Question is ⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency fc such, Options are ⇒ (A) 0.5 M(f + fc), (B) 0.5 M(f - fc), (C) 0.5 M(f + fc) + 0.5 M(f - fc), (D) 0.5 M(f - fc) + 0.5 M(f - fc), (E) , Leave your comments or Download question paper.

Question is ⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency fc such, Options are ⇒ (A) 0.5 M(f + fc), (B) 0.5 M(f - fc), (C) 0.5 M(f + fc) + 0.5 M(f - fc), (D) 0.5 M(f - fc) + 0.5 M(f - fc), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
A.	0.5 M(f + f_c) [Wrong Answer]
B.	0.5 M(f - f_c) [Wrong Answer]
C.	0.5 M(f + f_c) + 0.5 M(f - f_c) [Correct Answer]
D.	0.5 M(f - f_c) + 0.5 M(f - f_c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.
3 x 10⁸ m/sec
5 x 10⁸ m/sec
1.5 x 10⁸ m/sec
9 x 10⁸ m/sec

⇒ A cycloconverter uses
natural commutation
forced commutation
either natural or forced commutation
both natural and forced commutation together

⇒ In a R-L-C circuit at resonance is
maximum in series resonance and minimum in parallel resonance.
maximum in parallel resonance and minimum in series resonance
minimum in both series and parallel resonances
maximum in both series and parallel resonances.

⇒ It two voltages are v₁ = 100 sin (ωt - 30°) and v₂ = cos ω t then
v₁ is leading v₂ by 30°
v₂ is leading v₁ by 30°
v₂ is leading v₁ by 60°
v₁ is leading v₂ by 60°

⇒ Which of the following is used to generate PDM?
Free running multi-vibrator
Monostable multi-vibrator
JK flip-flop
Schmitt trigger

⇒ A transmission line terminates in two branches, each of length λ/4, as shown. The branches are terminated by 50Ω loads. The lines are lossless and have the characteristics impedances shown. Determine the impedance Z₁ as seen by the so
200Ω
100Ω
50Ω
25Ω

⇒ There is no radiation at right angles to the plane of the array, is end fire array.
TRUE
FALSE

⇒ Given below impulse response of two sys
h₁(n) non causal and stable
h₁(n) non causal and stable
h₁(n) causal and not stable
h₁(n) causal and stable

⇒ Signal flow graph is used to find :
stability of the system
controllability of the system
transfer function of the system
poles of the system

⇒ The current in a p-n junction diode with V volts applied in p region relative to n region (where I₀ is reverse saturation current, m is ideality factor, k is Boltzmann's constant, T is absolute temp and q is charge on electron) is
I₀ (e^-qV/mkT - 1)
I₀ e^-qV/mkT
I₀ (e^qV/mkT)
I₀ (e^qV/mkT - 1)

⇒ In a practical oscillator, the magnitude of loop gain Aβ is kept slightly larger than unity and the amplitude of oscillations is limited by
the ratio of A to β
the on set of non-linearity of amplifying device
the linearity of amplifying device
all of the above

⇒ The type of noise that interfere very much with high frequency transmission is
white
transit time
flicker
shot

⇒ Microprocessors were introduced in the year
1951
1961
1971
1981

⇒ Substitution theorem applies to
Linear network
Non linear network
Linear time invariant network
Any network

⇒

Assertion (A): When a wattmeter is used for low impedance loads, the pressure coil is connected across the load.

Reason (R): A wattmeter measures apparent power.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The percentage limiting error in an instrument reading 8.3 V and having guaranteed accuracy of 1% of the full scale reading and range of 0-150 V is
0.0181
0.00181
0.181
0.000018

⇒ If the drift velocity of holes under a field gradient of 100 V/m in 5 m/s, their mobility (in SI units) is
0.05
0.5
50
500

⇒ The purpose of connecting a coupling capacitor in the output circuit of an amplifier is
to increase voltage gain
to increase collector current
to block dc collector voltage
all of the above

⇒ If transfer function of a system is H(z) = 6 + z^-1 + z^-2 then system is
minimun phase
maximum phase
mixed phase
none

⇒ In a minimum function
the degree of numerator is higher than that of denominator
the degree of numerator is lower than that of denominator
the degree of numerator and denominator are equal
the denominator is a constant

⇒ In a klystron amplifier dc electron velocity is v₀ and dc electron charge density is r₀ the dc beam current is
r₀v₀
r₀^/v₀
v₀^/r₀
(v₀^/r₀)²

⇒

Assertion (A): If an electron having charge e is revolving in an orbit of radius R and with angular velocity ω, the magnetic dipole moment of orbit is 0.5 eωR².

Reason (R): Orbital angular momentum and magnetic dipole moment are always equal.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The pole zero plot of the given figure is
non-minimum phase function
minimum phase function
all pass function
none of the above

⇒ Consider the following statement in Fortran 77 3 values would be read and stored in X (0), X (1), X (2)
4 values would be read and stored in X (0), X (1), X (2), X (3)
5 values would be read and stored in X (0), X (1), X (2), (3)(4)
5 values would be read and stored in X (I), X (2), X (3), X (4), X (5)

⇒ Armoured submarine cable is used
to prevent insulation breakdown due to high voltage
to protect cable at great depths.
to prevent inadverent damage due to ploughing in
for the shallow shore ends of cable.

⇒ Which one is discrete time periodic signal?
sin 3pn
cos 2pn
sin 3pn
all

⇒ In a Hurwitz polynomial
all coefficients are non-negative
both the odd and even parts have roots on jω axis
the continued fraction expansion is the ratio of odd to even parts of a Hurwitz polynomial yields all positive quotient terms
all of the above

⇒ The threshold voltage of a MOSFET can be lowered by

using thin gate oxide
reducing the substrate concentration
increasing the substrate concentration.

Of the above statement
3 alone is correct
1 and 2 are correct
1 and 3 are correct
2 alone is correct

⇒ The number of doped regions in a SCR is
2
3
4
5

⇒ If D is diameter of circular waveguide the cutoff wave-length for TE₁₁ mode is equal to
1.706 D
2.11 D
0.82 D
0.41 D