Question is ⇒ A step voltage E is applied to an R-L series circuit. At <i>t</i> = 0, the current in the circuit is, Options are ⇒ (A) E/R, (B) E/L, (C) infinity, (D) zero, (E) , Leave your comments or Download question paper.

Question is ⇒ A step voltage E is applied to an R-L series circuit. At <i>t</i> = 0, the current in the circuit is, Options are ⇒ (A) E/R, (B) E/L, (C) infinity, (D) zero, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A step voltage E is applied to an R-L series circuit. At t = 0, the current in the circuit is
A.	E/R [Wrong Answer]
B.	E/L [Wrong Answer]
C.	infinity [Wrong Answer]
D.	zero [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which is not purpose of modulation?
Effective radiation
Multiplexing
Narrow band
Increase in signal power

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The box on the external left of the title bar of menu is called control menu box.
TRUE
FALSE

⇒ The main advantage of TWT over klystron is
higher bandwidth
higher gain
higher frequency
higher output

⇒ For a two port network to be reciprocal
Z₁₁ = Z₂₂
y₁₂ = y₂₁
h₂₁ = - h₁₂
AD - BC = 0

⇒ If it is desired to have low output impedance in an amplifier circuit then we should use
common collector circuit
common base circuit
common emitter circuit
either (b) or (c)

⇒ When Z₁ << Z, The circuit of figure work
inverting amplifier
Schmitt trigger
non-inverting amplifier
source follower

⇒ If a line having Z₀ = 300 ∠ 0 W is open circuited at far end, VSWR is
0
1
∞
2

⇒ The pole-zero plot given below corresponds
low pass filter
high pass filter
band pass filter
notch filter

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ In 8085 which addressing mode is also called inherent addressing?
Direct
Register
Implicit
Immediate

⇒ Which is not a software?
DOS
Windows
MS WORD
Hard disk

⇒ As temperature increases the forbidden gap in silicon increases.
TRUE
FALSE

⇒ Consider the following statements

EEPROM has the problem of high write time.
EEPROM has the problem of limited number of write cycles.
Shadow RAM has the problem of high write time.

Which of the above statements are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The input to an op-amp integrating amplifier is a constant voltage. The output will be
a constant voltage
a sawtooth wave
a ramp
ac voltage

⇒ Consider the following statements

Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.
For a given value of TM₁₀ cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.
Ridge wave guide has higher conductor losser than a rectangular waveguide.
Ridge guide has higher conductor losser than a rectangular waveguide.

Which of the above statements are correct?
1 and 2 only
1, 2 and 3 only
2 and 3 only
All

⇒ What is the minimum value of VSWR that may exist on a transmission line?
Less than zero
Zero
One
10

⇒ If the minimum range of a radar is to be doubled, the peak power has to be increased by a factor of
2
4
8
16

⇒ When tracing through a resistance we always get a voltage drop.
TRUE
FALSE

⇒ The high voltage level of a digital signal in positive logic is
1
0
either 1 or 0
-1

⇒ The power dissipation in a transistor is the product of
emitter current and emitter to base voltage
emitter current and collector to emitter voltage
collector current and collector to emitter voltage
none of the above

⇒ The relational operators allowed in Pascal are
=, >, <, > =, < = and < >
=, >, < and < >
=, >, <, > = and < =
>, <, > = and < =

⇒

Assertion (A): If minimum phase system has a gain margin of 8 dB and phase margin of 21°, the system is stable.

Reason (R): For a minimum phase system both GM and PM must be positive for the system to be stable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In 8085, the pins for SID and SOD are
4 and 5 respectively
5 and 4 respectively
3 and 4 respectively
4 and 3 respectively

⇒ The constellation diagram of a modem has four states as shown in the figure given below. What is the bit rate of this mod
Two times its band rate
Four times its band rate
Same as band rate
Sufficient information is not given to give the answer

⇒ In digital circuits Schottky transistors are preferred over normal transistors because of their
lower propagation delay
lower power dissipation
higher propagation delay
higher power dissipation

⇒ The symbol in figure is
SUS
SBS
Shockley diode
UJT

⇒ Which of the following pairs of octal and binary numbers are not equal?
111 11011₂ = 767₈
110110101₂ = 665₈
11010₂ = 3₈
10101.11₂ = 25.6₈

⇒ The secondary constants of a line are
Z₀
Z₀ and γ
Z₀, γ and wave velocity
Z₀, γ and L

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors