Question is ⇒ A series RC circuit has R = 5 Ω and C = 10 μF. The current in the circuit is 5 sin 20000t. The applied voltage is, Options are ⇒ (A) 252 sin (20000t + 45°), (B) 252 sin (20000t - 45°), (C) 252 sin 20000t, (D) 252 sin (20000t - 90°), (E) , Leave your comments or Download question paper.

Question is ⇒ A series RC circuit has R = 5 Ω and C = 10 μF. The current in the circuit is 5 sin 20000t. The applied voltage is, Options are ⇒ (A) 252 sin (20000t + 45°), (B) 252 sin (20000t - 45°), (C) 252 sin 20000t, (D) 252 sin (20000t - 90°), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A series RC circuit has R = 5 Ω and C = 10 μF. The current in the circuit is 5 sin 20000t. The applied voltage is
A.	252 sin (20000t + 45°) [Wrong Answer]
B.	252 sin (20000t - 45°) [Correct Answer]
C.	252 sin 20000t [Wrong Answer]
D.	252 sin (20000t - 90°) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The probability density function of the envelope of narrow band noise is :
Uniform
Gaussian
Rayleigh
None

⇒ The response of D'Arsonval galvanometer is over damped if
D² > 4CJ
D² > 2CJ
D² < 4CJ
D² < 2CJ

⇒ Twelve resistance each 2 ohm are connected to form a cube, one resistance being in each arm of cube. The resistance between any two diagonally opposite comers is
1 Ω
2 Ω
4 Ω
8 Ω

⇒ For the transport lag G(jω) = e^-jωT, the polar plot is
a semi circle
a circle
a unit circle
none of the above

⇒ An FM signal is modulated by an 8 kHz sine wave and has maximum and minimum frequencies of 100.05 MHz and 99.95 MHz respectively. Its deviation frequency is
100 kHz
100 MHz
500 kHz
108 kHz

⇒ Audio amplifiers need
Bass control
Treble control
Both Bass and Treble control
Either Bass or Treble control

⇒ In a specimen of silicon steel, a field strength of 200 A/m causes a flux density of 0.5 T. In a specimen of cast iron, the same H would cause B to be
0.5 T
less than 0.5 T
more than 0.5 T
0.5 T or more or less

⇒ In a semiconductor strain gauge, the ohmic electrical contacts are generally made of
copper wire
gold wire
aluminium wire
nickel wire

⇒ When large amount of power is required, a push pull amplifier is designed for operation as
class A
class B
class C
class AB

⇒ Industrial heating furnaces such as arc and induction furnaces operate on __________ power factor
low leading
low lagging
high leading
very low lagging

⇒ Number of fundamental cut-sets of any graph will be
same as the number of twigs
same as the number of tree branches
same as the number of nodes
equal to one

⇒ Which of the following is not a valid variable name in C?
p o, t
p o t
po_t
p_ot

⇒ On modulating a carrier of frequency f_c by an audio signal f_s, the following components has result
Amplitude modulation (DSB)
Single sideband modulation
Frequency modulation only
Amplitude modulation or frequency modulation

⇒ Read cycle is always followed by (during instructions execution)
read cycle
write cycle
delete signal
none of these

⇒

Assertion (A): In register indirect addressing mode of 8085, the address of operand is in the specified register.

Reason (R): An example of register indirect addressing mode is MOV, A, M..

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Semi conducting materials are all
elements
compounds
elements or compounds
elements or mixtures

⇒ The maximum number of alphabets/digits or special symbots for character constants in C is
1
2
4
8

⇒ In a half wave diode rectifier circuit the current flows in the load circuit for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ In which of the following circuits is op-amp used in open loop configuration?
Comparator
Summing amplifier
Integrating amplifier
Logarithmic amplifier

⇒ In the stabilized reactance modulator AFC system
phase modulation is converted into amplitude modulation by the equalizer circuit
the discriminator frequency must not be too low or the system will fail
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency, better the oscillator frequency stability

⇒ Which of the following is not a valid real variable in FORTRAN 77?
ANUT
MONEY
A MONEY
BS

⇒ The duration of sunspot cycle is
1 year
11 years
55 years
100 years

⇒ CMRR of a difference amplifier is equal to
(A_v')/(A_com)
A_v/A_com
A_com/A_v'
(A_v)/(A_com)²

⇒ In a two stage cascade amplifier, each stage has a gain of 10 dB and noise figure of 10 dB. The overall noise factor is
10
1.09
1
10.9

⇒ If φ_sh is flux of shunt magnet, φ_se is flux of series magnet, i_sh is eddy current due to φ_se, the torque in an induction wattmeter is proportional to
φ_se i_se + φ_sh i_sh
φ_sh i_se - φ_se i_sh
φ_sh i_sh - φ_se i_se
φ_sh i_sh + φ_se i_se

⇒ In integral cycle control of ac regulator, the input power factor is equal to
duty cycle a
a²
a
(a)^1/3

⇒ i₁(t) for t > 0 is give
2.5 - 2.5e^-2t
2.5 - 1.25e^-2t
1.25 - 1.25e^-2t
None of these

⇒ Two capacitors of 1 μF and 2 μF capacitance are connected in parallel across a 30 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be
30 μC each
60 μC each
30 μC and 60 μC respectively
60 μC and 30 μC respectively

⇒ For a given line voltage, four heating coils will produce maximum heat when connected
all in parallel
all in series
with two parallel pairs in series
one pair in parallel with the other two in series

⇒ In a radio receiver, the local oscillator is tuned to a frequency
lower than the incoming frequency
higher than the incoming frequency
equal to incoming frequency
any of the above