Question is ⇒ A square current wave of magnitude 1 A is applied to an element for 5 seconds. The voltage across the element rises linearly from 0 to final value linearly. The element is, Options are ⇒ (A) resistance, (B) inductance, (C) capacitance, (D) R and C in series, (E) , Leave your comments or Download question paper.

Question is ⇒ A square current wave of magnitude 1 A is applied to an element for 5 seconds. The voltage across the element rises linearly from 0 to final value linearly. The element is, Options are ⇒ (A) resistance, (B) inductance, (C) capacitance, (D) R and C in series, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A square current wave of magnitude 1 A is applied to an element for 5 seconds. The voltage across the element rises linearly from 0 to final value linearly. The element is
A.	resistance [Wrong Answer]
B.	inductance [Wrong Answer]
C.	capacitance [Correct Answer]
D.	R and C in series [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a power system, reactive power is necessary for
power transmission
stabilising the voltage level
counteracting the effect of reactance in the transmission system
none of the above

⇒ Trinitron is a monochrome picture tube.
TRUE
FALSE

⇒ Which of the following are the properties of a medium?
Permeability, flux, magnesium
Permittivity, permeability, insulation
Permeability, resistivity, conductivity
Permittivity, permeability, conductivity

⇒ For Q >> 1, the output frequency of LC oscillator is equal to resonant frequency.
TRUE
FALSE

⇒ Which of the following arithmetic operations requires only one operand in FORTRAN 77?
Addition
Multiplication
Negative
Substraction

⇒

Assertion (A): Demodulation of SSB and AM signals is exactly similar

Reason (R): The basic SSB demodulation device is product detector.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The maximum permissible distance between two samples of a 10 kHz signal
100 μ sec
50 μ sec
10 μ sec
none

⇒ In a klystron amplifier the input cavity is called
buncher
catcher
Pierce gun
collector

⇒ In the circuit shown in the given figure the diode states at the extremely large negative values of the input voltage v_i a
D₁ off, D₂ off
D₁ on, D₂ off
D₁ off, D₂ on
D₁ on, D₁ on, D₂ on

⇒ The discussing sharing of a communication satellite by many geographically dispersed Earth station, DAMA means
Demand-Assigned Multiple Access
Decibel Attenuated Microwave Access
Digital Analog Master Antenna
Dynamically-Assigned Multiple Access

⇒ The transformer cores operating at microwave frequency ranges are generally made up of
silicon steel
ferrites
albino
super alloy

⇒ An impulse train is
a number of pulses
a number of pulses spaced from each other
a number of pulses all originating together
none of the above

⇒ A 10 GHz signal propagates in a waveguide with a phase velocity of 4 x 10⁸ m/s. If the signal produces standing wave in the guide, then the distance between successive minimal will be
10 mm
20 mm
30 mm
40 mm

⇒ Denominator polynomial of a transfer function of certain network
stable
oscillatory
unstable
depends on numerator polynomial

⇒ In a power amplifier the collector current flows for 270° of the input cycle. The operations is
class A
class B
class AB
class C

⇒ N-channel FETs are superior to p-channel FETs because
mobility of electrons is smaller than that of holes
mobility of electrons is greater than that of holes
they consume less power
they have high switching time

⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz

⇒ In a diode rectifier with a capacitance input filter, a surge current is likely to flow when the circuit is switched on. The cause of this surge current is
the non linear behaviour of diodes
the capacitor acts as a short circuit at the instant of switching,
the inductance of leads
both (a) and (b)

⇒ Which of the following is used as switch?
J-K flip-flop
Master slave J-K flip-flop
T-flip-flop
D-flip-flop

⇒ The transfer function G₁₂ (s) for a two port is
V₂/V₁
V₂ (s)/V₁ (s)
V₂ (s)/I₁ (s)
I₂ (s)/I₁ (s)

⇒ IF amplifiers for radio receivers are often tuned to
456 Hz
456 kHz
3456 MHz
456 GHz

⇒ Consider the following statements a half adder.

As a half subtractor also
has two outputs C_H = x x y and S_n = x ⊕ y for two inputs x and y
has two outputs CH = x + y and SH = x ⊕ y for two inputs x and y
is a combinational circuit

Which of the statements given above is/are correct?
1, 3, 4
1, 2, 4
4 only
2 and 3

⇒ In the assembler, which one of the following is required for variable name in symbol table?
Addresses
Values
Registers
Storage

⇒ A logarithmic amplifier has diode in the feedback path.
TRUE
FALSE

⇒ The contents of stack location after the call operation wil
111
1110
1010
1111

⇒ In the following figure C = 0.02 μF, and V_th is known to be of frequency ω = 10⁷ rad/sec and r_d = 2.5 Ω and Z_Th = R_Th = 10 Ω Then phase angle between i_d and V_{d26.5°
25°
30°
0°}

⇒ In a positive-edge-triggered JK flip-flop, a low J and a low K produce __________ state. A high __________ on the rising edge of the clock.
inactive, reset
active, reset
active, toggle
inactive, toggle

⇒ Consider the following statements:

Race around condition can occur in JK flip flop when both inputs are 1
A flip flop is used to store one bit of information
A transparent latch is a D type flip flop
Master slave flip flop is used to store two bits of information

Which of the above are correct?
1, 2, 3
1, 3, 4
1, 2, 4
2, 3, 4

⇒ The reactance of coupling capacitor for AC signals in an amplifier, should be
as low as possible
as high as possible
neither low nor high
either low or high

⇒ The linear transistor circuits always operate in the
saturation
cut off
active
inactive