Question is ⇒ A voltage DAC is generally slower than current DAC, Options are ⇒ (A) because of more accuracy, (B) because of higher resolution, (C) because of response time of op-amp current to voltage converter, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A voltage DAC is generally slower than current DAC, Options are ⇒ (A) because of more accuracy, (B) because of higher resolution, (C) because of response time of op-amp current to voltage converter, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A voltage DAC is generally slower than current DAC
A.	because of more accuracy [Wrong Answer]
B.	because of higher resolution [Wrong Answer]
C.	because of response time of op-amp current to voltage converter [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A device has two resistances 300 Ω and 200 Ω respectively. The noise voltages due to these two resistance calculated separately are 5.38 μV and 4.38 μV respectively. When both of them are used together, the noise voltage will be
9.76 V
1 μV
23.56 μV
6.94 μV

⇒ The sensitivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒

Assertion (A): The output of a NOR gate is equal to the complement of OR of input variables.

Reason (R): A XOR gate is a universal gate.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A leakage capacitor can be represented by a capacitance C and resistance R in parallel C.
TRUE
FALSE

⇒ In a series RLC circuit excited by e = E_m sin ωt is seen that LC < 1/ω². Then
I lags E
I leads E
I leads E are in phase
voltage across L and C are equal

⇒ In switching devices, gold doping is used to
improve bonding
reduce storage time
increase the mobility of the carrier
protect the terminals against cooperation

⇒ An RLC series circuit is excited by 200 V, 100 Hz supply. The current is 20 A. If R = 10 Ω, X_L = 50 Ω, X_C is
10 Ω
14.14 Ω
7.07 Ω
50 Ω

⇒ The use of SSB
halves the bandwidth required for transmission
does not affect the bandwidth for transmission
decreases the bandwidth required for transmission by 25%
decreases the bandwidth required for transmission by 66.6%

⇒ Transconductance indicates the
control of output voltage by input voltage
control of output current by input voltage
control of input voltage by output current
control of input current by input voltage

⇒ Presently, the worlds's largest and most advanced multi-purpose communication satellite is
INSAT-2
Intelsat-V
INSAT-ID
Olympus-I

⇒ In case of stabilized reactance modulator AFC system
phase modulator is converted into frequency modulation by equalizer circuit
the discriminator must have a fast time constant to provide demodulation
the higher discriminator frequency, the better oscillator frequency
the discriminator frequency must be too low, or the system will fail

⇒ The open loop gain of an amplifier is 50 but likely to decrease by 20% due to various factors. If negative feedback with β = 0.1 is used, the change in gain will be about
0.2
0.02
0.005
0.0005

⇒ Figure sho
JFET
n-channel MOSFET
p-channel MOSFET
none of the above

⇒ In the given figure x_{6de(ax₁ + bx₂ + cx₃)
(a + b + c) (x₁ + x₂ + x₃) (d + e)
(ax₁ + bx₂ + cx₃) (d + e)
a b c d e (x₁ + x₂ + x₃)}

⇒ Nodal analysis is applicable to __________ .
planar network
planar and Non-planar both
circuit containing only voltage source
non planer

⇒ A capacitor can be represented by a capacitance C in parallel with a resistance R. For a good capacitor, the resistance R should be
very high
high
very low
low

⇒ In every practical oscillator the loop gain is slightly more than unit and amplitude of oscillations is limited by
magnitude of loop gain
onset of non-linearity
magnitude of gain
β

⇒ A three state switch has three outputs. These are
low, low and high
low, high, high
low. floating, low
low, high, floating

⇒ The symbol in figure is
UJT
PUT
SCS
SBS

⇒ The Boolean function/implemented in the figure using two I/P multiplexer
ABC + ABC
ABC + AB C
ABC + ABC
ABC + AB C

⇒

Assertion (A): A transistor has lower voltage drop during conduction as compared to thyristor

Reason (R): Transistors are manufactured in very high voltage and current ratings.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The S (sign) flag is set when the contents of accumulator become negative during an operation.
TRUE
FALSE

⇒ PAL system was proposed first in
USA
Japan
England
Germany

⇒

Assertion (A): Thyristors can be used in controlled heating, excitation systems of alternators, speed control of motors and HVDC

Reason (R): A static var system using thyristors is very commonly used in high voltage ac systems.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a bipolar transistor, the base collector junction has
forward bias
reverse bias
zero bias
zero or forward bias

⇒ Following figure repres
AND
OR
NAND
NOT

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ In a 3 phase bridge inverter with 180° mode of operation the numbers of thyristors conducting at one time are
1
2
3
4

⇒ In a colour TV receiver, the function of comb filter is
to pass only the clusters of monochrome signal energy while blocking chrome signals
to pass only chrome signals and block monochrome signals
to block both monochrome and chrome signals
none of the above

⇒ The current flowing in a certain P-N junction at room temperature is 2 x 10^-7 Amp. When a large reverse biased voltage is applied. Calculate the current flowing when 0.1 volts is applied.
9 μA
10 μA
2 μA
4 μA