Question is ⇒ A transistor amplifier with 85% efficiency is expected to be, Options are ⇒ (A) class A, (B) class B, (C) class C, (D) class AB, (E) , Leave your comments or Download question paper.

Question is ⇒ A transistor amplifier with 85% efficiency is expected to be, Options are ⇒ (A) class A, (B) class B, (C) class C, (D) class AB, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A transistor amplifier with 85% efficiency is expected to be
A.	class A [Wrong Answer]
B.	class B [Wrong Answer]
C.	class C [Correct Answer]
D.	class AB [Wrong Answer]
View Answer 6 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Capacitive transducer is superior to inductive type for measurement of capacitance because of
absence of non-linearity
high frequency response
small size
high accuracy

⇒ The saving of power in DSB-SC modulated at 80% is
NIL
0.8
0.7576
0.5

⇒ Thyristors connected in series need static and dynamic stabilizing circuits.
TRUE
FALSE

⇒ For an P-N-P transistor in normal operation its junction are biased as
emitter base : reverse, collector base : forward
emitter base : forward, collector base : reverse
emitter base : forward, collector base : forward
emitter base : reverse, collector base : reverse

⇒ The INTELSAT-IV satellite launched in 1974 had two earth coverage antenna and two narrower-angle antennas subtending 4.5°. The signal from narrow-angle antenna was stronger than that from earth- coverage antenna by a factor of
17.34/4.5
17.34 x 4.5
(17.34/4.5)²
(17.34/4.5)⁴

⇒ For a BJT a = 0.98, then β =
0.02
0.5
4.9
48

⇒ DC servomotors are, generally
permanent magnet dc motors
shunt field motors
separately excited dc motors
none of the above

⇒

Assertion (A): The ac load line is different from dc load line

Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A variable resistance R and capacitive reactance X_C are fed by an voltage. The current locus is
a semi circle in 4th quadrant
a semi circle in first quadrant
a straight line in 4th quadrant
a straight line first quadrant

⇒ The poles with greater displacement from the real axis correspond to
higher frequencies of oscillations
stable response
lower frequencies of oscillations
unbounded output

⇒ A parallel RLC circuit has ω₀ = 10⁶ and Q = 30, Given C = 30 pF, the value of R is
0
1 μΩ
2 MΩ
1 MΩ

⇒ Considerable ionization occurs between the range
50 km to 400 km
100 to 400 km
50 km to 250 km
10 to 50 km

⇒ The main advantage of TDM over FDM is that it
needs less power
needs less bandwidth
needs simple circuitry
gives better S/N ratio

⇒ "Micro-programming" is a technique
for programming the microprocessors
for writing small programs efficiently
for programming the control steps of a computer
for programming output/input

⇒ In radar PRF depends on maximum range.
TRUE
FALSE

⇒ Which type of fading causes serious distortion of modulated signal?
Selective fading
Interference fading
Absorption fading
Polarization fading

⇒ The relative permittivity of the ionosphere at ratio frequencies is
> 1
< 1
1
≥ 1

⇒ The noise performance of a square law demodulator of AM signal is
better than that of an envelope detector
better than that of a synchronous detector
identical with that of a synchronous detector
poorer than that of an envelope detector

⇒ Which of the following is not true as regards communication receiver?
It is exactly same as radio receiver used in households
It can be used, besides communication, for detection in high frequency bridges
It is designed to perform the task of low and high frequency reception better than in household receiver
Its tuning and operation are more complicated than those in household receiver

⇒ In practical commercial FM system, channel bandwidth is
150 kHz
100 kHz
88 MHz
108 MHz

⇒ An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of 0-5 V range through a 250 gain amplifier. For a displacement 0.5 mm the output of LVDT is 2 mV. The sensitivity of instrument is
0.1 V/mm
0.5 V/mm
1 V/mm
5 V/mm

⇒ Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C
0.5
5
5.657
5.756

⇒ LVDT is used to measure
displacement
pressure
temperature
any of the above

⇒ A lead compensator
speeds up the transient response
increases the stability margin
increases the stability margin and speeds up the transient-response.
none of the above.

⇒ Which instrument needs creep compensation?
Dynamometer wattmeter
Induction wattmeter
Energy meter
Both (b) and (c)

⇒ A counter has N flip flops. The total number of states are
N
2 N
2^N
4 N

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac

⇒ If V = 20 + j20, then log_e(A) A is
3.342 + j 45
28.28 ∠45°
400 ∠45°
3.342 + j 0.785

⇒ In n channel JFET
I_D and V_DS are positive but V_GS is negative
I_D and V_GS are positive but V_DS is negative
V_DS and V_GS are positive but I_D is negative
I_D, V_DS and V_GS are all positive

⇒ The device 'one shot' has
two stable states
one stable state
either 1 or 2 stable states
no stable state