Question is ⇒ A system has poles at 0.01 Hz, 1 Hz and 80 Hz, zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is, Options are ⇒ (A) -90°, (B) 0°, (C) 90°, (D) -180°, (E) , Leave your comments or Download question paper.

Question is ⇒ A system has poles at 0.01 Hz, 1 Hz and 80 Hz, zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is, Options are ⇒ (A) -90°, (B) 0°, (C) 90°, (D) -180°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A system has poles at 0.01 Hz, 1 Hz and 80 Hz, zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is
A.	-90° [Correct Answer]
B.	0° [Wrong Answer]
C.	90° [Wrong Answer]
D.	-180° [Wrong Answer]
View Answer 4 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A hollow rectangular waveguide has dimensions a = 2b. Calculate the amount of attenuation, if the frequency is 3 GHz, and b = 1 cm.
49
47.33
50.33
50

⇒ Which mode has the minimum cutoff frequency in rectangular wave guides?
TE₁₁
TE₁₀
TE₀₁
TE₂₀

⇒ The depletion layer around p-n junction in JFET consists of
hole
electron
immobile charges
none of the above

⇒ A coil of resistance R and inductance L is connected in series with 5 μF capacitor. The source frequency is equal to resonance frequency and circuit current is 0.5 A. Another 5 F capacitor is connected in parallel with the above capacitor. The circuit current will be
0.5 A
more than 0.5 A
less than 0.5 A
0.5 A or less

⇒ A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
is forward biased
is reverse biased
may be forward biased or reverse biased
forward biased initially but reverse biased afterwards

⇒ In binomial arrays the elimination of secondary lobes takes place
at the cost of directivity
at the cost of gain
both (a) and (b)
none of the above

⇒

Assertion (A): Transformer coupling has the disadvantage of the weight of transformer and Saturation of core

Reason (R): Transformer coupling is very suitable for impedance matching

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following statement about the advantage of phase discriminator over the slope detector is false?
Fewer tuned circuits
Better linearity
Greater limiting
Much easier alignment

⇒ T-flip-flop is commonly used as
a delay switch
a digital counter only
a digital counter and frequency divider
any of the above

⇒ 74HCT00 series is
NAND IC
interface between TTL and CMOS
inverting IC
NOR IC

⇒ The highest modulation frequencies typically used in FM broadcast is
5 kHz
10 kHz
15 kHz
25 kHz

⇒ The log magnitude curve of factor jω is a straight line having a slope of 20 dB/decade.
TRUE
FALSE

⇒ A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
rectification efficiency will be more than 0.6 and TUF will be more than 0.35
rectification efficiency will be more than 0.6 but TUF will be less than 0.35
rectification efficiency will be less than 0.6 and TUF will be less than 0.35
rectification efficiency will be less than 0.6 but TUF will be more than 0.35

⇒

Assertion (A): Thyristors can be used in controlled heating, excitation systems of alternators, speed control of motors and HVDC

Reason (R): A static var system using thyristors is very commonly used in high voltage ac systems.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ To prevent overloading in the last IF amplifier one should use
variable sensitivity
squelch
double conversion
variable selectivity

⇒ Nichrome is used in
heater coils
underground cables
overheated wires
lamp filament

⇒ The feedback control system shown in figure is stable for what values of K and
K < 0, T > - 1
K > 0, T > 0
K > 0, T > - 1
K < 0, T > 0

⇒

Assertion (A): The line integral of B about a closed contour, in a region containing steady current, is μ₀ times the total net current, following through the contour of integration.

Reason (R): The curl of B is equal to μ₀ times the current density vector J

Both (A) and (R) are true and (R) is the correct explanation of (A)
Both (A) and (R) are true but (R) is not the correct explanation of (A)
(A) is true but (R) is false
(A) is false but (R) is true

⇒ If i = 10 + 12 cos 500t - 3.5 sin 500 t, then in amplitude phasse form i =
10 + 12.5 sin (500 t + 106.20°)
5 + 12.5 sin (500 t + 106.20°)
10 + 11 sin (500 t + 106.20°)
10 + 12.5 sin (500 t + 10°)

⇒ The gain of a source follower is unity.
TRUE
FALSE

⇒ In the stabilized reactance modulator AFC system
phase modulation is converted into amplitude modulation by the equalizer circuit
the discriminator frequency must not be too low or the system will fail
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency, better the oscillator frequency stability

⇒ Noise with double-sided power spectral density of K overall frequencies is passed through a RC low pass filter with 3 dB cut-off frequency of f_c. The noise power at the filter output is
K
Kf_c
Kpf_c
∞

⇒ The number of p-n junctions in a semiconductor diode are
0
1
2
1 or 2

⇒ A circuit has two branches 1 and 2 in parallel. If |Q₁| = 8 KVAR and |Q₂| = 6 KVAR, the magnitude of total kvar drawn form supply will be
14 KVAR
2 KVAR
zero
14 or 2 KVAR

⇒ A radio wave is incident on a layer of ionosphere at an angle of 30° with the vertical. If the critical frequency is, 1.2 MHz, the maximum usable frequency is
1.2 MHz
2.4 MHz
0.6 MHz
1.386 MHz

⇒ The impedance of a coil above self-resonant frequency is
inductive
capacitive
resistive
none

⇒ Shaft encoder is used to measure
angular position
linear position
linear velocity
linear acceleration

⇒ The reverse saturation current depends on the reverse bias.
TRUE
FALSE

⇒ In a communication receiver, a squelch circuit is normally inserted
before detector
after detector
before mixer
after power amplifier

⇒ Full adder circuit can be implemented by
Multiplexers
Half adders
AND or OR gates
Decoders