Question is ⇒ A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin ωt. The thyristor will conduct, Options are ⇒ (A) from 0 to 180°, (B) when v > 50 V, (C) from 0 to 90°, (D) When v < 50 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin ωt. The thyristor will conduct, Options are ⇒ (A) from 0 to 180°, (B) when v > 50 V, (C) from 0 to 90°, (D) When v < 50 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = V_m sin ωt. The thyristor will conduct
A.	from 0 to 180° [Wrong Answer]
B.	when v > 50 V [Correct Answer]
C.	from 0 to 90° [Wrong Answer]
D.	When v < 50 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit of fi
V_a would always lag V_b
V_a would always lead V_b
V_a and V_b would always be in phase
V_a may lag or lead V_b

⇒ Which one of the following statements is not a property of RL driving point impedance?
The first critical frequency at the origin is a zero
The last critical frequency is a pole
The impedance at S = ∞ always less than the impedance at S = zero
The slope of the impedance curve is positive at all points

⇒ At f = 7 GHz, a 120 cm dish antenna gives a gain of about
50
500
5000
50000

⇒

Match the following:

	List I		List II
A.	C	1.	7 eV
B.	Si	2.	1.15 eV
C.	Ge	3.	0.75 eV
D.	Sn	4.	0.1 eV
E.	Pb	5.	0 eV

A-2, B-3, C-4, D-5, E-1
A-1, B-2, C-3, D-4, E-5
A-3, B-1, C-2, D-5, E-4
A-4, B-5, C-1, D-2, E-3

⇒ Stray capacitance is important at low frequencies.
TRUE
FALSE

⇒ If the switch is thrown to the START position, Q and Y will be equal to
Q = 0, Y = 0
Q= 1, Y= 1
Q = 1, Y = CLK
Q = 0, Y = CLK

⇒ Oscillator with best frequency stability is
Crystal oscillator
Phase shift oscillator
Clapp oscillator
Hartley oscillator

⇒ If V_dc1 is the dc output voltage in half wave controlled rectifier circuit feeding resistive load and V_dc2 is the dc output voltage in full wave controlled rectifier circuit (M - 2 connection) feeding resistive load, then
V_dc1 = 0.5 V_dc2 for all values of firing angle
V_dc1 = V_dc2 for all values of firing angle
V_dc1 ≤ 0.5 V_dc2 for all values of firing angle
V_dc1 ≥ 0.5 V_dc2 for all values of firing angle

⇒ The characteristics of which device has peak point and valley point
SCR
PUT
SCS
Shockley diode

⇒ Which of these is used in seven segment display?
PIN diode
LED
Photo diode
Tunnel diode

⇒ In computers the size of secondary memory is usually much larger than that of primary memory.
TRUE
FALSE

⇒ Vectored interrupt is an interrupt that takes the program to a vector location. TRAP vectors to 0024 FI, RST 7.5 to 003 CH, RST 6.5 to 0034 H and
RST 5.5
RST 6.5
24 H to 48 H
RST 5.5 to 002 CH

⇒ The behaviour of a JFET is similar to that of
NPN transistor
PNP transistor
SCR
Vacuum triode

⇒ The direction in a Yagi Uda antenna is longer than the radiating element.
TRUE
FALSE

⇒ When a diode is forward biased, the diode current is
high
low
zero
low or zero

⇒ Which of the following expressions is invalid in Fortran?
IA + IB
IB * IC / ID
IA * B
- K * I + J

⇒ Flow charts that contain decision sy
represent straight line programs
do not represent straight line programs
all of the above
none of the above

⇒ The Z parameters Z₁₁ and Z₂₁ for the 2-port network in the fig
Z₁₁ = - 6/₁₁Ω; Z₂₁ = 16/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = 4/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = - 16/₁₁Ω
Z₁₁ = 4/₁₁Ω; Z₂₁ = 4/₁₁Ω

⇒

Match the following:

	List I		List II
A.	V_OH(min)	1.	2.4 V
B.	V_IH(min)	2.	1.5 V
C.	V_OL(max)	3.	0.4 V
		4.	2.0 V
		5.	0.8 V

A-1, B-3, C-4
A-1, B-4, C-3
A-5, B-4, C-3
A-1, B-5, C-2

⇒ Transfer function of a linear system is 200 e^-j10ω The system is a
distortionless Attenuator
amplifier with Phase distortion
distortionless Amplifier
attenuator with Phase distortion

⇒

Assertion (A): In a BJT, a_dc is about 0.98.

Reason (R): In a BJT, recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which chopper circuit uses saturable reactor?
Auxiliary commutated
Jones chopper
Morgan chopper
Load commutated

⇒ For a standard 2nd order system the maximum overshoot is 10% to an unit step input. If the magnitude of the input is doubled, then maximum overshoot and percentage of maximum overshoot is:
maximum overshoot doubles and percentage of maximum overshoot is less than double
maximum overshoot doubles and percentage of maximum overshoot do not change
maximum overshoot remain same and percentage of maximum overshoot is double
maximum overshoot more than double and percentage of maximum overshoot is less than double

⇒ Assuming accumulator contain A 64 and the carry is set (1).What will register A and (CY) contain after RAR?
4 DH, 0
D 3H, 0
4 DH, 1
53 H, 0

⇒ For an RC impedance function
all poles lie on jω axis
all poles are simple ,
all poles are simple and lie on negative real axis
none of the above

⇒ A current 10 sin (200t) A flows through a 5 mH inductance. The expression for voltage is
10 sin (200t + 90°)
10 sin (200t - 90°)
10 sin(1000t + 90°)
10 sin (1000t - 90°)

⇒ Elements R, L, C are connected in parallel and excited by a dc current I. If i_R, i_L and i_C are the currents through R, L, C respectively then at t = 0
i_R > i_L > i_C
i_L > i_R > i_C
i_C = 0
i_C = I

⇒ For Disk partitioning th DOS command is
F DISK
H DISK
A DISK
D DISK

⇒ In a CE amplifier circuit, the output voltage
is very small
is always constant
depends on β
none of the above

⇒ In van der walls crystals, there exists a high degree of stability of the outer electron shell.
TRUE
FALSE