Question is ⇒ A unipole is also known as, Options are ⇒ (A) omnidirectional radiator, (B) unidirectional radiator, (C) line radiator, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A unipole is also known as, Options are ⇒ (A) omnidirectional radiator, (B) unidirectional radiator, (C) line radiator, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A unipole is also known as
A.	omnidirectional radiator [Correct Answer]
B.	unidirectional radiator [Wrong Answer]
C.	line radiator [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which mode has the minimum cutoff frequency in rectangular wave guides?
TE₁₁
TE₁₀
TE₀₁
TE₂₀

⇒ A source generates three symbols with probabilities 0.25, 0.25, 0.50 at a rate of 3000 symbols per second. Assuming independent generation of symbols, the most efficient source encoder would have average bit rate is as
6000 bits/sec
4500 bits/sec
3000 bits/sec
1500 bits/sec

⇒ An RLC series circuit is excited by a step voltage E. The units of roots of characteristic equation are
seconds
1/seconds
tesla
henry

⇒ In a TV studio the illuminance is about
200 lux
1000 lux
10000 lux
10 lux

⇒ In a circuit containing a complex impedance, maximum power transfer takes place when load is
pure resistance
equal to the complex impedance
conjugate complex of the circuit impedance
none of the above

⇒

Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.

Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be
at the centre of ac load line
at the centre of dc load line
at the centre of collector voltage
at the centre of collector current

⇒ The polarization of dielectric materials results in
production of eddy currents
creation of electric dipoles
absorption of electrons
release of high velocity protons

⇒ For a Gaussian process, auto-correlation also implies
statistical dependence
statistical independence
ergodic process
none of the above

⇒ In an amplifier the stray capacitances assume impedance at low frequencies
TRUE
FALSE

⇒ For the circuit shown in figure low cut-off frequenc
1.59 Hz
159 Hz
1.59 kHz
1.59 MHz

⇒ An AC circuit has two branches in parallel. The current in one branch is 5 A. Then the current source
must be less than 5 A
must be more than 5 A
may be equal or more or less than 5 A
0.208333333333333

⇒ Higher order active filters are used for variable
bandwidth
gain in the pass band
impedance
roll off rate

⇒ Integral error compensation changes a second order system to
first order system
third order system
fourth order system
either (a) or (b) depending on the system

⇒ In liquids charge carriers are electrons only.
TRUE
FALSE

⇒ The phase angle of a lag circuit is
between 0 and -90°
between 0 and +90°
90°
more than 90°

⇒ The binary addition 1 + 1 =
11
10
111
100

⇒ Consider the following materials

Nickel
Silver
Oxygen
Aluminium

The correct sequence in the order of decreasing permeability is
1, 4, 3, 2
1, 4, 2, 3
4, 1, 3, 2
4, 1, 2, 3

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ In magnetic film memory, the memory element consits of
plated wires
superconductive material
nickel iron alloy
doped aluminium

⇒ Signal flow graph is used to find :
stability of the system
controllability of the system
transfer function of the system
poles of the system

⇒ Which of the following is not correct?
P(A) = P(A) - 1
0 ≤ P ≤ 1
If A and B are mitual exclusive then P(A + B) = P(A) + P(B)
P(A) = 1 - P(A)

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal

⇒ Maximum effective aperture (A_e)max of short dipole antenna is
1.119 λ²
0.119 λ²
1.19 λ²
1.919 λ²

⇒ Reflex klystron oscillator is essentially a low power device
TRUE
FALSE

⇒ In FORTRAN 77 FLOAT (-28) gives the value
28
-28
-28
none of the above

⇒ The realization of a reactance function gives
a network having inductances only
a network having capacitances only
a network having resistances only
a network having inductances and capacitances only

⇒ F = ∑(0, 3, 4, 5, 7) =
[B ⊕ C] + AC
B'C' + BC + AC
AB + BC + CA
None

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ Consider the following types of distortions in diode detectors

Distortion is caused due to the reason that dc and ac load impedances are unequal
Distortion is caused because ac load impedance has a reactive component at high audio frequencies
Audio frequency diode current is less than dc current

Which of the above are true?
1, 2 and 3
1 and 2
1 and 3
2 and 3