Question is ⇒ A TV picture is to be transmitted over a channel of 6 MHz bandwidth at a 35 dB S/N ratio. The capacity of the channel is, Options are ⇒ (A) 50 Mbps, (B) 100 Mbps, (C) 36 Mbps, (D) 72 Mbps, (E) , Leave your comments or Download question paper.

Question is ⇒ A TV picture is to be transmitted over a channel of 6 MHz bandwidth at a 35 dB S/N ratio. The capacity of the channel is, Options are ⇒ (A) 50 Mbps, (B) 100 Mbps, (C) 36 Mbps, (D) 72 Mbps, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A TV picture is to be transmitted over a channel of 6 MHz bandwidth at a 35 dB S/N ratio. The capacity of the channel is
A.	50 Mbps [Wrong Answer]
B.	100 Mbps [Wrong Answer]
C.	36 Mbps [Wrong Answer]
D.	72 Mbps [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The units for electric dipole moment are
coulombs
colomb-metre
coulomb/metre
coulomb/m²

⇒ For a photoengraving the mask used is
master mask
slave mask
working mask
photo mask

⇒ An impulse train is
a number of pulses
a number of pulses spaced from each other
a number of pulses all originating together
none of the above

⇒ In the circuit of figur
I₁ will always lag I₃
I₂ may be in phase or lag I₃
I₃ will always lag I₂
I₂ and I₃ will be in phase

⇒ In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is
0
1
2
3

⇒ In a television transmitter, the output stage is most likely to be
screen modulated class C amplifier
plate modulated class C amplifier
grid modulated class A amplifier
grid modulated class C amplifier

⇒ Read the following statements as regards register pairs in microprocessor 8085

B represents B, C pair with B as high order register and C as low order register.
D represents D, E pair with D as high order register and E as low order register.
H represents H, L pair with H as high order register and L as low order register.

Which of the above statements are correct?
All
1 and 3
1 and 2
2 and 3 only

⇒ In a platinum RTD, the change in resistance for a temperature rise of 50° C is about
0.02
0.1
0.2
0.4

⇒ As per temperature limits, the number of categories of solid dielectrics are
7
6
8
5

⇒ The Boolean expression for the shaded area in the Venn diagra
X + Y + Z
XY + Z + X YZ
X Y Z + XY
X + Y + Z

⇒ In figure, the value of R shoul
0.2 Ω
0.1 Ω
0.05 Ω
0.1 Ω

⇒ One of the advantages of base modulation over collector modulation of a transistor class C amplifier is
improved efficiency
better linearity
high power output per transistor
the lower modulating power requirement

⇒ Short circuit is the dual of open circuit.
TRUE
FALSE

⇒ Waveform shown in figure is that
FM
PCM
AM-DSB
AM-SSB

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the starting torque is 100 N-m. At 25 Hz, the starting torque
will be less than 100 N-m
will be more than 100 N-m
may be more or less than 100 N-m depending on motor parameters
very small

⇒ If A = 3 + j1, A⁴ =
3.16 ∠18.4°
100 ∠73.72°
100 ∠18.4°
3.16 ∠73.22°

⇒ The log magnitude curve of factor jω is a straight line having a slope of 20 dB/decade.
TRUE
FALSE

⇒ Calculate cut off frequency for dominant mode in rectangular waveguide if dimensions are a = 2, b = 1 cm.
7.5 GHz
1.5 GHz
15 GHz
150 GHz

⇒ Consider the followings statements: A multiplier

selects one of the several inputs and steers it to the output
routes the data from a single input to many outputs
converts parallel data into serial data
is a combinational circuit

On the above statements which are correct?
1, 2, 4
2, 3, 4
1, 3, 4
1, 2, 3

⇒ To measure a resistance of about 8 ohms we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (b) or (c)

⇒ The scale of dynamometer wattmeter is non linear.
TRUE
FALSE

⇒ A voltage V_BB is applied across the terminals of a UJT. The emitter voltage at peak point is
hV_BB
(h + 1) V_BB
hV_BB + V_D
V_D

⇒ The current through a 10 Ω resistance in a dc circuit having two emf sources is 3A. If this resistance is changed to 20 Ω, the new value of current will be
less than 3 A
equal or less than 3 A
equal to or less or more than 3 A
1.5 A

⇒ Consider the following statement associated with bipolar junction transistor and JFET

The former has higher input impedance than the later
The former has higher frequency stability than the later
The later has lower noise figure than the former
The later has higher power rating than the former.

Of these statements
1 and 2 are correct
2 and 3 are correct
3 and 4 are correct
1 and 4 are correct

⇒ The first pulse in a TV remote control is
start pulse
preliminary pulse
either start pulse or preliminary pulse
erase pulse

⇒ It is possible to use a freewheeling diode in
single phase half wave controlled rectifier as well as in single phase full wave controlled rectifier (M - 2 connection)
single phase half wave controlled rectifier but not in single phase full wave controlled rectifier (M - 2 connection)
single phase full wave controlled rectifier (M - 2 connection) but not in single phase half wave controlled rectifier
all controlled rectifier circuits

⇒ Computer ICs work reliably because
they are based on two state design
these are made from pure silicon
these are maintained at two temperatures
none of the above

⇒ In a two phase servomotor the two stator windings have a phase difference of
30°
45°
90°
135°

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?
1 wavelength long
0.5 wavelength long
0.6 wavelength long
0.25 wavelength long

⇒ A diode is operating in forward region and the forward voltage and current are v = 3 + 0.3 sin ωt (volts) and i = 5 + 0.2 sin ωt (mA). The average power dissipated is
15 mW
about 15 mW
1.5 mW
about 1.5 mW