Question is ⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about, Options are ⇒ (A) 1000 Hz, (B) 2000 Hz, (C) 1025 Hz, (D) 975 Hz, (E) , Leave your comments or Download question paper.

Question is ⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about, Options are ⇒ (A) 1000 Hz, (B) 2000 Hz, (C) 1025 Hz, (D) 975 Hz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
A.	1000 Hz [Wrong Answer]
B.	2000 Hz [Wrong Answer]
C.	1025 Hz [Wrong Answer]
D.	975 Hz [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure V_CC = + 30 V, I_C corresponding to Q point is 1 mA. If R_C = 5 kΩ and R_E = 5 kΩ, V_CE corresponding to Q poin
30 V
20 V
25 V
5 V

⇒ LVDT is used to measure
displacement
pressure
temperature
any of the above

⇒ For dc the current through coupling capacitor in CE amplifier circuit is
very high
high
low
zero

⇒ In a single phase full wave regulator feeding a resistive load, the average current over one full cycle
is always zero
cannot be zero
may be sometimes zero
is always positive

⇒ In Java which operator can be used even if there is a single operand
+
-
*
%

⇒ Which of the following codes is based on BCD format?
EBCDIC
ASCII
Hollerith
both (a) and (b)

⇒ In Pulse Code Modulation system
large bandwidth is required
quantising noise can be overcome by companding
quantising noise can be reduced by decreasing the number of standard levels
suffers from the disadvantage of its incompatibly with TDM

⇒

Assertion (A): The circuit of figure thyristor will conduct for 180° during positive half cycle if it is continuously fir
Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Microwave link repeaters are typically 50 km apart in TV transmission due to
atmosphere attenuation
output power tube limitations
attenuation of surface wave
earth's curvature

⇒ The rms voltage measured across each of the circuit element in figure is as shown, when the circuit is excited by a sinusoidal voltage E_s, the rms value of the source voltage e_{s10 volt
2 volt
E_s
5 volt}

⇒ The essential condition for antenna array to be linear is that
individual antennas of the array must be of equal size
individual antennas of the array must be equally spaced along a straight line
any two individual antennas of the array must not be in the same direction
none of the above

⇒ In brushless excitation system of modern alternators, the main exciter is
dc generator
ac generator
either dc or ac generator
induction generator

⇒ Both ROM and RAM can be accessed randomly.
TRUE
FALSE

⇒ The converter whose conversion time is independent of number of bits is
dual stope
counter type
parallel conversion
successive approximation

⇒ Which one of the following is not necessarily an advantage of the phase cancellation method of obtaining SSB over the filter method?
It is possible to generate SSB at any frequency
SSB with lower audio frequencies present can be generated
Switching from one sideband to other is simpler
There are more balanced modulators; therefore the carrier is suppressed better

⇒ In an inverting amplifier using op-amp the current input to the inverting terminal
is equal to the current through feedback resistance
is less than the current through feedback resistance
is more than the current through feedback resistance
may be equal to, less or more than current through feedback resistance

⇒ Loading effect is primarily caused by instruments having
high resistance
high sensitivity
low sensitivity
high range

⇒ The length of half-wave antenna is at 30 MHz
2.5 meter
5 meter
10 meter
100 meter

⇒ In a specimen of n type semiconductor, the initial concentration of holes and electrons is p_no and n_no. When the specimen is subjected to radiation, the hole and electron concentration increase to p_n and n_n. Then
p_n - p_no = n_n - n_no
p_n + p_no = n_n + n_no
p_n - p_no = n_no + n_no
p_n + p_no = n_n - p_no

⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5

⇒ Which of the following is taken as reference antenna for directive gain?
Half wave dipole
Elementary doublet
Isotropic
Infinitesimal dipole

⇒ Current density has the dimensions
IL
IL^-2
IL^-3
I²L^-2

⇒ In TE mode of waveguide E_z = 0
TRUE
FALSE

⇒ In a 4 bit weighted resistor D/A converter, resistor value corresponding to LSB is 32 k ohm. The resistor value corresponding to MSB is
32 k ohm
16 k ohm
8 k ohm
4 k ohm

⇒

Assertion (A): When all inputs of a NAND-gate are shorted to get a one input, one output gate, it becomes an inverter.

Reason (R): When all inputs of a NAND-gate are at logic 'O' level, the output is at logic 'I' level.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following statement S₁ and S_{2S₁ is False, S₂ is true
S₁ and S₂ both are true
S₁ and S₂ both are false
S₁ is true, S₂ is false}

⇒ A coil has a resistance of 2 Ω and inductance of 0.1 mH. The applied voltages is suddenly increased from 10 V to 20 V. After steady state condition have reached, the current is
0.0833333333333333
more than 2 A but less than 4 A
0.166666666666667
more than 4 A

⇒ In electronic voltmeters the measuring device is a
moving coil instrument
moving iron instrument
dynamometer instrument
none of the above

⇒ Power monitor and reflectometer use the principle of
directional coupler
klystron amplifier
Gunn diode
TWT

⇒ A divide by 78 counter can be obtained by
6 numbers of mod-13 counters
13 numbers of mod-6 counters
one mod-13 counter followed by mod-6 counter
13 number of mod-13 counters