Question is ⇒ A transistor with a = 0.9 and ICBO = 10 μA is biased so that IBQ = 90 μA. Then ICQ will be, Options are ⇒ (A) 910 mA, (B) 5 mA, (C) 5.25 mA, (D) 4.95 mA, (E) , Leave your comments or Download question paper.

Question is ⇒ A transistor with a = 0.9 and ICBO = 10 μA is biased so that IBQ = 90 μA. Then ICQ will be, Options are ⇒ (A) 910 mA, (B) 5 mA, (C) 5.25 mA, (D) 4.95 mA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_CQ will be
A.	910 mA [Correct Answer]
B.	5 mA [Wrong Answer]
C.	5.25 mA [Wrong Answer]
D.	4.95 mA [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ In a low level AM system, the amplifier which follows the modulated stage must be the
linear device
harmonic device
class C amplifier
non-linear device

⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
31 V
32 V
insufficient data
none of these

⇒ A transmitter power of 10 W is increased by 30 dB. The effective radiated power is
100 W
1000 W
10000 W
100000 W

⇒ The signal y(t) = x(- t) is __________ .
causal
non-causal
depends on x(t)
none of these

⇒ In 8085 microprocessor, if interrupt service requests have been received from all of the following interrupts, then which one will be serviced first?
RST 5.5
RST 6.5
RST 7.5
None

⇒ Which of the following statements is correct?
Convex lens has positive focal power and concave lens have negative focal power
Convex lens has negative focal power and concave lens have positive focal power
All lens have positive focal power
All lens have negative focal power

⇒ I-PD controlled system has
I, P and D actions in forward path
I, P and D actions in feedback path
I action in forward path but P and D action in feedback path
I action in feedback path but P and D actioins in forward path

⇒ The power in the signal s(t) = 8 cos (20 p - p/2) + 4 sin (15 pt) is
40
41
42
82

⇒ The number FF in hexadecimal system is equivalent to number __________ in decimal system.
256
255
240
239

⇒ MS Excel is an application software for financial planning.
TRUE
FALSE

⇒ In Pulse Code Modulation system
large bandwidth is required
quantising noise can be overcome by companding
quantising noise can be reduced by decreasing the number of standard levels
suffers from the disadvantage of its incompatibly with TDM

⇒ As compared to LED, LASER has

higher emission efficiency
no tuning arrangement
narrow spectral width
provision for confinement

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1 and 3 are correct
1, 3, 4 are correct

⇒ Hall's effect can be used to measure
magnetic field intensity
average number of holes
carriers concentration
electrostatic field intensity

⇒ An insulator will conduct when the
voltage applied is more than the breakdown voltage
temperature is raised to very high level
either (a) or (b) above
none of the above

⇒ Find L_eq if each L is
4/3 H
1/3 H
2/3 H
3/2 D

⇒ Which of the following can not be used as a variable name in C?
else
coal
ram
vendy

⇒

Match the following:

	List I		List II
A.	shift Register	1.	Frequency division
B.	Counter	2.	Addressing in memory chips
C.	Decoder	3.	Serial to parallel Data conversion

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-1, C-3
A-1, B-2, C-2

⇒ The product of which of the following gives the figure of merit of a logic family?
Gain and bandwidth
Propagation delay time and power dissipation
Fan-out and propagation delay time
Noise margin and power dissipation

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ The dielectric losses do not depend on frequency.
TRUE
FALSE

⇒ In modern MOSFET_S, the material used for the gate is
high purity silicon
high purity silica
heavily doped polycrystalline silicon
epitaxial grown silicon

⇒ In energy band diagram of n type semiconductor, the donor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band

⇒ Following figure is a signal conditioning Amplifier, changes gain depending upon the polarity of V_s. What will be circuit voltage gain for + V_s and for - V_s if D₂ is id
A_V = -R₃/R₁
R₃/R₁
R₁/R₃
1 + R₃/R₁

⇒

Assertion (A): A GTO circuit is more compact than SCR circuit

Reason (R): A GTO can be turned off by negative gate pulse.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): A tuned amplifier uses a parallel tuned circuit

Reason (R): A tuned amplifier is used to amplify a narrowband frequencies

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A white noise X(t) with two-sided power spectral density 1 x 10^-10 W/Hz is input to a filter whose magnitude squared response is shown be
5 x 10^-7W
1 x 10^-6W
2 x 10^-6W
5 x 10^-6W

⇒ The maximum permissible distance between two samples of a 10 kHz signal
100 μ sec
50 μ sec
10 μ sec
none

⇒

Assertion (A): Hamming code is commonly used for error correction

Reason (R): In Hamming code the number of parity bits increases as the number of information bits increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For generating 1 MHz frequency signal, the most suitable circuit is
phase shift oscillator
weinbridge oscillator
colpitt's oscillator
clapp oscillator