Question is ⇒ A signal is x + f(t) where x is constant and f(t) is a power signal with zero mean value. The power of the signal is, Options are ⇒ (A) x2, (B) x2 + f2(t), (C) more than x2 + f2(t), (D) less than x2 + f2(t), (E) , Leave your comments or Download question paper.

Question is ⇒ A signal is x + f(t) where x is constant and f(t) is a power signal with zero mean value. The power of the signal is, Options are ⇒ (A) x2, (B) x2 + f2(t), (C) more than x2 + f2(t), (D) less than x2 + f2(t), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A signal is x + f(t) where x is constant and f(t) is a power signal with zero mean value. The power of the signal is
A.	x² [Wrong Answer]
B.	x² + f²(t) [Correct Answer]
C.	more than x² + f²(t) [Wrong Answer]
D.	less than x² + f²(t) [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure which diode will conduct and what will be the value of V_{0D₃, 1 V
D₁, 2 V
D₂, 5 V
D₁, 5 V}

⇒ The logic represented by the abbreviation ECL is
Emitter Coupled Logic
Electron Carrier Logic
Encoding Clock Logic
Electrostatic Channel Logic

⇒

Assertion (A): SSB and ISB receivers have good S/N ratio

Reason (R): SSB and ISB receivers have good suppression of adjacent channels.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is true about an impulse voltage?
It is a unidirectional voltage
Chopped impulse flashover does not occur
Time taken to rise is equal to time taken to fall
RMS value is always less than 50% of average value

⇒ Consider the following registers:

A accumulator and B register
B and C registers
D and E registers
H and L registers

Which of these 8-bit registers of 8085 μP can be paired together to make a 16-bit register?
1, 3 and 4
2, 3 and 4
1 and 2
1, 2 and 3

⇒ The range of values of a and b for which the linear time invariant system with impulse respon
|a| > 1, |b| > 1
|a| < 1, |b| < 1
|a| < 1, |b| > 1
|a| > 1, |b| < 1

⇒ The applications of shift registers are

Time delay
Ring counter
Serial to parallel data conversion
Serial to serial data conversion

Which of the above are correct?
1, 2, 3
2, 3, 4
1, 2, 3, 4
1, 2, 4

⇒ Hue of a colour means
amount of light energy received by eye
predominant spectral purity of colour light
amount of other colours present
none of the above

⇒ Nichrome is used for
overload line wires
heater coils
lamp filaments
all of the above

⇒ A λ/8 section of transmission line is determined of load impedance of (2 - j 5) Ω. If characteristic impedance of line is 10 Ω. Then input impedance of line is
10 Ω
(6.9 + j 7.24) Ω
(1.75 + j 3.098) Ω
(2 - j 5) Ω

⇒ Broadcasting antennas are generally
omnidirectional type
vertical type
horizontal type
helical

⇒ It is desired to clean up ragged looking pulsed that have been distorted during transmission from one place to another, which of the following device will be appropriate?
Multiplexer
D/A converter
JK flip-flop
Schmitt trigger

⇒ If a microcomputer has a 64 K memory; what is the hexadecimal notations for the last memory location?
1111
1A1A
EEEF
FFFF

⇒ The product of which of the following gives the figure of merit of a logic family?
Gain and bandwidth
Propagation delay time and power dissipation
Fan-out and propagation delay time
Noise margin and power dissipation

⇒ A bulb rated at 60 W, 120 V is used for 30 minutes. The charge associated with this operation is
3600 C
900 C
7200 C
600 C

⇒ Generally a servomotor operates at
high torque and high speed
low torque and low speed
low torque and high speed
high torque and low speed

⇒ The secondary constants of a line are
Z₀
Z₀ and γ
Z₀, γ and wave velocity
Z₀, γ and L

⇒ Switching systems
are limited to small data networks
require additional lines
are not used in data system
improve the efficiency of data transfer

⇒ The effective electrical length of an antenna is __________ its physical length
greater than
equal to
less than
none of the above

⇒ In a DM system, the granular noise occurs when modulating signal
decrease Rapidly
increase
has high frequency component
change within step size

⇒ Measurement of non-electrical quantity involves the following subsystems

Amplifier block
Display block
Instrumentation block
Transducer block

The correct sequence of these blocks is
4, 1, 3, 2
4, 3, 1, 2
1, 3, 2, 4
1, 2, 3, 4

⇒ A ripple in collector supply voltage of the output stage of amplifier causes noise.
TRUE
FALSE

⇒ In 8085 microprocessor system, can an input and output port have same port address?
Yes
No
Insufficient data
None of these

⇒ A 4 bit ripple counter starts in 0000 state. When the counter reads 0010 the number of clock pulses which have occurred is
2
18
2 or 18
2 or 18 or 34

⇒ The stud in a stud mounted SCR acts as
anode
cathode
gate
anode or cathode

⇒ Given a power supply filter circuit, what measurements must be made of determine percentage regulation
current through and voltage across the capacitor
d.c. load voltage and r.m.s. load voltage
current through load and voltage across load resistance
number of turns and gauge of secondary winding of transformer

⇒ In a perfect conductor the resistor noise is
maximum
zero
very high
almost infinite

⇒ For operation of enhancement only N-channel MOSFET, value of gate voltage has to be
zero
low positive
high negative
high positive

⇒ To convert SR latch to D latch
connect both S and R to D
connect D to S directly and D to R through inverter
connect D to R directly and D to S through inverter
connect S to D and leave R open

⇒ The input voltage for starting oscillations in an oscillator is caused by
negative feedback
positive feedback
noise voltage in resistors
a special generator