Question is ⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?, Options are ⇒ (A) 636 pF, (B) 180 pF, (C) 65 pF, (D) 30 pF, (E) , Leave your comments or Download question paper.

Question is ⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?, Options are ⇒ (A) 636 pF, (B) 180 pF, (C) 65 pF, (D) 30 pF, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?
A.	636 pF [Wrong Answer]
B.	180 pF [Wrong Answer]
C.	65 pF [Correct Answer]
D.	30 pF [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a transistor operating in forward active mode
depletion layer between emitter and base is thin and that between base and collector is also thin
both depletion regions are thick
depletion layer between emitter and base is thin and that between base and collector is thick
depletion layer between emitter and base is thick and that between base and collector is thin

⇒

Match the following:

	List I		List II
A.	Former	1.	Produces deflecting torque
B.	Coil	2.	Provides base for coil
C.	Core	3.	Makes the magnetic field radial
D.	Spring	4.	Provides controlling torque

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3

⇒ For very low frequencies, log magnitude for the given figur
0 dB
-3 dB
3 dB
10 dB

⇒ As the firing of a thyristor is delayed, the output voltage of a controlled rectifier decreases.
TRUE
FALSE

⇒ In the circuit shown below current through the resistor is shown. Voltage across 4 Ω resistor
8 volt
≈ 5.87 V
≈ 6.87 V
None of these

⇒ In Schering bridge, the potential of detector above earth potential is about
a few volts
10 kV
1000 V
either (a) or (b)

⇒ Program counter in a digital computer
counts the number of program run in the machine
counts the number of times a subroutine is called
counts the number of times the loops are executed
points the memory address of the current or the next instruction to be executed

⇒ The modulation index of an AM wave is measured using a CRO. The waveform is as shown in figure, the modulation index is nea
0.43
0.3
0.23
0.17

⇒ The box on the external left of the title bar of menu is called control menu box.
TRUE
FALSE

⇒ A network has two sources of different frequencies. The only method of analysis which can be used to find current and voltages of different branches is the use of
Kirchoff's laws
Superposition theorem
Thevenin's theorem
Tellegen's theorem

⇒ The voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit) is 25 volts. The maximum voltage on the reverse biased diode will be
100 V
50 V
25 V
12.5 V

⇒ In a P-N-P transistor, with normal bias
the collector junction has negligible resistance
only holes cross the collector junction
the collector-base junction is reverse biased and the emitter base junction is forward biased
only majority carriers cross the collector junction

⇒ Read the following statements about 8085

RAL instruction rotates ACC contents left by 1 bit
When RAL instruction is executed once the binary number gets doubled
STC means set CY to 1

Which of the above statements are correct?
1 and 2 only
1, 2 and 3 only
1, 2 and 4 only
1 and 4 only

⇒ Figure shows the V-i characteristics of a material. The material is likely t
copper
carbon
zinc oxide
rubber

⇒ The skip distance is the maximum distance upto which ionospheric reflection is possible.
TRUE
FALSE

⇒ A + AB =
A
A
A + B
A + B

⇒ In figure, the short circuit current through terminal AB wil
0.125
1.5 A
0.0833333333333333
0.0416666666666667

⇒ For an ideal 3000 Hz channel, S/N ratio is
3
1.5
4
2

⇒ In a computer the instructions, data, intermediate and final results during processing are held in ALU.
TRUE
FALSE

⇒ For an amplifier the power gain in decibels will be equal to voltage gain in decibels only when
R₀ = 0
R₀ = R_i = 90
R₀ = R_i
R_i = 0

⇒ Which of the following is an oscillator with best frequency stability?
Crystal oscillator
Clapp oscillator
Phase shift circuit
Multivibrator

⇒ The distance at which a sky wave is received back on earth decreases with angle of incidence for all angles of incidence.
TRUE
FALSE

⇒ Which of the following is not a library string function in C?
strlen
strcpy
strdup
strbig

⇒

Assertion (A): Tunnel diode is used in many pulse and digital circuits.

Reason (R): The v-i curve of a tunnel diode resembles letter 'N'.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The I/P impedance of a short circuited quarter wave long transmission line is
purely reactive
purely resistive
depend on the characteristic impedance of the line
none of the above

⇒ In a full bridge inverter, the waveshape of load current depends on
relative values of load parameters R, L and C
relative values of load parameters R and L
relative values of load parameters L and C
gating frequency

⇒ V MOS have the advantage of
faster switching
no thermal run away
both (a) and (b)
none of the above

⇒

Assertion (A): Copper is a monoatomic solid.

Reason (R): In a metal the valence electrons belong to all atoms.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ When the gate terminal of MOSFET is positive, it is said to operate in
depletion mode
conduction mode
enhancement mode
none of the above

⇒ In a synchro transmitter-control transformer, the voltage induced in rotor winding of control transformer is zero when the angular displacement between rotors of transmitter and transformer is
0°
90°
180°
either (a) or (c)