Question is ⇒ A sinusoidal voltage of 2 kV peak value is amplitude modulated to give 20% modulation. The peak value of each side band term is, Options are ⇒ (A) 400 V, (B) 200 V, (C) 100 V, (D) 800 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A sinusoidal voltage of 2 kV peak value is amplitude modulated to give 20% modulation. The peak value of each side band term is, Options are ⇒ (A) 400 V, (B) 200 V, (C) 100 V, (D) 800 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A sinusoidal voltage of 2 kV peak value is amplitude modulated to give 20% modulation. The peak value of each side band term is
A.	400 V [Wrong Answer]
B.	200 V [Correct Answer]
C.	100 V [Wrong Answer]
D.	800 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An electron when placed midway between two equal and opposite charges will
remain stationary
oscillate between the charges
be thrown out of the field
spin in the field

⇒ Epitaxial growth is used in ICs
because it produces low parasitic capacitance
because it yields back to back isolating pn junction
to grow single crystal n doped silicon on a single crystal p type substrate
to grow selectively single crystal p doped silicon of one resistivity on a p type substrate of a different resistivity

⇒ Which type of gate is in the given fig
NOR
OR
NAND
EX-OR

⇒ A JFET is a
unipolar device
bipolar device
tripolar device
none of the above

⇒

Assertion (A): For most metals, Fermi energy E_F is less than 10 eV.

Reason (R): Fermi level of a metal is given by E_F = 3.64 x 10^-19 (n)^2/3 where n is number of free electrons/m³ of metal.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The equivalent T circuit of this coupled network is shown in figure. Find the values of Z_A, Z_B and Z_{C-j, 6j, 2j
-j, 2j, 6j
j, 2j, - 6j
j, 2j, 6j}

⇒ When the phase velocity of an EM wave depends on frequency in any medium, the phenomenon is called
scattering
polarization
absorption
dispersion

⇒ To realize the full power of 8086 the pin of 8086 connected to ground is
DEN
ALE
INTR
MN / MX

⇒

Match the following:

	List I (Functional headings of instruction set of 8085)		List II (Functions performed)
A.	Branch group	1.	Compares, rotates etc.
B.	Logic group	2.	Moves, loads, stores etc.
C.	Data transfer group	3.	Initiates conditional or unconditional jumps, calls etc.

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-1, C-2
A-1, B-3, C-2

⇒ In the given figure the input is x(t) = A sin ωt. The steady state output y(tA sin (ωt + φ) where φ = tan^-1 |G(jω)|
|G(jω)| A sin [ωt + ∠G(jω)]
|G(jω)| A sin [2ωt + ∠G(jω)]
A G(jω) sin [ωt + ∠G(jω)]

⇒ For the discrete time system of the given fig
y_k - 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k - 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The noise factor is
1
1.5
2
15

⇒ Which of the following devices is a 'hot-electron' diode?
Thermionic tube diode
Schottky-Barrier diode
Thomson-Deletion diode
Thermal electron diode

⇒ Maximum efficiency of class B power amplifier is 50%.
TRUE
FALSE

⇒ Transistor T₁ operates at 30 kHz and T₂ operates at 300 Hz. The flicker noise is
not depend on frequency
T₁ > T₂
T₁ = T₂
T₁ < T₂

⇒ Which of the following are included in the architecture of a computer?
Addressing modes, CPU
Instruction set, data formats
Secondary memory, operating system
Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
3 only

⇒ If V_r is the reverse voltage across a graded P-N Junction, then the junction capacitance c_j is proportional to
(V_r)²
(V_r)ⁿ
(V_r)^-n
(V_r)^3/2

⇒ The dynamic characteristics of capacitive transducer are similar to those of
LP filter
HP filter
notch filter
band stop filter

⇒ A person with a receiver is 5 km away from the transmitter. What is the distance that this person must move further to detect at 3 dB decrease in signal strength?
942 m
2070 m
4978 m
5320 m

⇒ For a full rectified sine wave, the form factor and peak factor respectively are
1.57 and 2
1.57 and 2
1.11 and 1.11
1.11 and 2

⇒
Assertion (A): Intrinsic resistivity of silicon is lower than that of germanium.
Reason (R): Magnitude of free electron concentration in germanium is more than that of silicon.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of product terms in the minimized sum of product expression obtained through the following k map is (where "d" denotes don't care states)
2
3
4
5

⇒ The contents of F register in 8085 are 01010001. This means
S = 0, Z = 1, AC = 1, P = 0 and CY=1
S = 1, Z = 1, AC = 1, P = 0 and CY=1
S = 1, Z = 0, AC = 1, P = 0 and CY=1
S = 1, Z = 0, AC = 0, P = 0 and CY=1

⇒
Assertion (A): δ(t - b) is an impulse occuring at t = b
Reason (R): Intergal of unit impulse gives unit step function.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The core of a solenoid is made of material of relative permeability μ_r. A small cavity area dA and length dl is cut in the core. If it is desired that flux density in the cavity should be equal to B₀
the fields inside and outside the cavity must be equal
the field inside the cavity must be made stronger than field outside the cavity
the field inside the cavity must be made weaker than the field outside the cavity
none of the above

⇒ Which of the following can provide two or more voice circuits with the same carrier?
SSB
Carrier reinsertion
Lincompex
Independent side band system

⇒ The disadvantage of FM over AM is that
high output power is needed
high modulating power is needed
noise is very high for high frequency
large bandwidth is required

⇒ In terrestrial microwave links, the number of 'fades' per unit increases as
both the transmission and the distance between the antennas are increased
the transmission frequency is increased but the distance between the antennas is decreased
the transmission frequency is decreased but the distance between the antennas is increased
both the transmission frequency and distance between the antennas are decreased

⇒ When a JFET is cut off, it's like an __________ switch and when it is saturated, it's like a __________ switch.
closed, open
open, closed
open, open
closed, closed

⇒ For a 12 pulse operation, the two 6 pulse units are fed by
Y - Y and Y - Y transformers
Δ - Δ and Δ - Δ transformers
Y - Y and Y - Δ transformers
Y - Δ and Y - Δ transformers

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math