/sec, the current through the capacitor is
A.	0.0314 cos 314 t + 0.0157 cos 1570 t [Correct Answer]
B.	0.0314 sin 314 t + 0.0157 sin 1570 t [Wrong Answer]
C.	0.0314 cos 314 t + 0.0314 cos 1570 t [Wrong Answer]
D.	0.0157 cos 314 t + 0.0157 cos 1570 t [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is
21 kHz
22 kHz
42 kHz
44 kHz

⇒ Two sinusoidal signals of equal amplitude and frequency are applied to X and Y plate of CRO respectively. The observed Lissajous pattern is a straight line. The phase shift between signals is
zero
90°
either zero or 180°
either 90° or 270°

⇒ Which of the following circuits come under the class of combinational logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 only
3 and 4
4 and 5
1, 2 and 3

⇒ In the transformer shown in the figure, the inductance measured across the terminal 1 and 2 was 4 H with open terminals 3 and 4. It was 3H when the terminals 3 and 4 were short circuited. The coefficient of coupling woul
1
0.707
0.5
indetermine due to insufficient data

⇒ Which of the following codes is based on BCD format?
EBCDIC
ASCII
Hollerith
both (a) and (b)

⇒ The depletion layer across a P⁺ n junction lies
mostly in the P⁺ region
mostly in n region
equally in both the P⁺ and n-region
entirely in the P⁺ region

⇒ The instruction MVI A, 20 in 8085 means
contents of memory location 20 are brought into the accumulator
the value 20 is brought into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ The characteristic equation of flip-flop gives the next state Q_{N + 1} in terms of present state Q_N and the inputs. Which one of the following is the characteristic equation of J - K flip-flop?
Q_N+1 = JQ_N + KQ_N
Q_N+1 = J + KQ_N
Q_N+1 = KQ_N + JQ_N
Q_N+1 = K + JQ_N

⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above

⇒ For the power amplifier circuit shown below, the maximum power dissipated by both output transisto
9.66 W
30.11 W
31.66 W
33.66 W

⇒ In figure base current is 10 μA and β_dc = 100. Then V_{E5 V
10 V
15 V
20 V}

⇒ An electrolytic capacitor can be used for
ac only
dc only
both ac and dc
high frequency ac

⇒ __________ acts as a depolarizer in a dry cell.
ammonium chloride
carbon powder
manganese dioxide
zinc chloride

⇒ In a single phase semi-converter the number of thyristors is
16
8
4
2

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ The circuit in the given figur
low pass filter
high pass filter
band Pass filter
band reject filter

⇒ The operator precedence in Java is in the order
arithmetic operation, increment and decrement operation, comprassion, logical operation and assignment operation.
increment and decrement operation, arithmetic operation, comparison, logical operation and assignment operation.
comparison, arithmetic operation, increment and decrement operation, logical operation and assignment operation.
arithmetic operation, comparison operation, increment and decrement operation, logical operation and assignment operation.

⇒ A colour monitor usign 16 bits at a resolution of 600 x 400 pixels needs a memory of
240000 B
9600 B
6400 B
480000 B

⇒ An image uses 512 x 512 picture elements. Each of the picture elements can take any of the 8 distinguishable intensity levels. The maximum entropy in the above image will be
2097152 bits
786432 bits
648 bits
144 bits

⇒ In a stud mounted SCR, the stud is
in thermal contact with heat sink
insulated from heat sink
in electrical and thermal contact with heat sink
in either electrical or thermal contact with heat sink

⇒ When a current carrying conductor is brought into magnetic field, the force that moves the conductor depends upon
the value of current
the weight of the conductor
the direction of the conductor
none of the above

⇒

Assertion (A): A series RLC circuit resonates when excited by variable frequency source.

Reason (R): Resonant frequency is geometric mean of half power frequencies.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I (Characteristics)		List II (Decrease)
A.	Paramagnetic	1.	All dipoles are aligned is one preferred direction
B.	Ferromagnetic	2.	Half the dipoles are aligned in opposite direction and have equal magnitude
C.	Antiferromagnetic	3.	Half the dipoles (with equal magnitudes) are aligned in opposite direction to the other half having equal but lower magnitude
D.	Ferrimagnetic	4.	All dipoles have equal magnitude but are randomly oriented

A-4, B-3, C-2, D-1
A-4, B-1, C-2, D-3
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1

⇒ It is desired to reduce distortion in a CE amplifier circuit. We should
reduce emitter current
reduce collector current
reduce ac base voltage
reduce base emitter voltage

⇒

Assertion (A): In a BJT, a_dc is about 0.98.

Reason (R): In a BJT, recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ For the two ports in figure, y₁₁ = 8 mho, y₁₂ = y₂₁ = -6 mho and y₂₂ = 6 mho. The values of Y_A, Y_B, Y_C respectively
2, 6, 6 mho
2, 6, 0 mho
2, 0, 6 mho
2, 6, 8 mho

⇒ Which DOS command improves memory usage?
MEM MAKER
MOVE
MEM IM
None on the above

⇒ The open loop frequency response of a unity feed back system is as u
20 dB and 15°
20 dB and 25°
6 dB and 15°
6 dB and 25°

⇒ The sum of positive real function is positive real.
TRUE
FALSE

⇒ In a digital system there are three inputs ABC. Output should be high when atleast two inputs are high. Then output =
AB + BC + AC
ABC + ABC + A BC + ABC
AB + BC + AC
AB + BC + AC