Question is ⇒ A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR, Options are ⇒ (A) is forward biased, (B) is reverse biased, (C) may be forward biased or reverse biased, (D) forward biased initially but reverse biased afterwards, (E) , Leave your comments or Download question paper.

Question is ⇒ A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR, Options are ⇒ (A) is forward biased, (B) is reverse biased, (C) may be forward biased or reverse biased, (D) forward biased initially but reverse biased afterwards, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
A.	is forward biased [Wrong Answer]
B.	is reverse biased [Correct Answer]
C.	may be forward biased or reverse biased [Wrong Answer]
D.	forward biased initially but reverse biased afterwards [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ To realize following function 'f'
3
6
4
10

⇒
Match the following:
List I (Characteristics) List II (Device)
A. Voltage controlled device 1. BJT
B. Current controlled device 2. UJT
C. Conductivity modulation device 3. FET
D. Negative conductance device 4. Impatt diode

A-2, B-3, C-1, D-1
A-2, B-3, C-4, D-1
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2

⇒ The ac motor used in servo applications is
single phase induction motor
two phase induction motor
3 phase induction motor
synchronous motor

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What must be the minimum gain of the oscillator to provide oscillations?
40
60
100
130

⇒ Consider the following BJT circ
2.46 kΩ
2.88 kΩ
200 Ω
18.48 Ω

⇒ A remote control of TV uses a 10 bit word. The maximum number of total commands it can transmit is
64
256
512
1024

⇒ As the reverse voltage is increased, the depletion layer
becomes narrow
widens
remains the same
reduce to zero

⇒ Epitaxial growth is used in IC_s
because it produces low parasitic capacitance
because it yields back to back isolating pn Junction
to grow single crystal n doped silicon on a single crystal P-type substrate
to grow Selectivity single crystal P doped silicon of one resistivity on a P type substrate of a different resistivity

⇒ The generic microprocessor contains a zero and a carry flag. These are located on
interrupt control
status register
either (a) or (b)
none of the above

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ A current source inverter has simple commutation circuit.
TRUE
FALSE

⇒ Which of the following is also called handshaking programmed data transfer?
Synchronous transfer
Asynchronous transfer
Interrupt driver transfer
Both (a) and (c)

⇒ A dual trace CRO has
one electron gun
two electron guns
one electron gun with one two pole switch
two electron guns with one two pole switch

⇒ The primary reason for the widespread use of Si in semiconductor device technology is
abundance of Si on the surface of earth
larger band gap of Si in comparison to Ge
favourable properties of Silicon-dioxide (SiO₂)
lower melting point

⇒ In a reactance function
all poles are simple
all poles and zeros are simple
all poles and zeros are simple and lie on jω axis only
all poles and zeros lie on negative real axis

⇒ As per BIS, solid insulators are classified into 6 categories.
TRUE
FALSE

⇒ To find current in a resistance connected in a network, Thevenin's theorem is used V_TH = 20 V and R_TH = 5 Ω. The current through the resistance
is 4 A
is 4 A or less
is less than 4 A
may be 4 A or less or more than 4 A

⇒ A 12-bit binary counter has the following state. The octal number represente
677
7163
7128
7183

⇒ An angle modulated signal is expressed by f_a(t) = cos (2 x 10⁸ pt) + 75 sin (2 x 10³ pt). The peak frequency deviation of the carrier is
1 kHz
7.5 kHz
75 kHz
100 MHz

⇒ In a synchro transmitter
input is angular position of rotor shaft and output is stator voltages
input is stator voltages and output is angular position of shaft input is rotor voltage and output is angular position of rotor shaft
input is rotor voltage and output is angular position of rotor shaft
input is angular position of rotor shaft and output is rotor voltage

⇒
Match the following:
List I List II
A. p type semiconductor 1. silicon
B. n type semiconductor 2. holes are majority carriers
C. Intrinsic semiconductor 3. electrons are majority carriers
D. Tungsten 4. is a metal

A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-1, C-2, D-4

⇒ In a TV, studio the function of vision switcher is to
edit television programs
relay television programs
control zoom lens
mix audio and video signals

⇒ Present day stereophonic systems have
only CD playback facility
only tape playback facility
both CD and tape playback facilities along with radio
none of the above

⇒ Dielectric loss due to polarisation occurs in
bipolar dielectrics
non-metallic dielectrics
liquid dielectrics
all of the above

⇒ The slope of the transfer characteristics of an N-channel JFET is
positive
negative
constantly varying
zero

⇒ In an ordinary thyristor
turn on and turn off times are equal
turn on time is more than turn off time
turn off time is more than turn on time
turn on time may be equal, less than or more than turn off time

⇒ Find V_o(t) for the following circ
0 V
5 V
3 V
2 V

⇒ What is the address space of 8086 CPU?
One Megabyte
256 Kilobytes
1 K Megabytes
64 Kilobytes

⇒ The capacitance of a parallel plate capacitor varies as per the equation C(t) = C₀ (1 - cos ωt). It is connected to a battery of V volts. The equation for current is
ωC₀V (1 - cos ωt)
ωC₀V(1 - sin ωt)
ωC₀V (1 - sin 2ωt)
ωC₀V sin ωt

⇒ If reflection coefficient is 1/5, then corresponding VSWR is given by
1
2
3
42796

	List I (Characteristics)		List II (Device)
A.	Voltage controlled device	1.	BJT
B.	Current controlled device	2.	UJT
C.	Conductivity modulation device	3.	FET
D.	Negative conductance device	4.	Impatt diode

	List I		List II
A.	p type semiconductor	1.	silicon
B.	n type semiconductor	2.	holes are majority carriers
C.	Intrinsic semiconductor	3.	electrons are majority carriers
D.	Tungsten	4.	is a metal

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math