Question is ⇒ A switch tail ring counter is made by using a single D FF. The resulting circuit is a, Options are ⇒ (A) SR FF, (B) JK FF, (C) D FF, (D) T FF, (E) , Leave your comments or Download question paper.

Question is ⇒ A switch tail ring counter is made by using a single D FF. The resulting circuit is a, Options are ⇒ (A) SR FF, (B) JK FF, (C) D FF, (D) T FF, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A switch tail ring counter is made by using a single D FF. The resulting circuit is a
A.	SR FF [Wrong Answer]
B.	JK FF [Wrong Answer]
C.	D FF [Correct Answer]
D.	T FF [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In FM signal with a modulation index m_f is passed through a frequency tripler. The wave in the output of the tripler will have a modulation index of
m_f
3m_f
m_f/3
m_f/9

⇒ The frequency at which phase angle is 180° is called
phase crossover frequency
stability limit frequency
frequency of limited stability
gain margin frequency

⇒ In the given figure, the number of individual loop
2
4
5
6

⇒ The power in the signal s(t) = 8 cos (20 p - p/2) + 4 sin (15 pt) is
40
41
42
82

⇒ A communication receiver is
TRF receiver
a superheterodyne receiver
either (a) or (b)
neither (a) nor (b)

⇒ Advanced low power Schottky is a part of
ECL family
CMOS family
TTL family
none of the above

⇒ The resolution of a wire wound potentiometer is about
0.00001
0.001
0.01
0.05

⇒ Without a spectrum analyser, it is not possible to determine
carrier frequency
antenna pattern
pulse width
spurious signal strength and its location

⇒

Assertion (A): Most of magnetic circuits have an air gap.

Reason (R): An air gap has high reluctance.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If low pressure of 10^-6 mm of Hg is required to be measured, we should use
compound pressure gauge
thermocouple vacuum gauge
Pirani gauge
ionization type vacuum gauge

⇒ The signumm function written as [sgn(t)] is defined as
sgn(t) = - 1 for t < 0, = 0 for t = 0 and = 1 for t > 0
sgn(t) = 1 for t < 0, = 0 for t = 0 and = - 1 for t > 0
sgn(t) = 0 for t < 0, = 1 for t = 0 and = 0 for t > 0
sgn(t) = 0 for t < 0, = 1 for t³ 0

⇒ If V_dc1 is the dc output voltage in half wave controlled rectifier circuit feeding resistive load and V_dc2 is the dc output voltage in full wave controlled rectifier circuit (M - 2 connection) feeding resistive load, then
V_dc1 = 0.5 V_dc2 for all values of firing angle
V_dc1 = V_dc2 for all values of firing angle
V_dc1 ≤ 0.5 V_dc2 for all values of firing angle
V_dc1 ≥ 0.5 V_dc2 for all values of firing angle

⇒ Symbol shown in figure represen
Enhancement only N-channel MOSFET
UJT with p-type base
N-channel DMOSFET with internal protection
Phototransistor

⇒ Which of the following capabilities are available in a Universal Shift Register?

Shift left
Shift right
Parallel load
Serial add

Select the correct answer from the codes given below:
2 and 4 only
1, 2 and 3
1, 2 and 4
1, 3 and 4

⇒ Out of S, R, J, K, Preset, Clear inputs to flip flops, the synchronous inputs are
S, R, J, K only
S, R, Preset, Clear only
Preset, Clear only
S, R only

⇒ In root locus analysis the breakaway and break in points
lie on the real axis
either lie on the real axis or occur in complex conjugate pairs
always occur in complex conjugate pairs
none of the above

⇒

Match the following:

	List I		List II
A.	bit	1.	10
B.	nat	2.	e
C.	decit	3.	2

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-2, C-1
A-2, B-3, C-1

⇒ An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a
sine wave
square wave
triangular wave
(a) or (c)

⇒ In fi
Wave A is lagging wave B by ∠θ
Wave A is leading wave B by ∠θ
Wave A is lagging wave B by ∠θ and the two waves have same rms values
Wave A is lagging wave B by ∠θ and the two waves have different rms values

⇒ Find curren
4/5 A
5/4 A
1.23 A
1.32 A

⇒

Assertion (A): The h-parameter model of a BJT can be derived from its hybrid-p model and vice-versa.

Reason (R): The hybrid-p model has many more additional elements as compared to h-parameter model of the BJT.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is a disadvantage of Vestigial Sideband (VSB) system?
Low video frequencies are attenuated
Bandwidth is conserved resulting in a saving of 2 MHz per channel over DSB system
It results in a power boost of two video frequencies
It possess the advantages of both DSB and SSB system

⇒ The depletion type MOSFET can operate in
depletion mode only
enhancement mode only
depletion or enhancement mode
neither depletion nor enhancement mode

⇒ A FET
has two P-N junctions
has three P-N junctions
depends on the variation of the depletion layer width with reverse voltage, for its operation
depends on the variation of a magnetic field for its operation

⇒ A transconductance amplifier has
high input impedance and low output impedance
low input impedance and high output impedance
high input and output impedance
low input and output impedance

⇒ Which of them radiates emission?
LED only
LCD only
Both LED and LCD
Neither LED nor LCD

⇒ If x_k = a^k and k &l
TRUE
FALSE

⇒

Assertion (A): If power gain doubles the power gain increases by 3 dB

Reason (R): The bel power gain of cascaded stages is equal to sum of each bel power gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a semiconductor strain gauge, the ohmic electrical contacts are generally made of
copper wire
gold wire
aluminium wire
nickel wire

⇒ Skip distance depends on time of day and angle of incidence.
TRUE
FALSE