Question is ⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The minimum sampling rate is :, Options are ⇒ (A) 62831.9 V/sec, (B) 125663.8 V/sec, (C) 31415.95 V/sec, (D) None, (E) , Leave your comments or Download question paper.

Question is ⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The minimum sampling rate is :, Options are ⇒ (A) 62831.9 V/sec, (B) 125663.8 V/sec, (C) 31415.95 V/sec, (D) None, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The minimum sampling rate is :
A.	62831.9 V/sec [Correct Answer]
B.	125663.8 V/sec [Wrong Answer]
C.	31415.95 V/sec [Wrong Answer]
D.	None [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If f(t) = - f(- t) satisfies Drichlet conditions, then f(t) can be expanded in Fourier series containing
only sine terms
only cosine terms
cosine terms and constant
sine terms and constant

⇒ FIR digital filter having __________ stability than FIR filter.
good stability
poor stability
stability not guarnteed
poor stability

⇒ In the circuit shown in the fi
only red will glow
only green will glow
both red and green will glow
none will glow

⇒ The Hilbert transform of cos ω₁t + sin ω₂t is
sin ω₁t + cos ω₂t
sin ω₁t - cos ω₂t
cos ω₁t - cos ω₂t
sin ω₁t + sin ω₂t

⇒ Which of the following flip flops cannot be converted to D flip flop?
JK
SR
Master slave
None of the above

⇒ A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be
20 ∠20° A
10 ∠20° A
14.14 ∠20° A
10 ∠- 20° A

⇒ In a synchro transmitter
input is angular position of rotor shaft and output is stator voltages
input is stator voltages and output is angular position of shaft input is rotor voltage and output is angular position of rotor shaft
input is rotor voltage and output is angular position of rotor shaft
input is angular position of rotor shaft and output is rotor voltage

⇒ The pole zero plot of the given figure is
non-minimum phase function
minimum phase function
all pass function
none of the above

⇒

Assertion (A): In a full wave rectifier output the lowest ac component is at twice the input frequency

Reason (R): In a full wave rectifier, the output waveform consists of half sinusoids

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ If x_k = 2^k for k ≤ 0 and = 0 for k > 0 X(z) = 2/(2 - z).
TRUE
FALSE

⇒

Assertion (A): Most of actual systems are non-linear.

Reason (R): Non linearity may be due to saturation, dead zone, square law etc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Double spotting in a receiver is due to
poor sensitivity of RF amplifier
high gain of IF amplifier
inadequate image frequency rejection
all of the above

⇒ At t = 0⁺, the current i_{1- V/2R
- V/4R
- V/R
zero}

⇒ The following circuit diagram resembl
logic 0
logic 1
f(A, B, C) = Σm(0, 1, 4, 6, 7)
none

⇒ A receiver has poor selectivity. It will also have poor
sensitivity
double spotting
blocking
diversity reception

⇒ In a flash type ADC, employing 15 comparators resolution with 10 volts reference; is expected to be :
0.625 V
0.656 V
0.525 V
insufficient data

⇒

Assertion (A): The maximum range of a radar is proportional to fourth root of the peak transmitted pulse power.

Reason (R): Radar signals are subjected twice to inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is a valid integer variable in FORTRAN 77?
ALPHA
NEXT
BANGLORE
ABC

⇒ Which of the following is the point of reference JFET?
Drain
Gate
Source
None of the above

⇒ Which one of the following is the correct statement of the system characterized by the equation y(t) = ax(t) + b?
linear for any value of b
linear if b > 0
linear if b < 0
non-linear

⇒ The reduced form of the func
A(C D + E F + D E) + D E
(A + C + D + E)(D + E + F)
(C + D + E + A)(A + D + E + F)
A C D + A E F + A(D ⊕ E)

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate

⇒ The currents fed to the two dipoles of turnstile antenna are
in phase
in quadrature
in phase opposition
either (a) or (c)

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ At resonance, the parallel circuit constituted by an iron-cored coil and a capacitor behaves
open circuit
short circuit
pure resistor of value R
pure resistor of value much higher than R

⇒ Microprocessors were introduced in the year
1951
1961
1971
1981

⇒ A computer monitor uses 180 W in normal operation and 20 W in sleep mode. The computer is on all the 24 hours but is in sleep mode for 18 hours a days. The energy units saved in 30 days are
0.54 units
86.4 units
2.88 units
4.8 units

⇒

Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement

Reason (R): Large value capacitor can also be fabricated on a chip

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ In a second order system, the time constant t of exponential envelopes depends
only on damping factor
only on natural frequency
both on damping factor and natural frequency
neither on damping factor nor on natural frequency