Question is ⇒ A square in which each (i, j)th element of matrix is equal to the negative of the conjugate complex of (j, i)th element, is called, Options are ⇒ (A) Hermitian matrix, (B) Skew symmetric matrix, (C) Conjugate anti-symmetric matrix, (D) Skew-Hermitian matrix, (E) , Leave your comments or Download question paper.

Question is ⇒ A square in which each (i, j)th element of matrix is equal to the negative of the conjugate complex of (j, i)th element, is called, Options are ⇒ (A) Hermitian matrix, (B) Skew symmetric matrix, (C) Conjugate anti-symmetric matrix, (D) Skew-Hermitian matrix, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A square in which each (i, j)^th element of matrix is equal to the negative of the conjugate complex of (j, i)^th element, is called
A.	Hermitian matrix [Wrong Answer]
B.	Skew symmetric matrix [Wrong Answer]
C.	Conjugate anti-symmetric matrix [Wrong Answer]
D.	Skew-Hermitian matrix [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If the ladder reference voltage is 2 V, then minimum comparator resolution required is
0.125 V
1.25 V
12.5 V
0

⇒ For a delayed half wave rectified wave, the average and rms values are lower than those for half wave.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Reflex Klystron	1.	High efficiency
B.	Dielectric loaded wave guide	2.	Slow wave structure
C.	TWT	3.	Cross field device
D.	Multi Cavity Klystron	4.	Oscillator

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-4, C-1, D-3
A-3, B-1, C-4, D-2

⇒ The Kirchoff's laws fail in which of the following circuits?
Linear circuits
Non-linear circuits
Lumped parameters circuits
Distributed parameters circuits

⇒ A zener diode is used in
voltage regulator circuit
amplifier circuits
both voltage regulator and amplifier circuit
none of the above

⇒ A good ohmic contact on a P-type semiconductor chip is formed by introducing
gold as an impurity below the contact
high concentration of donors below the contact
high concentration of acceptors below the contact
thin insulator layer between the metal and semiconductor

⇒ In a 4 bit weighted resistor D/A converter, resistor value corresponding to LSB is 32 k ohm. The resistor value corresponding to MSB is
32 k ohm
16 k ohm
8 k ohm
4 k ohm

⇒ A microprocessor with a 16-bit address bus is used in a linear memory selection configuration (i.e., Address bus lines are directly used as chip selects of memory chips) with 4 memory chips. The maximum addressable memory space is
64 K
16 K
8 K
4 K

⇒ The current through a 10 Ω resistance in a dc circuit having two emf sources is 3A. If this resistance is changed to 20 Ω, the new value of current will be
less than 3 A
equal or less than 3 A
equal to or less or more than 3 A
1.5 A

⇒

Assertion (A): In ionic dielectrics, P = P_e + P_i.

Reason (R): In ionic crystals, permanent electric dipole moment is zero.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): BCD code is used in pocket calculators

Reason (R): BCD code is slower than binary.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high

⇒ Consider the following statements, SWR of a transmission line is infinite when the load is

a short circuit
a complex impedance
an open circuit
a pure reactance

Which of the above statements are correct?
1 and 3 only
1, 2, 3
2, 3, 4
1, 2, 4

⇒ If I = J = K = 13, then in Fortran 1 = 10 - (1 / 10) * 10 + (J / 5) * 4 + K ** (- 2) is equal to
8
7
6
5

⇒ Voltage 1 + 2 sin ωt is applied to the circuit shown be
0 volt
2 volts
-2 volts
-3 volts

⇒ In TV transmission the modulation schemes for video and audio are respectively
FM and AM
FM and FM
AM and FM
AM and AM

⇒ Which of the following is a vector quantity?
Standing wave ratio
Reflection coefficient
Gain
All of the above

⇒ In super computers the extra level of primary memory is generally called
Solid state device
Single stage device
Digital state device
Surface stage device

⇒ Which of the following circuits can be used as parallel-to-series converter?
Digital counter
Decoder
Demultiplexer
Multiplexer

⇒ According to maximum power transfer theorem, if the load is inductive, the source should be
inductive
capacitive
resistive
any of the above

⇒ Almost all resistors are made in a monolithic integrated circuit
during the entire diffusion
while growing the epitaxial layer
during the base diffusion
during the collector diffusion

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ A piece of copper and another piece of Germanium are cooled from 30°C to 80 K. The resistance of
copper decreases and germanium increases
both decreases
both increases
copper increases and germanium decreases

⇒ A clamper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ In 8085 microprocessor, what are the contents of register SP, after the interrupt has been star
0210 H
0211 H
054 CH
054 EH

⇒ In the TTL circuit in the figure, S₂ to S₀ are select lines and X₇ to X₀ are input lines. S₀ and X₀ are LSBs. The output
Indeterminate
A ⊕ B
A ⊕ B
C . A ⊕ B + C . (A ⊕ B)

⇒ The disturbance from adjacent telephone line is known as
cross fire
cross talk
inductive disturbance
none of the above

⇒ Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using
divide by 5 circuit
divide by 2 circuit
divide by 5 circuit followed by divide by 2 circuit
BCD counter

⇒ What is the direction of control
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into μp an some others out of μp

⇒ For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?
Δ.E = 0
Δ.E = 0
Δ x E = 0
Δ x E = 0