Question is ⇒ A TRIAC is a semiconductor device which acts as a, Options are ⇒ (A) 2 terminal unidirectional switch, (B) 2 terminal bidirectional switch, (C) 3 terminal bidirectional switch, (D) 4 terminal multidirectional switch, (E) , Leave your comments or Download question paper.

Question is ⇒ A TRIAC is a semiconductor device which acts as a, Options are ⇒ (A) 2 terminal unidirectional switch, (B) 2 terminal bidirectional switch, (C) 3 terminal bidirectional switch, (D) 4 terminal multidirectional switch, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A TRIAC is a semiconductor device which acts as a
A.	2 terminal unidirectional switch [Wrong Answer]
B.	2 terminal bidirectional switch [Wrong Answer]
C.	3 terminal bidirectional switch [Correct Answer]
D.	4 terminal multidirectional switch [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Most of the digital computers do not have floating-point hardware because
floating point hardware is costly
it is slower than software
it is not possible to perform floating point addition by hardware
of not specific reason

⇒ The signal in 8086 are in minimum mode when
MN / Mx pin is tied to V_cc
MN / Mx pin is grounded
MN / MX pin is left open
none of the above

⇒ In ferromagnetic materials
the atomic magnetic moments are antiparallel and unequal
the atomic magnetic moments are parallel
the constituent is iron only
one of the constituents is iron

⇒ The maximum rectification efficiency in case of full wave rectifier is
1
0.812
0.666
0.406

⇒ In a multi-processor configuration two coprocessors are connected to host 8086 processor. The instruction sets of the two coprocessors
must be same
may overlap
must be disjoint
must be the same as that of host

⇒ During playback the take up reel is
in clockwise motion
in anticlockwise motion
either clockwise or anticlockwise motion
none of the above

⇒ What is the correct sequence of the following step in the fabrication of a monolithic, Bipolar junction transistor?

Emitter diffusion
Base diffusion
Buried layer formation
E pi-layer formation

Select the correct answer using the codes given below:
3, 4, 1, 2
4, 3, 1, 2
3, 4, 2, 1
4, 3, 2, 1

⇒ In the circuit of figure the function of resistor R and diode D
to limit the current and to protect LED against over voltage
to limit the voltage and to protect LED against over current
to limit the current and protect LED against reverse breakdown voltage.
none of the above.

⇒ Semiconductor ROM's are sometimes preferred to semiconductor RAM's because
ROM's are cheaper than RAMs
ROMs are faster
ROMs do not require power supply for their operations
Programs stored in ROMs cannot be altered either by the power failure or by the user

⇒ The gain of a source follower is unity.
TRUE
FALSE

⇒ Consider the following features:

negative operands cannot be used
when immediate operand changes, the program should be reassembled
the program is difficult to read
the size of operand is restricted by word length of the computer

Disadvantages of immediate addressing include
1 and 2
2 and 4
2 and 3
1 and 4

⇒ If a and b are the dimensions of waveguide then
a = 3b
a = 2b
a = b
a = b/4

⇒ Which control action is also called rate control?
Proportional
Derivative
Integral
Proportional plus integral

⇒ In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
400 V
about 100 V
about 20 V
zero

⇒ Decimal number 10 is equal to binary number
1110
1010
1001
1000

⇒ Giga watt is equal to
10¹² W
10⁹ W
10⁶ W
10³ W

⇒ If the minimum range of a radar is to be doubled, the peak power has to be increased by a factor of
2
4
8
16

⇒ Ferrite have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ Which of the following logic no resistors are used?
CMOS
TTL
4 n sec ECL
8 sec ECL

⇒ A receiver has poor selectivity. It will also have poor
sensitivity
double spotting
blocking
diversity reception

⇒ The different channels in a TDM receiver are separated by
integration
differentiation
AND gate
OR gate

⇒ The inverse Fourier transform of δ(t) is
∪(t)
1
δ(t)
e^j2pt

⇒

Assertion (A): In a conductor, current density remains constant in time as long as E is constant.

Reason (R): In a conductor, J = σE.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the above case if another sine wave corresponding to 40% modulation is transmitted simultaneously, the total radiated power will be
9.9 kW
10.15 kW
10.84 kW
18.4 kW

⇒ Find current flowing through 1 H inductor at t = 0, at which switch 'S' is ope
0
2
3
5

⇒ KCL is a statement of principle of conservation of energy.
TRUE
FALSE

⇒ While forming Routh's array, the situation of a row of zeros indicates that the system
has symmetrically located roots
is not sensitive to variations in gain
is stable
is unstable

⇒ The Boolean expression (A + B) (A + C) (B + C) simplifies to
(A + B) C
(A + B) C
(A + B) C
none of these

⇒ A noiseless 3 kHz channel can't transmit binary bit at the rate
12000 bps
1000 bps
6000 bps
3000 bps

⇒ The O/P Power of a power amplifier is several times its input power. It is possible because
power amplifier introduces a -ve resistance
there is +ve feed back in the circuit
step up transformer is use in the circuit
power amplifier converts a part of I/P d.c. power into a.c. power