Question is ⇒ A single layer air cored coil has n turns and inductance L. If a new coil is formed by having 2n turns while keeping the coil length and diameter the same, the new inductance is, Options are ⇒ (A) 0.5 L, (B) L, (C) 2 L, (D) 4 L, (E) , Leave your comments or Download question paper.

Question is ⇒ A single layer air cored coil has n turns and inductance L. If a new coil is formed by having 2n turns while keeping the coil length and diameter the same, the new inductance is, Options are ⇒ (A) 0.5 L, (B) L, (C) 2 L, (D) 4 L, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A single layer air cored coil has n turns and inductance L. If a new coil is formed by having 2n turns while keeping the coil length and diameter the same, the new inductance is
A.	0.5 L [Wrong Answer]
B.	L [Wrong Answer]
C.	2 L [Wrong Answer]
D.	4 L [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When a p-n junction is forward biased. The width of depletion layer decreases.
TRUE
FALSE

⇒ In a purely inductive ac circuit the power curve is a sinusoid of the same frequency as the voltage.
TRUE
FALSE

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒ For a delayed half wave rectified wave, the average and rms values are lower than those for half wave.
TRUE
FALSE

⇒ The merging of a hole and an electron is called
recombination
covalent bonding
thermal union
none of the above

⇒ The Voltage e₀ in the figu
2 V
4 V
4/3 V
8 V

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ If short-circuited and open circuited impedances are 5 ohms and 20 ohms, then characteristic impedance is
1 ohms
10 ohms
25 ohms
100 ohms

⇒ The feedback technique employed in the following circuit
voltage series feedback
current series feedback
voltage shunt feedback
current shunt feedback

⇒ The density of dynamic RAM is
the same as static RAM
less than that of static RAM
more than that of static RAM
either equal or less than that of static RAM

⇒ Microwave links are typically 50 km apart
because of atmospheric attenuation
because of output tube power limitation
because of earth's curvature
to ensure that applied dc voltage is not excessive

⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I²/2 pr
I²/4 pr

⇒ Twelve 1 Ω resistance are used as edges to form a cube. The resistance between two diagonally opposite corners of the cube is
5/6 Ω
1 Ω
6/5 Ω
3/2 Ω

⇒ A two port network is symmetrical if
z₁₁ z₁₂ - z₁₂ z₂₁ = 1
AD - BC = 1
h₁₁ h₂₂ - h₁₂ h₄₁ = 1
y₁₁ y₂₂ = y₁₂ y₂₁ = 1

⇒ What kind of signal does the times produce?
Single pulse
Square wave
Continuous pulse
No signal

⇒ In a TWT the axial component of electric field advances along the tube
at a velocity that is almost equal to speed of light
at a velocity that is a small fraction of speed of light
at a velocity that is about 50% of speed of light
at a velocity that may be even more than speed of light

⇒ The circuit in figure has reached steady values with switch open. If switch is closed at t = 0 the voltage across 2 μF capacitance at t = 0^{+zero
4 V
6 V
10 V}

⇒ Which of the following is a vector quantity?
Standing wave ratio
Reflection coefficient
Gain
All of the above

⇒ The real part of complex dielectric constant and tanδ for a dielectric are 2.1 and 5 x 10^-4 at 100 Hz respectively. The imaginary part of dielectric constant at 100 Hz is
1.05 x 10^-3
2.1 x 10^-3
5 x 10^-3
1.05 x 10^-2

⇒ The function shown in figure, can represent a probability density function for A _______
A = 1/4
A = 1/6
A = 1/9
A = 1/2

⇒ x = AX + Bu is a state equation.
TRUE
FALSE

⇒ Frequency shift keying is used mostly in
telephony
telegraphy
radio transmission
none of the above

⇒

Assertion (A): Superposition theorem can be used to find the output of a full wave rectifier excited by sinusoidal signal sources of different frequencies connected in series.

Reason (R): Superposition theorem is valid for all linear systems.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): Demorgan's first theorem replaces a NOR gate by bubbled AND gate.

Reason (R): Double complement of a variable equals the variable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Modulated carrier power in FM
increases with modulating signal power
decreases with modulating signal power
is independent of the modulating signal power
none

⇒ A particular green LED emits light of wavelength 5490, Å, the energy bandgap of the semiconductor material used there is .. h = 6.6 x 10^-34 J sec.
2.26 eV
1.98 eV
1.17 eV
0.74 eV

⇒ Which of the following is 'synchronous'?
Half adder
Full adder
R-S flip-flop
Clocked R-S flip-flop

⇒ As compared to a full wave diode rectifier circuit using centre tapped transformer, the bridge diode rectifier circuit has the main advantage of
higher current carrying capacity
higher efficiency
lower ripple factor
lower PIV

⇒ In a uniformly doped BJT, assume that N_E, N_B and N_C are the emitter, base and collector dopings in atoms/cm³, respectively. If the emitter injection efficiency of the BJT is close unity, which one of the following conditions is TRUE?
N_E = N_B = N_C
N_E >> N_B and N_B > N_C
N_E = N_B and N_B < N_C
N_E < N_B < N_C

⇒

Assertion (A): Transient analysis uses Laplace transformation.

Reason (R): Laplace transform method is suitable for solution of integro differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true