Question is ⇒ A transistor is operated as non-saturated switch to eliminate, Options are ⇒ (A) turn on time, (B) turn off time, (C) storage time, (D) delay time, (E) , Leave your comments or Download question paper.

Question is ⇒ A transistor is operated as non-saturated switch to eliminate, Options are ⇒ (A) turn on time, (B) turn off time, (C) storage time, (D) delay time, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A transistor is operated as non-saturated switch to eliminate
A.	turn on time [Wrong Answer]
B.	turn off time [Correct Answer]
C.	storage time [Wrong Answer]
D.	delay time [Wrong Answer]
View Answer 1 -4 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A transistor with a = 0.98 then β will be
49
50
47
48

⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
decreases
increases
remains constant
may increases or decreases

⇒

Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.

Reason (R): A semi converter is cheaper than a full converter.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The turn on time of an SCR is 5 micro second. Its trigger pulse should have
short rise time with pulse width = 2.5 μs
long rise time with pulse width = 3 μs
short rise time with pulse width = 4 μs
long rise time with pulse width = 4 μs

⇒ 1011₂ x 101₂ = __________ ₁₀
55
45
35
25

⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases

⇒ What is the direction of control
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into μp an some others out of μp

⇒ Which one the following is an advantage of AM over FM?
FM has wide bandwidth
FM has better
FM is more immune to noise
Probability of noise spike generation is less in AM

⇒ The direction of force an a conductor carrying current and lying in a magnetic field can be found by using
Fleming's left hand rule
Fleming's right hand rule
Cork screw rule
Any of the above

⇒ The internal resistance of a current source used in the model of a BJT while analyzing a circuit using BJT is :
very high
very low
zero
of the order of a few mega ohms

⇒ An RLC series circuit is excited by an ac voltage v = 1 sint. If L = 10 H, C = 0.1 F peak value of voltage across R is
0.707 V
1 V
1.44 V
indeterminate as value of R is not given

⇒ The logic function f(A B, C) = Σm(0, 2, 4, 5, 6) represente
i
i, ii
i, iii
i, ii, iii

⇒ A coil with large distributed capacitance has a
high resonant frequency
low resonant frequency
low quality factor
low resistance

⇒ In two level logic, logic race does not occur.
TRUE
FALSE

⇒ The circuit shown in figure conv
BCD to binary code
binary to excess-3 code
excess-3 to Gray code
gray to binary code

⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the radiated power
730 W
73 W
100 W
None

⇒ Initially the number decimal 8 is stored. If instruction RAL is executed twice, the final number stored will be
decimals 8
decimal 16
decimal 32
decimal 2

⇒ To convert SR latch to D latch
connect both S and R to D
connect D to S directly and D to R through inverter
connect D to R directly and D to S through inverter
connect S to D and leave R open

⇒ The switch board instruments
should be mounted in vertical position
should be mounted in horizontal position
should be mounted at about 45°
should be mounted at about 80°

⇒ The spectral range of a band pass signal extends from 10 MHz to 10.4 MHz. What is the minimum sampling frequency required for reconstruction?
20 MHz
20.8 MHz
20.4 MHz
0.8 MHz

⇒

Assertion (A): Static RAMS are used where speed of operation is of primary concern.

Reason (R): Dynamic RAM has lower cost per bit than static RAM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a picture tube, the video signal is applied to
cathode
grid
any anode
either cathode or grid

⇒ A PC can be upgraded to a multimedia PC by adding CD ROM drive, sound card etc.
TRUE
FALSE

⇒ In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?
Half wave rectifier
Full wave rectifier
Bridge type full wave rectifier
Three phase full wave rectifier

⇒ Which of the following is the digital system?
PWM
PAM
PPM
PCM

⇒ An antisymmetric filter having odd number of coefficient may have a performance as
low pass
high pass
band pass
all pass

⇒ The frequencies in ultra high frequency range are propagated by means of __________ waves
surface
ground
sky
space

⇒ When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of I_c(sat).
storage time
fall time
turn-on time
turn-off time

⇒ When time constant T in any factor is varied, the shapes of log magnitude and phase angle curves remain the same.
TRUE
FALSE

⇒ During processing the instructions, data, intermediate results and final results in a computer are held in
CPU
ALU
Primary memory
Secondary memory