Question is ⇒ A transducer must have, Options are ⇒ (A) good dynamic response, (B) good sensitivity, (C) good resolution, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A transducer must have, Options are ⇒ (A) good dynamic response, (B) good sensitivity, (C) good resolution, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A transducer must have
A.	good dynamic response [Wrong Answer]
B.	good sensitivity [Wrong Answer]
C.	good resolution [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ - 56 is not a valid real constant in Fortran.
TRUE
FALSE

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10

⇒ To measure dielectric loss you would use
Anderson bridge
Kelvin bridge
Schering bridge
Maxwell's bridge

⇒ A divide by 78 counter can be obtained by
6 numbers of mod-13 counters
13 numbers of mod-6 counters
one mod-13 counter followed by mod-6 counter
13 number of mod-13 counters

⇒ Two coupled coils with self inductances of 4 mH and 16 mH are connected in series. The maximum possible value of inductance can be
36 mH
20 mH
28 mH
64 mH

⇒ In figure, the current supplied by battery immediately after switching on the circui
0.0416666666666667
0.166666666666667
0.416666666666667
0

⇒ The secondary constants of a line are
Z₀
Z₀ and γ
Z₀, γ and wave velocity
Z₀, γ and L

⇒ A variable reluctance type tachometer has 150 teeth on rotor. The counter records 13500 pulse/sec. The rotational speed is
4800 RPM
5400 RPM
6000 RPM
7200 RPM

⇒ Which stage generates RF carri
Amplifier
Oscillator
Power supply
All of the above

⇒ In CE approximation, the upper end of d.c. load line is called the __________ point and the lower end is the __________ point.
Q, base
base, Q
saturation, cut off
cut off, saturation

⇒ The effective value of the waveform in the given figur
5
2.5
2.5
5.0

⇒ Maxwell's curl equation for the static electric field E can be expressed as
Δ x E = 0
Δ x E = constant
Δ - E = constant
Δ . E = 0

⇒

Match the following:

	List I		List II
A.	lag compensation	1.	Exterior of unit circle \|z\| = 1
B.	lead compensation	2.	PD control
C.	stability	3.	Non-minimum phase
D.	Instability	4.	Left half s plane
		5.	PI control

A-2, B-5, C-1, D-3
A-3, B-1, C-2, D-5
A-1, B-2, C-3, D-4
A-5, B-2, C-4, D-1

⇒ As regards dielectric constant ε_r
the units are farads/m
the units are newton/coulomb
it is dimensionless
the units are farads

⇒ Which of the following is not a valid real constant?
-73.1
10251,3
10.23
-5.7381

⇒ Three cascaded stages have gains of 10, 20 and 25. The overall gain will be
10
55
500
5000

⇒ If γ = (S₀/N₀)/(S_i/N_m) where S₀ and S₁ are signal power output and signal power input and N₀ and N_m are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are
1 and 1
1 and 2
2 and 1
0.5 and 0.5

⇒ If CS = A₁₅ A₁₄ A₁₃ is used as chip select logic of a 4 K RAM in 8085 system, its memory range is
3000 H - 3 FFF H
7000 H - 7 FFFH
5000 H - 5 FFF H and 6000 H - 6 FFF H
6000 H - 6 FFF H and 7000 H - 7 FFF H

⇒ The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
260 V
252 V
250 V
248 V

⇒ During testing of an energy meter, the energy recorded by meter was 0.05 kWh and correct energy was found to be 0.09 kWh. The error and correction respectively are
-0.01 kWh and 0.01 kWh
0.01 kWh and -0.01 kWh
-0.01 kWh and ± 0.01 kWh
± 0.01 kWh and 0.01 kWh

⇒ Antenna radiation efficiency can be increased by
reducing radiation resistance of the system
increasing radiation resistance of the system
providing effective earthing
any of the above

⇒ In following figure, what will be R₁ and R₂ for maximum symmetrical swing if V_CSat ≈ 0. Given that R_E = 200 Ω, R_C = 400 Ω, V_CC = 20 V, β
6 k
3 k, 6 k
9.9 k, 2.4 k
2.4 k, 9.9 k

⇒ Which of the following is equivalent to x?
x EX-OR 0
x EX-NOR 0
1 NOR x
x AND x

⇒ Two function g₁(t) and g₂(t) with correlation of 6 has average power of 4 and 5 respectively. The power of g₁(t) + g₂(t) is
9
21
3
15

⇒ A radiation thermometer is suitable for temperatures
below 500°C
below 100°C
above 500°C
above 1400°C

⇒ In a synchro transmitter-control transformer, the voltage induced in rotor winding of control transformer is zero when the angular displacement between rotors of transmitter and transformer is
0°
90°
180°
either (a) or (c)

⇒ As compared to bipolar junction transistor, a FET
is less noisy
has better thermal stability
has higher input resistance
all of the above

⇒ In carbon resistor colour code, if the third band is of silver, it indicates
that three zeros are to be added to indicate the resistance value
multiplier is 0.01
multiplier is 0.1
tolerance is ± 5%

⇒ In a rectangular waveguide
the broad width is generally labelled 'a' and height 'b'
the broad width is generally labelled 'b' and height 'a'
any one of the dimensions may be labelled 'a' and the other 'b'
the length is labelled as 'a'

⇒ In a TV receiver antenna the length of reflector rod
is the same as that of dipole
is less than that of dipole
is more than that of dipole
may be equal, more or less than that of dipole