Question is ⇒ A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is, Options are ⇒ (A) 8 W, (B) 7.5 W, (C) 7.1 W, (D) 6.8 W, (E) , Leave your comments or Download question paper.

Question is ⇒ A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is, Options are ⇒ (A) 8 W, (B) 7.5 W, (C) 7.1 W, (D) 6.8 W, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is
A.	8 W [Wrong Answer]
B.	7.5 W [Wrong Answer]
C.	7.1 W [Correct Answer]
D.	6.8 W [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300k will be (in m²/s).
0.43
0.16
0.04
0.01

⇒ Which of the following conversion is incorrect?
2048.0625 = 100000000000.0001₂
100000011.1001₂ = 131.5625₁₀
101101₂ = 45₈
Hexadecimal B6C₇ = 46791₁₀

⇒ If the diameter of a wire is doubled, its current carrying capacity becomes
one-fourth
half
twice
four times

⇒ The resistance of a standard conductor.
increases with frequency
same for ac and dc
increases with frequency
increases as square root of frequency

⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter

⇒ Most of the memory chips in static RAM
do not require any supply
need 2 V supply
need 5 V supply
need 12 V supply

⇒ Which of the following material has nearly zero temperature-coefficient of resistance?
Carbon
Porcelain
Copper
Manganin

⇒ Binary 1111 when added to binary 11111, the result in binary is
111111
1111
1000
10000

⇒ The function δ' (t-b) is
a step function originating at t = b
an impulse function originating at t = b
a unit doublet originating at = t - b
none of the above

⇒ One input terminal of high gain comparator circuit is connected to ground and a sinusoidal voltage is applied to the other input. The output of comparator will be
sinusoidal
full rectified sinusoidal
half rectified sinusoidal
square wave

⇒ If the functions w, x, y, z are as foll
w = z x = z
w = z, x = y
w = y
w = y = z

⇒ In a transistor operating in forward active mode
depletion layer between emitter and base is thin and that between base and collector is also thin
both depletion regions are thick
depletion layer between emitter and base is thin and that between base and collector is thick
depletion layer between emitter and base is thick and that between base and collector is thin

⇒ If the ladder reference voltage is 2 V, then minimum comparator resolution required is
0.125 V
1.25 V
12.5 V
0

⇒ If operator 'a' = 1 ∠120° then (1 - a²) =
1 ∠ - 30°
1 ∠ 30°
1 ∠ - 60°
1 ∠60°

⇒ Power transistors are invariably provided with
soldered connections
heat sink
metallic casing
none of the above

⇒ If f(t) is in volts, then F(jω) is in
volts
volt seconds
volts/sec
volt-sec²

⇒

Assertion (A): Increasing the system gain improves steady state behaviour but may result in instability.

Reason (R): A compensator is inserted into a system to ensure specified performance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The data of speed of train V and resistance to motion
6.7 + 0.0092 V²
3 + 0.001 V²
3.2 + 0.0012 V²
5.2 + 0.006 V²

⇒

Assertion (A): Microprocessor 8085 has an 8 bit register called accumulator which stores intermediate answers during a computer operation.

Reason (R): Accumulator can send or receive data.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ If R(t) is autocorrelation of a waveform v(t) and R(0) is autocorrelation for t = 0, then
R(0) > R(t)
R(0) ≥ R(t)
R(0) < R(t)
R(0) ≤ R(t)

⇒ Electric lines of force do not cross each other because
the lines of force mutually repel each other
the lines of force emanate from a point charge
the tangent to the line of force gives the direction of E and if they cross two tangents for E which is not possible
none of the above

⇒ The 8085 instruction 'PUSH PSW' belongs to the group
data transfer
arithmetic
logic
none of the above

⇒ When a current flows through a conductor,
an electric field exists at all points within the conductor
electric field exists only at all points on the surface of the conductor
electric field exists only at ends of the conductor
any of the above depending on magnitude of current

⇒ A modem is classified as low speed if data rate handled is
upto 100 bps
upto 250 bps
upto 400 bps
upto 600 bps

⇒ The operator precedence in Java is in the order
arithmetic operation, increment and decrement operation, comprassion, logical operation and assignment operation.
increment and decrement operation, arithmetic operation, comparison, logical operation and assignment operation.
comparison, arithmetic operation, increment and decrement operation, logical operation and assignment operation.
arithmetic operation, comparison operation, increment and decrement operation, logical operation and assignment operation.

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls Calculate group velocity for dominant mode.
1.8 x 10⁸ m/sec
5 x 10⁸ m/sec
3 x 10⁸ m/sec
1.5 x 10⁸ m/sec

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be
0.05 MHz
1 MHz
2 MHz
4 MHz

⇒ A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
ω₁
less than ω₁
more than ω₁
either more than ω₁ or less then ω₁

⇒ For the network shown below, the Thevenin voltage and R_TH is equal to _______
0 V, 58.82 Ω
0 V, 96.774 Ω
0 V, 3 KΩ
None of these

⇒ The classes of solid dielectrics are
A, B, C, D, E, F, H
A E B F H C D
Y A E B F H C
A E B F H C