Question is ⇒ A transmitter serial current contains, Options are ⇒ (A) carrier frequencies, (B) audio frequencies, (C) radio frequencies, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A transmitter serial current contains, Options are ⇒ (A) carrier frequencies, (B) audio frequencies, (C) radio frequencies, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A transmitter serial current contains
A.	carrier frequencies [Wrong Answer]
B.	audio frequencies [Wrong Answer]
C.	radio frequencies [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The colour subcarrier and sidebands produced by its modulation with the chrominance signals are accommodated in the standard channel width by the process of
frequency adjustment
frequency interleaving
frequency changing
frequency amalgamation

⇒ As the temperature increases the mobility of electrons __________ .
decreases because the number of carries increases with increased collisions
increases because the number of carries decreases with decreased collisions
remains same
none of the above

⇒ The addressing mode depicted in the given figur
direct
register
register indirect
implicit

⇒ In the given figure the input frequency f = 10(1/2 p
0 dB
3 dB
-3 dB
-20 dB

⇒ The following switching functions are to be implemented using a decoder

f₁ = ∑m (1, 2, 4, 8, 10, 14)
f₂ = ∑m (2, 5, 9, 15)
f₃ = ∑m (2, 4, 5, 6, 7)

The minimum configuration of decoder is
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line

⇒ Which of the following is incorrect?
(111)₂ + (10)₂ = 9
(111)₂ + (2)₁₀ = (9)₁₆
7 + 2 = (1001)₂
None of the above

⇒ As temperature increases, the temperature coefficient of a metal
decreases
increases
remains unchanged
any of the above

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ A 1 ms pulse can be converted into a 10 ms pulse by using which one of the following
An astable multivibrator
Stable multivibrator
A bistable multivibrator
A J-K flip-flop

⇒ A 4 cm by 3 cm rectangular waveguide with air cavity, is operating at 12 GHz with TE₁₁ mode. The cut-off frequency is:
6.25 GHz
4.75 GHz
1.5 GHz
8.75 GHz

⇒ The advantages of high density IC are
more circuits on chip
high operating speed
low power consumption
both (a) and (b)

⇒ In Weston frequency meter, the magnetic axes of the two fixed coils are
parallel
perpendicular
inclined at 60°
inclined at 15°

⇒ When a current flows through a conductor,
an electric field exists at all points within the conductor
electric field exists only at all points on the surface of the conductor
electric field exists only at ends of the conductor
any of the above depending on magnitude of current

⇒ It two voltages are v₁ = 100 sin (ωt - 30°) and v₂ = cos ω t then
v₁ is leading v₂ by 30°
v₂ is leading v₁ by 30°
v₂ is leading v₁ by 60°
v₁ is leading v₂ by 60°

⇒ What is the RF amplifier plate voltage when the audio-modulating voltage is +600
-600 V
Zero
600 V
1200 V

⇒ In phase modulation, the phase deviation is
proportional to the amplitude of the signal and varies with frequency
remains constant while amplitude and frequency of signal varies
proportional to the amplitude of the signal and independent of the frequency
none of the above

⇒ Which of the following is not a classification of programmed data transfer?
Synchronous transfer
Hand shaking
Interrupt driver transfer
Direct transfer

⇒ For a sinusoidal input, the circuit shown in the figure will act
Pulse generator
Full wave rectifier
Ramp generator
Voltage Doubler

⇒ The block diagram of AM transmitter in which high level modulation is used as shown in figure. The block X could
audio power amplifier
buffer RF amplifier
compressor amplifier
none of the above

⇒ The following program starts at location 0
20 H
02 H
00 H
FFH

⇒ A transistor will operate in inverted region when
emitter junction is forward biased and collector junction is reverse biased
emitter junction is reverse biased and collector junction is forward biased
emitter junction as well as collector junction are forward biased
emitter junction as well as collector junction are reverse biased

⇒ Consider the following statements about 8085

The instruction LDA uses direct addressing mode.
The instruction MVI uses direct addressing mode.
The instruction MVI uses immediate addressing mode.
The instruction LDA uses immediate addressing mode.

Which of the above are correct?
1 and 3 only
3 and 4 only
1 and 2 only
2 only

⇒ The h parameter equivalent circuit of BJT has one voltage source and one current source.
TRUE
FALSE

⇒ In which one of the following types of analog to digital convertors the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ A T network is inserted between source and R as shown in figure. The resistance seen by the source remains the same with or without T network when
5 Ω
10 Ω
15 Ω
20 Ω

⇒ Examine the circuit of figure and the following statem
1, 2, 3
1, 2
1 only
2 and 3

⇒ When p-n junction is reverse biased the holes in p material move towards the junction and electrons in n material move away from the junction.
TRUE
FALSE

⇒ In terms of ABCD parameters, the image parameter Z₁₁ is equal to
AC/BD
BD/AC
AB/CD
AD/BC

⇒ In a low level AM system, the modulated amplifiers stage must be
harmonic devices
non-linear devices
class C amplifier
linear devices

⇒ The phase velocity in a coaxial line is
greater than C
equal to C
less than C
not depend on C