Question is ⇒ A system with input x[n] and output y[n] is given as y[n] = (sin 5/6 pn) x(n) The system is, Options are ⇒ (A) linear, stable and invertible, (B) non-linear, stable and non-invertible, (C) linear stable, non invertible, (D) linear, unstable, invertible, (E) , Leave your comments or Download question paper.

Question is ⇒ A system with input x[n] and output y[n] is given as y[n] = (sin 5/6 pn) x(n) The system is, Options are ⇒ (A) linear, stable and invertible, (B) non-linear, stable and non-invertible, (C) linear stable, non invertible, (D) linear, unstable, invertible, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A system with input x[n] and output y[n] is given as y[n] = (sin 5/6 pn) x(n) The system is
A.	linear, stable and invertible [Wrong Answer]
B.	non-linear, stable and non-invertible [Wrong Answer]
C.	linear stable, non invertible [Correct Answer]
D.	linear, unstable, invertible [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The characteristics of which device has peak point and valley point
SCR
PUT
SCS
Shockley diode

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register E are stored.
054 CH
054 DH
054 EH
054 FH

⇒ An n type semiconductor is illuminated by a steady flux of photons with energy greater than the band gap energy. The change in conductivity Δσ obeys which relati
Δσ = 0
Δσ = e(σ_n + σ_p) Δ_n
Δσ = e(μ_nΔ_n - μ_pΔ_p)
Δσ = e μ_nΔ_n

⇒ The operating voltage of a megger is about
100 V
12 V
6 V
1 V

⇒ A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be
zero or 16 W
4 W or 8 W
zero or 8 W
8 W or 16 W

⇒ Which of the following are the memory performance parameters?

Access time and latency
Block size and Block access time
Cycle time and Bandwidth

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ j⁶ =
j
j²
j³
- j

⇒

Match the following:

	List I (Double Rectifier)		List II (Number of Diodes)
A.	Full wave Bridge rectifier	1.	1
B.	Half wave rectifier	2.	2
C.	Full wave rectifier using centre tapped transformer	3.	4

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-1, C-3
A-3, B-1, C-2

⇒ All of the following elements have three valence electrons EXCEPT
boron
indium
gallium
arsenic

⇒ The following circuit is implementation of:

sum of full adder

carry of half adder

difference of full subtractor

1 only
3 only
2 only
1 and 2 both

⇒ In a backward wave oscillator the efficiency
is much higher than in TWT
is much lower than in TWT
is almost the same as in TWT
either (a) or (b)

⇒ The z transform of sequence x[n] = {2, 4, 3, 2}
2z^-1 + 4z^-2 + 3 + 2z⁺¹
2z^-1 + 3 + 4z⁺¹ + + 2z⁺²
2z⁺¹ + 3z^-1 + 4z^-2 + 2z^-3
3 + 2z^-1 + 4z^-2 + 2z^-1

⇒ Space wave may be a direct wave or wave reflected from earth.
TRUE
FALSE

⇒ Two resistance R₁ and R₂ are connected in series R₁ = 528 ± 5 Ω and R₂ = 325 ± 3Ω. The total resistance will be
853 ± 2 Ω
853 ± 5 Ω
853 ± 3 Ω
853 ± 8 Ω

⇒ A pulse width signal can be governed by
free running multi-vibrator
monostable multi-vibrator
Schmitt trigger
JK flip-flop

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz

⇒ Consider the following instruments

Tangent galvanometer
Rayleigh current balance
Household energy meter
Hot wire ammeter

Out of above absolute instruments are
1, 2 and 3
1, 2 and 4
1 and 2
2, 3 and 4

⇒ The phenomenon known as "Early effect" in a BJT refers to a reduction of the effective base width caused by
electron-hole recombination at the base
reverse biasing of the base collector junction
forward biasing of emitter base junction
the early removal of stored base charge during saturation to cut off switching

⇒ In a fully controlled bridge converter feeding a resistive load the waveshapes of output voltage and output current
are always similar
can never be similar
may be similar or dissimilar
are similar only if a = 0

⇒ The slew rate of an ideal op-amp is
very slow
slow
fast
infinitely fast

⇒ The line of sight communication requires the transmit and receive antennas to face each other. If the transmit antenna is vertically polarized, for best reception to the receive antenna should be
horizontally polarized
vertically polarized
at 45° within respect to horizontal polarization
at 45° with respect to vertical polarization

⇒ In a uniformly doped BJT, assume that N_E, N_B and N_C are the emitter, base and collector dopings in atoms/cm³, respectively. If the emitter injection efficiency of the BJT is close unity, which one of the following conditions is TRUE?
N_E = N_B = N_C
N_E >> N_B and N_B > N_C
N_E = N_B and N_B < N_C
N_E < N_B < N_C

⇒ The gate width of a monostable multivibrator is given by
T = 1.1 RC
T = 0.693 RC
0.963 RC
T = 0.369 RC

⇒ Consider the following statements

The sign of a floating point number depends on the sign of mantissa only.
If the absolute value of a number is less than 1, the sign of exponent is zero or positive.
With sign bit of mantissa as 0, increasing the exponent from a positive to a more positive value gives a larger floating point number.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ In a C expression using assignment operators, relational operators and arithmetic operators, the hierarchy of operations (in the absence of parenthesis) is
assignment, relational, arithmetic
relational, assignment, arithmetic
arithmetic, assignment, relational
arithmetic, relational, assignment

⇒ In a waveguide if TE mode exist for z direction propagation, then
E_z = 0, H_z ≠ 0
E_z = 0, H_z = 0
E_z ≠ 0, H_z = 0
E_z ≠ 0, H_z ≠ 0

⇒ An RC impadence function has a pole at s = 0. The first element in the Foster form of synthesis
is R
may be R and C
is C
is R and C in parallel

⇒ 2's complement of a given 3 or more bit number of non-zero magnitude is the same as the original number if all bits except
MSB are zero
LSB are zero
MSB are 1
LSB are 1

⇒ How can the quantizing noise be reduced?
By using de-emphasis circuit
By using RF amplifier in the receiver
By increasing the number of quantization levels
By sending sloping pulses

⇒ At the peak of negative half cycle in fi
diode A is forward biased and diode B is reverse biased
both diodes are reverse biased
both diodes are forward biased
diode A is reverse biased and diode B is forward biased