Question is ⇒ A step voltage E is applied to a series R-L circuit. The rate of change of current is maximum at <i>t</i> =, Options are ⇒ (A) zero, (B) infinity, (C) L/R, (D) R/L, (E) , Leave your comments or Download question paper.

Question is ⇒ A step voltage E is applied to a series R-L circuit. The rate of change of current is maximum at <i>t</i> =, Options are ⇒ (A) zero, (B) infinity, (C) L/R, (D) R/L, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A step voltage E is applied to a series R-L circuit. The rate of change of current is maximum at t =
A.	zero [Correct Answer]
B.	infinity [Wrong Answer]
C.	L/R [Wrong Answer]
D.	R/L [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls Calculate group velocity for dominant mode.
1.8 x 10⁸ m/sec
5 x 10⁸ m/sec
3 x 10⁸ m/sec
1.5 x 10⁸ m/sec

⇒ The high voltage level of a digital signal in positive logic is
1
0
either 1 or 0
-1

⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2

⇒ If the electric field intensity associated with a uniform plane electromagnetic wave travelling in a perfect dielectric medium is given
3.0 x 10⁸ m/sec
2 x 10⁸ m/sec
6.28 x 10⁷ m/sec
2 x 10⁷ m/sec

⇒ Circuit switching, Message switching and Packet Switching Network belong to which of the following systems?
Computer communication system
Electromechanical communication system
PBX system
EPBX system

⇒ Which of the following combinations is not used in thermocouple transducer measurement of temperature?
Iron-constantan
Chromel-aluminium
Copper-constantan
Iron-silver

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ In 8156, the lower times byte is addressed with 24 H, and the upper times byte with
20 H
23 H
24 H
25 H

⇒ Vectored interrupt is an interrupt that takes the program to a vector location. TRAP vectors to 0024 FI, RST 7.5 to 003 CH, RST 6.5 to 0034 H and
RST 5.5
RST 6.5
24 H to 48 H
RST 5.5 to 002 CH

⇒ The range of visible light is
300 to 2000 Å
200 - 4000 Å
4000 to 7700 Å
more than 10000 Å

⇒ The units of F(jω) are volt-seconds.
TRUE
FALSE

⇒ In a decimal digital computer, the number 127 is stored
1111111
0001 00100111
10001
11000111

⇒ A sample of N type semiconductor has electron density of 6.25 x 10⁸/cm² at 300 K. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density works out to be
10⁶/cm³
10⁸/cm³
10¹⁰/cm³
10^l2/cm³

⇒ In PM, without any modulation, all the transmitted pulses have the same
amplitude
width
amplitude and spacing
amplitude, spacing and width

⇒ In floating point representation, the accuracy is
10 bit
9 bit
8 bit
6 bit

⇒ A resistance is measured by voltmeter-ammeter method. The voltmeter is 0-250V, ± 1% accuracy and ammeter is 0-5 A, ± 1 % accuracy. The readings of voltmeter and ammeter are 100 V and 2 A respectively. The error in the measured resistance can be
± 1%
± 2%
± 5%
± 10%

⇒ When avalanche breakdown occurs covalent bonds are not affected.
TRUE
FALSE

⇒ In Gunn diode electrons are transferred from
Ridge guide is essentially a form of capacitively loaded guide
low to high mobility energy bands
valley to domain formation
domain to valley formation

⇒ The gain of a source follower is unity.
TRUE
FALSE

⇒ A coil is connected across a 200 V, 50 Hz supply and takes a current of 10 A. The loss in the coil is 1000 W. The impedance and resistance of the coil are
10 Ω, 8 Ω
15 Ω, 8 Ω
20 Ω, 10 Ω
30 Ω, 15 Ω

⇒ Consider the following program in Pascal 2
2.6
2.63
26.3

⇒ An I/O processor controls the flow of information between
cache memory and I/O devices
main memory and I/O devices
two I/O devices
cache and main memory

⇒ At a frequency equal to cutoff frequency in a rectangular wave guide
the flow of electromagnetic energy is zero
the flow of electromagnetic energy is infinite
the flow of electromagnetic energy is 50% of maximum
the flow of electromagnetic energy is 10% of maximum

⇒ Intel 2004 is a
ROM
Volatile RAM
NV RAM
None of the above

⇒ Which one of the following pairs is not correctly matched?
NaCl : Diamagnetic
Gd : Paramagnetic
Ferrite : Ferrimagnetic
Cr₂ O₃ : Ferromagnetic

⇒ If the op-amp in figure has a unity gain frequency of 1 MHz, the cut off frequenc
100 kHz
1 MHz
10 MHz
90 MHz

⇒ The output resistance of a microphone is 20 ohms. It is to feed a line of impedance 320 ohms. To ensure maximum power transfer, the turn ratio of transformer is
16
256
2
4

⇒ When the mains supply is switched off the contents of primary computer memory are lost.
TRUE
FALSE

⇒ If a sequence is causal then ROC is (where a is any number)
|z| > a
|z| < a
|z| = a
Entire Plane

⇒

Assertion (A): When Diode used as rectifier the reverse breakdown voltage should not be exceeded.

Reason (R): A high inverse voltage can destroy a p-n junction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true