Question is ⇒ A signal occupies a band 5 kHz to 10 kHz. For proper error free reconstruction at what rate it should be sampled?, Options are ⇒ (A) 10 kHz, (B) 20 kHz, (C) 5 kHz, (D) (10 + 5) x 2 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ A signal occupies a band 5 kHz to 10 kHz. For proper error free reconstruction at what rate it should be sampled?, Options are ⇒ (A) 10 kHz, (B) 20 kHz, (C) 5 kHz, (D) (10 + 5) x 2 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A signal occupies a band 5 kHz to 10 kHz. For proper error free reconstruction at what rate it should be sampled?
A.	10 kHz [Correct Answer]
B.	20 kHz [Wrong Answer]
C.	5 kHz [Wrong Answer]
D.	(10 + 5) x 2 kHz [Wrong Answer]
View Answer 2 -7 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When narrow current pulses drive a high Q resonant circuit the voltage across the circuit looks like
narrow pulses
half sine wave
almost sine wave
either (a) or (b)

⇒ For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is
sin^-1 ξ
cos^-1 ξ
tan^-1 ξ
cot^-1 ξ

⇒ Which one of following is correct condition to check the stability of system?
Bounded I/P unbounded O/P
Bounded I/P and O/P
Bounded O/P and I/P
Bounded I/P Bounded O/P

⇒ When a CE transistor is cut off
voltage across collector reduces to zero
voltage across collector is maximum
maximum collector current flows
maximum voltage appears across the load resistance

⇒ For measurement of high voltage capacitors the suitable bridge is
Wien bridge
modified De Sauty bridge
Schering bridge
either (a) or (b)

⇒

Assertion (A): An op-amp has high voltage gain, high input impedance and low output impedance

Reason (R): Negative feedback increases output impedance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In FM, increased depth of modulation increases
modulation
modulation index
bandwidth
all of the above

⇒ The circuit diagram shown in the figure consists of transistors
parallel connection
cascade connection
darlington connection
series connection

⇒ The magnitude plot of a composite signal x(t) = e^2jt + e^3jt is
Half wave rectified sinusoid
Full wave rectified sinusoid
Exponentially increasing sinusoid
Exponentially decreasing sinusoid

⇒ If f(t)↔ F(jω), and f(t) is real, then F(- jω)
F(jω)
F*(j↔)
F*(- jω)
none of these

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒ In a 3 phase bridge inverter with 180° mode of operation the numbers of thyristors conducting at one time are
1
2
3
4

⇒ An inductance having X_L = 5 Ω and a capacitance having X_C = 5 Ω are connected in parallel across 100 V, 50 Hz supply. The current drawn from source is
zero
20 A
40 A
28.28 A

⇒ The dissipation at the collector is in the quiescent state and increases with excitation in the case of a
class A series fed Amplifier
class A transistor coupled Amplifier
class AB amplifier
class B amplifier

⇒ The function off an oxide layer in an IC device is to

mask against diffusion or ion implantation
insulate the surface electrically
increase the melting point of Si
produce a chemically stable protective layer

1, 2, 3
1, 3, 4
2, 3, 4
4, 1, 2

⇒ A JK flip flop can be converted to D flip flop by
Connecting both J and K terminals to D
Connecting J terminal to D and leaving K open
Connecting K terminal to D and leaving J open
Connecting J terminal to D and K terminal to D through an inverter

⇒ In some on-off controllers a differential gap is provided
to make the manufacture process easier
to prevent too often frequent operation of controller
both (a) and (b)
neither (a) nor (b)

⇒ In a series inverter
the commutating elements carry full load current
the commutating elements carry upto 50% of load current
the commutating elements do not carry load current
any of the above

⇒ As frequency increases, the transmission efficiency
decreases
increases
is not affected
either (a) or (c)

⇒ A bulb rated at 60 W, 120 V is used for 30 minutes. The charge associated with this operation is
3600 C
900 C
7200 C
600 C

⇒ If x_k = a^k and k &l
TRUE
FALSE

⇒ In figure I_D = 4 mA. Then V_{S20 V
4.4 V
0.4 V
0.44 V}

⇒ Two coil have their axis perpendicular to each other. The coefficient of coupling k is
1
0.5
more than 0 but less than 1
0

⇒ The depletion layer in a reverse biased p-n junction is due to the presence of
electrons
holes
both electrons and holes
immobile ions

⇒ Threshold of perception occurs at a current of about 1 mA.
TRUE
FALSE

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ In a conventional AM superhetrodyne receivers, the detectors employed to extract intelligence include
Peak detectors
Ratio detectors
PLL
Slope detectors

⇒

Assertion (A): JFET is a voltage controlled device.

Reason (R): The drain current can be controlled by controlling V_GS.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The two conductors of a single phase transmission line suspended in air carry currents in opposite directions. The force per unit length on each conductor varies
directly as the current in either conductor
directly as the distance between the two conductors
directly as the square of the current in either conductor
inversely as the square of the distance between the two conductors

⇒ The integral of a unit impulse is unit step function.
TRUE
FALSE